linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: Chen-Yu Tsai <wens@kernel.org>
To: Maxime Ripard <mripard@kernel.org>,
	Mauro Carvalho Chehab <mchehab@kernel.org>,
	Sakari Ailus <sakari.ailus@linux.intel.com>,
	Rob Herring <robh+dt@kernel.org>,
	Mark Rutland <mark.rutland@arm.com>
Cc: devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
	Chen-Yu Tsai <wens@csie.org>, Chen-Yu Tsai <wens@kernel.org>,
	linux-arm-kernel@lists.infradead.org,
	linux-media@vger.kernel.org
Subject: [PATCH 11/14] ARM: dts: sun8i: r40: Add device node for CSI0
Date: Mon, 16 Dec 2019 00:59:21 +0800	[thread overview]
Message-ID: <20191215165924.28314-12-wens@kernel.org> (raw)
In-Reply-To: <20191215165924.28314-1-wens@kernel.org>

From: Chen-Yu Tsai <wens@csie.org>

The CSI0 and CSI1 blocks are the same as found on the A20. However only
CSI0 is supported upstream right now.

Add a device node for CSI0 using the A20 compatible as a fallback, and
the standard pinctrl options. Also add the MBUS interconnect.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
 arch/arm/boot/dts/sun8i-r40.dtsi | 36 ++++++++++++++++++++++++++++++++
 1 file changed, 36 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-r40.dtsi b/arch/arm/boot/dts/sun8i-r40.dtsi
index 82ea0b5b0710..2d1e97cc4155 100644
--- a/arch/arm/boot/dts/sun8i-r40.dtsi
+++ b/arch/arm/boot/dts/sun8i-r40.dtsi
@@ -180,6 +180,20 @@ nmi_intc: interrupt-controller@1c00030 {
 			interrupts = <GIC_SPI 0 IRQ_TYPE_LEVEL_HIGH>;
 		};
 
+		csi0: csi@1c09000 {
+			compatible = "allwinner,sun8i-r40-csi0",
+				     "allwinner,sun7i-a20-csi0";
+			reg = <0x01c09000 0x1000>;
+			interrupts = <GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_CSI0>, <&ccu CLK_CSI_SCLK>,
+				 <&ccu CLK_DRAM_CSI0>;
+			clock-names = "bus", "isp", "ram";
+			resets = <&ccu RST_BUS_CSI0>;
+			interconnects = <&mbus 5>;
+			interconnect-names = "dma-mem";
+			status = "disabled";
+		};
+
 		mmc0: mmc@1c0f000 {
 			compatible = "allwinner,sun8i-r40-mmc",
 				     "allwinner,sun50i-a64-mmc";
@@ -355,6 +369,20 @@ clk_out_a_pin: clk-out-a-pin {
 				function = "clk_out_a";
 			};
 
+			/omit-if-no-ref/
+			csi0_8bits_pins: csi0-8bits-pins {
+				pins = "PE0", "PE2", "PE3", "PE4", "PE5",
+				       "PE6", "PE7", "PE8", "PE9", "PE10",
+				       "PE11";
+				function = "csi0";
+			};
+
+			/omit-if-no-ref/
+			csi0_mclk_pin: csi0-mclk-pin {
+				pins = "PE1";
+				function = "csi0";
+			};
+
 			gmac_rgmii_pins: gmac-rgmii-pins {
 				pins = "PA0", "PA1", "PA2", "PA3",
 				       "PA4", "PA5", "PA6", "PA7",
@@ -624,6 +652,14 @@ gmac_mdio: mdio {
 			};
 		};
 
+		mbus: dram-controller@1c62000 {
+			compatible = "allwinner,sun8i-r40-mbus";
+			reg = <0x01c62000 0x1000>;
+			clocks = <&ccu 155>;
+			dma-ranges = <0x00000000 0x40000000 0x80000000>;
+			#interconnect-cells = <1>;
+		};
+
 		tcon_top: tcon-top@1c70000 {
 			compatible = "allwinner,sun8i-r40-tcon-top";
 			reg = <0x01c70000 0x1000>;
-- 
2.24.0


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply	other threads:[~2019-12-15 17:02 UTC|newest]

Thread overview: 34+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-12-15 16:59 [PATCH 00/14] media: sun4i-csi: A10/A20 CSI1 and R40 CSI0 support Chen-Yu Tsai
2019-12-15 16:59 ` [PATCH 01/14] dt-bindings: media: sun4i-csi: Add compatible for CSI1 on A10/A20 Chen-Yu Tsai
2019-12-16 10:30   ` Maxime Ripard
2019-12-19 23:56   ` Rob Herring
2019-12-15 16:59 ` [PATCH 02/14] dt-bindings: media: sun4i-csi: Add compatible for CSI0 on R40 Chen-Yu Tsai
2019-12-16 10:30   ` Maxime Ripard
2019-12-19 23:57   ` Rob Herring
2019-12-15 16:59 ` [PATCH 03/14] media: sun4i-csi: Fix data sampling polarity handling Chen-Yu Tsai
2019-12-16 13:36   ` Maxime Ripard
2019-12-15 16:59 ` [PATCH 04/14] media: sun4i-csi: Fix [HV]sync " Chen-Yu Tsai
2019-12-16 13:37   ` Maxime Ripard
2023-01-16 10:03   ` Oleg Verych
2023-01-16 10:16     ` Maxime Ripard
2023-01-16 18:43       ` Oleg Verych
2019-12-15 16:59 ` [PATCH 05/14] media: sun4i-csi: Deal with DRAM offset Chen-Yu Tsai
2019-12-16 13:38   ` Maxime Ripard
2019-12-15 16:59 ` [PATCH 06/14] media: sun4i-csi: Add support for A10 CSI1 camera sensor interface Chen-Yu Tsai
2019-12-16 13:38   ` Maxime Ripard
2020-01-02 11:33   ` Sakari Ailus
2020-01-02 11:36     ` Chen-Yu Tsai
2019-12-15 16:59 ` [PATCH 07/14] ARM: dts: sun4i: Add CSI1 controller and pinmux options Chen-Yu Tsai
2019-12-15 16:59 ` [PATCH 08/14] ARM: dts: sun7i: " Chen-Yu Tsai
2019-12-15 16:59 ` [PATCH 09/14] ARM: dts: sun8i: r40: Add I2C " Chen-Yu Tsai
2019-12-16 10:29   ` Maxime Ripard
2019-12-15 16:59 ` [PATCH 10/14] dt-bindings: bus: sunxi: Add R40 MBUS compatible Chen-Yu Tsai
2019-12-19 23:58   ` Rob Herring
2019-12-15 16:59 ` Chen-Yu Tsai [this message]
2019-12-16 13:39   ` [PATCH 11/14] ARM: dts: sun8i: r40: Add device node for CSI0 Maxime Ripard
2019-12-16 13:42     ` Chen-Yu Tsai
2019-12-16 13:53       ` Maxime Ripard
2019-12-15 16:59 ` [PATCH 12/14] [DO NOT MERGE] ARM: dts: sun4i: cubieboard: Enable OV7670 camera on CSI1 Chen-Yu Tsai
2019-12-15 16:59 ` [PATCH 13/14] [DO NOT MERGE] ARM: dts: sun7i: cubieboard2: " Chen-Yu Tsai
2019-12-15 16:59 ` [PATCH 14/14] [DO NOT MERGE] ARM: dts: sun8i-r40: bananapi-m2-ultra: Enable OV5640 camera Chen-Yu Tsai
2020-01-01 10:20 ` [PATCH 00/14] media: sun4i-csi: A10/A20 CSI1 and R40 CSI0 support Chen-Yu Tsai

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20191215165924.28314-12-wens@kernel.org \
    --to=wens@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-media@vger.kernel.org \
    --cc=mark.rutland@arm.com \
    --cc=mchehab@kernel.org \
    --cc=mripard@kernel.org \
    --cc=robh+dt@kernel.org \
    --cc=sakari.ailus@linux.intel.com \
    --cc=wens@csie.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).