Linux-ARM-Kernel Archive on lore.kernel.org
 help / color / Atom feed
From: Sasha Levin <sashal@kernel.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Sasha Levin <sashal@kernel.org>,
	devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
	Vladimir Zapolskiy <vz@mleia.com>
Subject: [PATCH AUTOSEL 4.9 054/251] ARM: dts: lpc32xx: phy3250: fix SD card regulator voltage
Date: Thu, 16 Jan 2020 12:33:23 -0500
Message-ID: <20200116173641.22137-14-sashal@kernel.org> (raw)
In-Reply-To: <20200116173641.22137-1-sashal@kernel.org>

From: Vladimir Zapolskiy <vz@mleia.com>

[ Upstream commit dc141b99fc36cf910a1d8d5ee30f43f2442fd1bd ]

The fixed voltage regulator on Phytec phyCORE-LPC3250 board, which
supplies SD/MMC card's power, has a constant output voltage level
of either 3.15V or 3.3V, the actual value depends on JP4 position,
the power rail is referenced as VCC_SDIO in the board hardware manual.

Fixes: d06670e96267 ("arm: dts: phy3250: add SD fixed regulator")
Signed-off-by: Vladimir Zapolskiy <vz@mleia.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 arch/arm/boot/dts/lpc3250-phy3250.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/lpc3250-phy3250.dts b/arch/arm/boot/dts/lpc3250-phy3250.dts
index b7bd3a110a8d..dd0bdf765599 100644
--- a/arch/arm/boot/dts/lpc3250-phy3250.dts
+++ b/arch/arm/boot/dts/lpc3250-phy3250.dts
@@ -49,8 +49,8 @@
 		sd_reg: regulator@2 {
 			compatible = "regulator-fixed";
 			regulator-name = "sd_reg";
-			regulator-min-microvolt = <1800000>;
-			regulator-max-microvolt = <1800000>;
+			regulator-min-microvolt = <3300000>;
+			regulator-max-microvolt = <3300000>;
 			gpio = <&gpio 5 5 0>;
 			enable-active-high;
 		};
-- 
2.20.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply index

Thread overview: 34+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-01-16 17:33 [PATCH AUTOSEL 4.9 041/251] media: s5p-jpeg: Correct step and max values for V4L2_CID_JPEG_RESTART_INTERVAL Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 043/251] ASoC: imx-sgtl5000: put of nodes if finding codec fails Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 046/251] clk: sunxi-ng: sun8i-a23: Enable PLL-MIPI LDOs when ungating it Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 050/251] ARM: dts: lpc32xx: add required clocks property to keypad device node Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 051/251] ARM: dts: lpc32xx: reparent keypad controller to SIC1 Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 052/251] ARM: dts: lpc32xx: fix ARM PrimeCell LCD controller variant Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 053/251] ARM: dts: lpc32xx: fix ARM PrimeCell LCD controller clocks property Sasha Levin
2020-01-16 17:33 ` Sasha Levin [this message]
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 058/251] thermal: mediatek: fix register index error Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 085/251] clocksource/drivers/sun5i: Fail gracefully when clock rate is unavailable Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 086/251] clocksource/drivers/exynos_mct: Fix error path in timer resources initialization Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 087/251] mmc: sdhci-brcmstb: handle mmc_of_parse() errors during probe Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 088/251] ARM: 8847/1: pm: fix HYP/SVC mode mismatch when MCPM is used Sasha Levin
2020-01-16 17:33 ` [PATCH AUTOSEL 4.9 089/251] ARM: 8848/1: virt: Align GIC version check with arm64 counterpart Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 104/251] ARM: OMAP2+: Fix potentially uninitialized return value for _setup_reset() Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 110/251] soc/fsl/qe: Fix an error code in qe_pin_request() Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 111/251] spi: bcm2835aux: fix driver to not allow 65535 (=-1) cs-gpios Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 114/251] ARM: pxa: ssp: Fix "WARNING: invalid free of devm_ allocated data" Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 118/251] ARM: dts: ls1021: Fix SGMII PCS link remaining down after PHY disconnect Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 138/251] pwm: meson: Don't disable PWM when setting duty repeatedly Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 139/251] ARM: riscpc: fix lack of keyboard interrupts after irq conversion Sasha Levin
2020-01-16 17:34 ` [PATCH AUTOSEL 4.9 146/251] serial: stm32: fix transmit_chars when tx is stopped Sasha Levin
2020-01-16 17:35 ` [PATCH AUTOSEL 4.9 184/251] ASoC: sun4i-i2s: RX and TX counter registers are swapped Sasha Levin
2020-01-16 17:35 ` [PATCH AUTOSEL 4.9 205/251] net: stmmac: dwmac-meson8b: Fix signedness bug in probe Sasha Levin
2020-01-16 17:35 ` [PATCH AUTOSEL 4.9 207/251] net: ethernet: stmmac: Fix signedness bug in ipq806x_gmac_of_parse() Sasha Levin
2020-01-16 17:35 ` [PATCH AUTOSEL 4.9 210/251] net: stmmac: gmac4+: Not all Unicast addresses may be available Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 214/251] net: stmmac: fix length of PTP clock's name string Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 218/251] dmaengine: imx-sdma: fix size check for sdma script_number Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 224/251] mt7601u: fix bbp version check in mt7601u_wait_bbp_ready Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 229/251] spi: atmel: fix handling of cs_change set on non-last xfer Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 232/251] clk: samsung: exynos5420: Preserve CPU clocks configuration during suspend/resume Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 235/251] media: exynos4-is: Fix recursive locking in isp_video_release() Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 240/251] tty: serial: imx: use the sg count from dma_map_sg Sasha Levin
2020-01-16 17:36 ` [PATCH AUTOSEL 4.9 249/251] arm64: dts: juno: Fix UART frequency Sasha Levin

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200116173641.22137-14-sashal@kernel.org \
    --to=sashal@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=stable@vger.kernel.org \
    --cc=vz@mleia.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ARM-Kernel Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/0 linux-arm-kernel/git/0.git
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/1 linux-arm-kernel/git/1.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-arm-kernel linux-arm-kernel/ https://lore.kernel.org/linux-arm-kernel \
		linux-arm-kernel@lists.infradead.org
	public-inbox-index linux-arm-kernel

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.infradead.lists.linux-arm-kernel


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git