On Wed, Aug 07, 2019 at 10:36:08AM -0700, Vasily Khoruzhick wrote: > On Wed, Aug 7, 2019 at 4:56 AM Maxime Ripard wrote: > > > > On Tue, Aug 06, 2019 at 07:39:26PM -0700, Vasily Khoruzhick wrote: > > > On Tue, Aug 6, 2019 at 2:14 PM Robin Murphy wrote: > > > > > > > > On 2019-08-06 9:52 pm, Vasily Khoruzhick wrote: > > > > > On Tue, Aug 6, 2019 at 1:19 PM Harald Geyer wrote: > > > > >> > > > > >> Vasily Khoruzhick writes: > > > > >>> On Tue, Aug 6, 2019 at 7:35 AM Robin Murphy wrote: > > > > >>>> > > > > >>>> On 06/08/2019 15:01, Vasily Khoruzhick wrote: > > > > >>>>> Looks like PMU in A64 is broken, it generates no interrupts at all and > > > > >>>>> as result 'perf top' shows no events. > > > > >>>> > > > > >>>> Does something like 'perf stat sleep 1' at least count cycles correctly? > > > > >>>> It could well just be that the interrupt numbers are wrong... > > > > >>> > > > > >>> Looks like it does, at least result looks plausible: > > > > >> > > > > >> I'm using perf stat regularly (cache benchmarks) and it works fine. > > > > >> > > > > >> Unfortunately I wasn't aware that perf stat is a poor test for > > > > >> the interrupts part of the node, when I added it. So I'm not too > > > > >> surprised I got it wrong. > > > > >> > > > > >> However, it would be unfortunate if the node got removed completely, > > > > >> because perf stat would not work anymore. Maybe we can only remove > > > > >> the interrupts or just fix them even if the HW doesn't work? > > > > > > > > > > I'm not familiar with PMU driver. Is it possible to get it working > > > > > without interrupts? > > > > > > > > Yup - you get a grumpy message from the driver, it will refuse sampling > > > > events (the ones which weren't working anyway), and if you measure > > > > anything for long enough that a counter overflows you'll get wonky > > > > results. But for counting hardware events over relatively short periods > > > > it'll still do the job. > > > > > > I tried to drop interrupts completely from the node but 'perf top' is > > > still broken. Though now in different way: it complains "cycles: PMU > > > Hardware doesn't support sampling/overflow-interrupts. Try 'perf > > > stat'" > > > > I have no idea if that's the culprit, but what is the state of the > > 0x09010000 register? > > What register is that and how do I check it? It's in the CPUX Configuration block, and the bits are labelled as CPU Debug Reset. And if you have busybox, you can use devmem. Maxime -- Maxime Ripard, Bootlin Embedded Linux and Kernel engineering https://bootlin.com