linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: Catalin Marinas <catalin.marinas@arm.com>
To: Anshuman Khandual <anshuman.khandual@arm.com>
Cc: linux-arm-kernel@lists.infradead.org,
	linux-kernel@vger.kernel.org, linux-mm@kvack.org,
	"Will Deacon" <will@kernel.org>,
	"Ard Biesheuvel" <ardb@kernel.org>,
	"Mark Rutland" <mark.rutland@arm.com>,
	"James Morse" <james.morse@arm.com>,
	"Robin Murphy" <robin.murphy@arm.com>,
	"Jérôme Glisse" <jglisse@redhat.com>,
	"Dan Williams" <dan.j.williams@intel.com>,
	"David Hildenbrand" <david@redhat.com>,
	"Mike Rapoport" <rppt@linux.ibm.com>,
	"Veronika Kabatova" <vkabatov@redhat.com>
Subject: Re: [PATCH V3 1/2] arm64/mm: Fix pfn_valid() for ZONE_DEVICE based memory
Date: Mon, 8 Mar 2021 17:59:30 +0000	[thread overview]
Message-ID: <20210308175928.GG15644@arm.com> (raw)
In-Reply-To: <1614921898-4099-2-git-send-email-anshuman.khandual@arm.com>

On Fri, Mar 05, 2021 at 10:54:57AM +0530, Anshuman Khandual wrote:
> pfn_valid() validates a pfn but basically it checks for a valid struct page
> backing for that pfn. It should always return positive for memory ranges
> backed with struct page mapping. But currently pfn_valid() fails for all
> ZONE_DEVICE based memory types even though they have struct page mapping.
> 
> pfn_valid() asserts that there is a memblock entry for a given pfn without
> MEMBLOCK_NOMAP flag being set. The problem with ZONE_DEVICE based memory is
> that they do not have memblock entries. Hence memblock_is_map_memory() will
> invariably fail via memblock_search() for a ZONE_DEVICE based address. This
> eventually fails pfn_valid() which is wrong. memblock_is_map_memory() needs
> to be skipped for such memory ranges. As ZONE_DEVICE memory gets hotplugged
> into the system via memremap_pages() called from a driver, their respective
> memory sections will not have SECTION_IS_EARLY set.
> 
> Normal hotplug memory will never have MEMBLOCK_NOMAP set in their memblock
> regions. Because the flag MEMBLOCK_NOMAP was specifically designed and set
> for firmware reserved memory regions. memblock_is_map_memory() can just be
> skipped as its always going to be positive and that will be an optimization
> for the normal hotplug memory. Like ZONE_DEVICE based memory, all normal
> hotplugged memory too will not have SECTION_IS_EARLY set for their sections
> 
> Skipping memblock_is_map_memory() for all non early memory sections would
> fix pfn_valid() problem for ZONE_DEVICE based memory and also improve its
> performance for normal hotplug memory as well.
> 
> Cc: Catalin Marinas <catalin.marinas@arm.com>
> Cc: Will Deacon <will@kernel.org>
> Cc: Ard Biesheuvel <ardb@kernel.org>
> Cc: Robin Murphy <robin.murphy@arm.com>
> Cc: linux-arm-kernel@lists.infradead.org
> Cc: linux-kernel@vger.kernel.org
> Acked-by: David Hildenbrand <david@redhat.com>
> Fixes: 73b20c84d42d ("arm64: mm: implement pte_devmap support")
> Signed-off-by: Anshuman Khandual <anshuman.khandual@arm.com>
> ---
>  arch/arm64/mm/init.c | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/arch/arm64/mm/init.c b/arch/arm64/mm/init.c
> index 0ace5e68efba..5920c527845a 100644
> --- a/arch/arm64/mm/init.c
> +++ b/arch/arm64/mm/init.c
> @@ -230,6 +230,18 @@ int pfn_valid(unsigned long pfn)
>  
>  	if (!valid_section(__pfn_to_section(pfn)))
>  		return 0;
> +
> +	/*
> +	 * ZONE_DEVICE memory does not have the memblock entries.
> +	 * memblock_is_map_memory() check for ZONE_DEVICE based
> +	 * addresses will always fail. Even the normal hotplugged
> +	 * memory will never have MEMBLOCK_NOMAP flag set in their
> +	 * memblock entries. Skip memblock search for all non early
> +	 * memory sections covering all of hotplug memory including
> +	 * both normal and ZONE_DEVICE based.
> +	 */
> +	if (!early_section(__pfn_to_section(pfn)))
> +		return pfn_section_valid(__pfn_to_section(pfn), pfn);
>  #endif
>  	return memblock_is_map_memory(addr);
>  }

Acked-by: Catalin Marinas <catalin.marinas@arm.com>

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply	other threads:[~2021-03-08 18:01 UTC|newest]

Thread overview: 13+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-03-05  5:24 [PATCH V3 0/2] arm64/mm: Fix pfn_valid() for ZONE_DEVICE based memory Anshuman Khandual
2021-03-05  5:24 ` [PATCH V3 1/2] " Anshuman Khandual
2021-03-05 18:13   ` Catalin Marinas
2021-03-05 18:24     ` David Hildenbrand
2021-03-08 11:29       ` Catalin Marinas
2021-03-08 17:59   ` Catalin Marinas [this message]
2021-03-05  5:24 ` [PATCH V3 2/2] arm64/mm: Reorganize pfn_valid() Anshuman Khandual
2021-03-08 18:00   ` Catalin Marinas
2021-03-05  5:38 ` [PATCH V3 0/2] arm64/mm: Fix pfn_valid() for ZONE_DEVICE based memory Anshuman Khandual
2021-03-05 12:28   ` Veronika Kabatova
2021-03-05 18:16     ` Veronika Kabatova
2021-03-05 18:22       ` Catalin Marinas
2021-03-08 19:16 ` Will Deacon

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20210308175928.GG15644@arm.com \
    --to=catalin.marinas@arm.com \
    --cc=anshuman.khandual@arm.com \
    --cc=ardb@kernel.org \
    --cc=dan.j.williams@intel.com \
    --cc=david@redhat.com \
    --cc=james.morse@arm.com \
    --cc=jglisse@redhat.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mm@kvack.org \
    --cc=mark.rutland@arm.com \
    --cc=robin.murphy@arm.com \
    --cc=rppt@linux.ibm.com \
    --cc=vkabatov@redhat.com \
    --cc=will@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).