Hello Alex, On Mon, Nov 09, 2020 at 12:02:18PM +0100, Alexandre Torgue wrote: > Hi Alex > > On 10/31/20 2:54 PM, Alexander Dahl wrote: > > Hei hei, > > > > On Tue, Oct 27, 2020 at 11:58:10AM +0100, Ahmad Fatoum wrote: > > > Hello, > > > > > > On 10/27/20 11:05 AM, Alexander Dahl wrote: > > > > Hello Ahmad, > > > > > > > > thanks for your feedback, comments below. > > > > > > > > > > > > > - led-rgb { > > > > > > + led-controller-2 { > > > > > > > > > > Is a single RGB LED really a controller? > > > > > > > > I just followed the recommendations by Rob here. > > > > > > Do you happen to know if the new multicolor LED support could be used here? > > > > > > I find it unfortunate that the device tree loses information relevant to humans > > > to adhere to a fixed nomenclature. Apparently led-controller isn't even codified > > > in the YAML binding (It's just in the examples). If you respin, please add a > > > comment that this is a single RGB led. I'd prefer to keep the information > > > in the DTB as well though. > > > > Slightly off-topic, but while I was working on the patch based on your > > feedback I tried to find some information on that Linux Automation > > MC-1 board. However I could not find any? Is there some website, some > > datasheet or maybe a schematic online? The vendor prefix says "Linux > > Automation GmbH", but I find only that USB-SD-Mux on their page? > > > > Greets > > Alex > > I saw that Ahmad Acked this patch but regarding your discussion it seems > there are opening questions. Are you going to send an update of it or can I > take it ? I'll send an update, I already reworked this patch. I'm still waiting for an Ack for the first patch of the series before sending the next iteration, though. :-/ Greets Alex > > regards > alex > > > > > > > > > > > > > > > > > > > > > > > > compatible = "pwm-leds"; > > > > > > - led-red { > > > > > > + led-2 { > > > > > > > > > > Shouldn't this have been led-1 as well or is the numbering "global" ? > > > > > > > > Also good question. This numbering is for dts only, it usually does > > > > not correspond with LEDs on the board, so it could be numbered per > > > > led-controller as well? > > > > > > I'd prefer that it starts by 1. That way it's aligned with PWM channel > > > ID. > > > > > > Thanks for fixing the dtschema warnings by the way! > > > > > > Cheers, > > > Ahmad > > > > > > > > > > > Greets > > > > Alex > > > > > > > > > > > > > > > label = "mc1:red:rgb"; > > > > > > pwms = <&leds_pwm 1 1000000 0>; > > > > > > max-brightness = <255>; > > > > > > active-low; > > > > > > }; > > > > > > - led-green { > > > > > > + led-3 { > > > > > > label = "mc1:green:rgb"; > > > > > > pwms = <&leds_pwm 2 1000000 0>; > > > > > > max-brightness = <255>; > > > > > > active-low; > > > > > > }; > > > > > > - led-blue { > > > > > > + led-4 { > > > > > > label = "mc1:blue:rgb"; > > > > > > pwms = <&leds_pwm 3 1000000 0>; > > > > > > max-brightness = <255>; > > > > > > > > > > > > > > > > -- > > > > > Pengutronix e.K. | | > > > > > Steuerwalder Str. 21 | http://www.pengutronix.de/ | > > > > > 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | > > > > > Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | > > > > > > > > > > -- > > > Pengutronix e.K. | | > > > Steuerwalder Str. 21 | http://www.pengutronix.de/ | > > > 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | > > > Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | > > > > > > _______________________________________________ > > Linux-stm32 mailing list > > Linux-stm32@st-md-mailman.stormreply.com > > https://st-md-mailman.stormreply.com/mailman/listinfo/linux-stm32 > > > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel -- /"\ ASCII RIBBON | »With the first link, the chain is forged. The first \ / CAMPAIGN | speech censured, the first thought forbidden, the X AGAINST | first freedom denied, chains us all irrevocably.« / \ HTML MAIL | (Jean-Luc Picard, quoting Judge Aaron Satie)