linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: Krzysztof Kozlowski <krzk@kernel.org>
To: Chanwoo Choi <cw00.choi@samsung.com>,
	Krzysztof Kozlowski <krzk@kernel.org>,
	Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>,
	Michael Turquette <mturquette@baylibre.com>,
	Stephen Boyd <sboyd@kernel.org>, Rob Herring <robh+dt@kernel.org>,
	Lee Jones <lee.jones@linaro.org>,
	Sebastian Reichel <sre@kernel.org>,
	Liam Girdwood <lgirdwood@gmail.com>,
	Mark Brown <broonie@kernel.org>, Andy Gross <agross@kernel.org>,
	Bjorn Andersson <bjorn.andersson@linaro.org>,
	Alessandro Zummo <a.zummo@towertech.it>,
	Alexandre Belloni <alexandre.belloni@bootlin.com>,
	linux-kernel@vger.kernel.org, linux-clk@vger.kernel.org,
	devicetree@vger.kernel.org, linux-pm@vger.kernel.org,
	linux-arm-kernel@lists.infradead.org,
	linux-samsung-soc@vger.kernel.org, linux-arm-msm@vger.kernel.org,
	linux-rtc@vger.kernel.org
Cc: Angus Ainslie <angus@akkea.ca>,
	Hans de Goede <hdegoede@redhat.com>,
	Sebastian Krzyszkowiak <sebastian.krzyszkowiak@puri.sm>,
	Iskren Chernev <iskren.chernev@gmail.com>,
	Matheus Castello <matheus@castello.eng.br>
Subject: [RFC 17/18] mfd: max14577: Do not enforce (incorrect) interrupt trigger type
Date: Thu, 10 Dec 2020 22:25:33 +0100	[thread overview]
Message-ID: <20201210212534.216197-17-krzk@kernel.org> (raw)
In-Reply-To: <20201210212534.216197-1-krzk@kernel.org>

Interrupt line can be configured on different hardware in different way,
even inverted.  Therefore driver should not enforce specific trigger
type - edge falling - but instead rely on Devicetree to configure it.

The Maxim 14577/77836 datasheets describe the interrupt line as active
low with a requirement of acknowledge from the CPU therefore the edge
falling is not correct.

The interrupt line is shared between PMIC and charger driver, so using
level sensitive interrupt is here especially important to avoid races.
With an edge configuration in case if first PMIC signals interrupt
followed shortly after by the RTC, the interrupt might not be yet
cleared/acked thus the second one would not be noticed.

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>

---

This patch should wait till DTS changes are merged, as it relies on
proper Devicetree.
---
 Documentation/devicetree/bindings/mfd/max14577.txt | 4 ++--
 drivers/mfd/max14577.c                             | 6 +++---
 2 files changed, 5 insertions(+), 5 deletions(-)

diff --git a/Documentation/devicetree/bindings/mfd/max14577.txt b/Documentation/devicetree/bindings/mfd/max14577.txt
index 92070b346756..be11943a0560 100644
--- a/Documentation/devicetree/bindings/mfd/max14577.txt
+++ b/Documentation/devicetree/bindings/mfd/max14577.txt
@@ -71,7 +71,7 @@ max14577@25 {
 	compatible = "maxim,max14577";
 	reg = <0x25>;
 	interrupt-parent = <&gpx1>;
-	interrupts = <5 IRQ_TYPE_NONE>;
+	interrupts = <5 IRQ_TYPE_LEVEL_LOW>;
 
 	muic: max14577-muic {
 		compatible = "maxim,max14577-muic";
@@ -106,7 +106,7 @@ max77836@25 {
 	compatible = "maxim,max77836";
 	reg = <0x25>;
 	interrupt-parent = <&gpx1>;
-	interrupts = <5 IRQ_TYPE_NONE>;
+	interrupts = <5 IRQ_TYPE_LEVEL_LOW>;
 
 	muic: max77836-muic {
 		compatible = "maxim,max77836-muic";
diff --git a/drivers/mfd/max14577.c b/drivers/mfd/max14577.c
index be185e9d5f16..6c487fa14e9c 100644
--- a/drivers/mfd/max14577.c
+++ b/drivers/mfd/max14577.c
@@ -332,7 +332,7 @@ static int max77836_init(struct max14577 *max14577)
 	}
 
 	ret = regmap_add_irq_chip(max14577->regmap_pmic, max14577->irq,
-			IRQF_TRIGGER_FALLING | IRQF_ONESHOT | IRQF_SHARED,
+			IRQF_ONESHOT | IRQF_SHARED,
 			0, &max77836_pmic_irq_chip,
 			&max14577->irq_data_pmic);
 	if (ret != 0) {
@@ -418,14 +418,14 @@ static int max14577_i2c_probe(struct i2c_client *i2c,
 		irq_chip = &max77836_muic_irq_chip;
 		mfd_devs = max77836_devs;
 		mfd_devs_size = ARRAY_SIZE(max77836_devs);
-		irq_flags = IRQF_TRIGGER_FALLING | IRQF_ONESHOT | IRQF_SHARED;
+		irq_flags = IRQF_ONESHOT | IRQF_SHARED;
 		break;
 	case MAXIM_DEVICE_TYPE_MAX14577:
 	default:
 		irq_chip = &max14577_irq_chip;
 		mfd_devs = max14577_devs;
 		mfd_devs_size = ARRAY_SIZE(max14577_devs);
-		irq_flags = IRQF_TRIGGER_FALLING | IRQF_ONESHOT;
+		irq_flags = IRQF_ONESHOT;
 		break;
 	}
 
-- 
2.25.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply	other threads:[~2020-12-10 21:30 UTC|newest]

Thread overview: 28+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-12-10 21:25 [PATCH 01/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on GT-I9100 Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 02/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on P4 Note family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 03/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on Midas family Krzysztof Kozlowski
2020-12-29 15:43   ` Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 04/18] ARM: dts: exynos: correct MUIC " Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 05/18] ARM: dts: exynos: correct PMIC " Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 06/18] ARM: dts: exynos: correct PMIC interrupt trigger level on Odroid X/U3 family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 07/18] ARM: dts: exynos: correct PMIC interrupt trigger level on P4 Note family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 08/18] ARM: dts: exynos: correct PMIC interrupt trigger level on SMDK5250 Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 09/18] ARM: dts: exynos: correct PMIC interrupt trigger level on Snow Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 10/18] ARM: dts: s5pv210: correct fuel gauge interrupt trigger level on Fascinate family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 11/18] ARM: dts: qcom: msm8974-lge-nexus5: correct fuel gauge interrupt trigger level Krzysztof Kozlowski
2020-12-11 15:29   ` Iskren Chernev
2020-12-10 21:25 ` [PATCH 12/18] ARM: dts: qcom: msm8974-samsung-klte: " Krzysztof Kozlowski
2020-12-11 15:25   ` Iskren Chernev
2020-12-10 21:25 ` [RFC 13/18] mfd: max77686: Do not enforce (incorrect) interrupt trigger type Krzysztof Kozlowski
2020-12-21 18:45   ` Rob Herring
2020-12-10 21:25 ` [RFC 14/18] rtc: " Krzysztof Kozlowski
2020-12-10 21:25 ` [RFC 15/18] mfd: max77693: " Krzysztof Kozlowski
2020-12-21 18:46   ` Rob Herring
2020-12-10 21:25 ` [RFC 16/18] power: supply: max17042: " Krzysztof Kozlowski
2020-12-10 21:25 ` Krzysztof Kozlowski [this message]
2020-12-21 18:47   ` [RFC 17/18] mfd: max14577: " Rob Herring
2020-12-10 21:25 ` [RFC 18/18] power: supply: max17040: " Krzysztof Kozlowski
2020-12-11  7:47   ` Krzysztof Kozlowski
2020-12-11 15:44     ` Iskren Chernev
2020-12-11 15:51       ` Krzysztof Kozlowski
2021-03-03 18:19 ` [PATCH 01/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on GT-I9100 Krzysztof Kozlowski

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20201210212534.216197-17-krzk@kernel.org \
    --to=krzk@kernel.org \
    --cc=a.zummo@towertech.it \
    --cc=agross@kernel.org \
    --cc=alexandre.belloni@bootlin.com \
    --cc=angus@akkea.ca \
    --cc=b.zolnierkie@samsung.com \
    --cc=bjorn.andersson@linaro.org \
    --cc=broonie@kernel.org \
    --cc=cw00.choi@samsung.com \
    --cc=devicetree@vger.kernel.org \
    --cc=hdegoede@redhat.com \
    --cc=iskren.chernev@gmail.com \
    --cc=lee.jones@linaro.org \
    --cc=lgirdwood@gmail.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pm@vger.kernel.org \
    --cc=linux-rtc@vger.kernel.org \
    --cc=linux-samsung-soc@vger.kernel.org \
    --cc=matheus@castello.eng.br \
    --cc=mturquette@baylibre.com \
    --cc=robh+dt@kernel.org \
    --cc=sboyd@kernel.org \
    --cc=sebastian.krzyszkowiak@puri.sm \
    --cc=sre@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).