From: Vincenzo Frascino <vincenzo.frascino@arm.com>
To: linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org, kasan-dev@googlegroups.com
Cc: Vincenzo Frascino <vincenzo.frascino@arm.com>,
Andrew Morton <akpm@linux-foundation.org>,
Catalin Marinas <catalin.marinas@arm.com>,
Will Deacon <will@kernel.org>, Dmitry Vyukov <dvyukov@google.com>,
Andrey Ryabinin <aryabinin@virtuozzo.com>,
Alexander Potapenko <glider@google.com>,
Marco Elver <elver@google.com>,
Evgenii Stepanov <eugenis@google.com>,
Branislav Rankov <Branislav.Rankov@arm.com>,
Andrey Konovalov <andreyknvl@google.com>,
Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Subject: [PATCH v16 7/9] arm64: mte: Enable async tag check fault
Date: Mon, 15 Mar 2021 13:20:17 +0000 [thread overview]
Message-ID: <20210315132019.33202-8-vincenzo.frascino@arm.com> (raw)
In-Reply-To: <20210315132019.33202-1-vincenzo.frascino@arm.com>
MTE provides a mode that asynchronously updates the TFSR_EL1 register
when a tag check exception is detected.
To take advantage of this mode the kernel has to verify the status of
the register at:
1. Context switching
2. Return to user/EL0 (Not required in entry from EL0 since the kernel
did not run)
3. Kernel entry from EL1
4. Kernel exit to EL1
If the register is non-zero a trace is reported.
Add the required features for EL1 detection and reporting.
Note: ITFSB bit is set in the SCTLR_EL1 register hence it guaranties that
the indirect writes to TFSR_EL1 are synchronized at exception entry to
EL1. On the context switch path the synchronization is guarantied by the
dsb() in __switch_to().
The dsb(nsh) in mte_check_tfsr_exit() is provisional pending
confirmation by the architects.
Cc: Catalin Marinas <catalin.marinas@arm.com>
Cc: Will Deacon <will@kernel.org>
Reviewed-by: Catalin Marinas <catalin.marinas@arm.com>
Acked-by: Andrey Konovalov <andreyknvl@google.com>
Tested-by: Andrey Konovalov <andreyknvl@google.com>
Signed-off-by: Vincenzo Frascino <vincenzo.frascino@arm.com>
---
arch/arm64/include/asm/mte.h | 29 +++++++++++++++++++++++++
arch/arm64/kernel/entry-common.c | 6 ++++++
arch/arm64/kernel/mte.c | 36 ++++++++++++++++++++++++++++++++
3 files changed, 71 insertions(+)
diff --git a/arch/arm64/include/asm/mte.h b/arch/arm64/include/asm/mte.h
index 8603c6636a7d..9a929620ca5d 100644
--- a/arch/arm64/include/asm/mte.h
+++ b/arch/arm64/include/asm/mte.h
@@ -98,11 +98,40 @@ static inline bool system_uses_mte_async_mode(void)
{
return static_branch_unlikely(&mte_async_mode);
}
+
+void mte_check_tfsr_el1(void);
+
+static inline void mte_check_tfsr_entry(void)
+{
+ mte_check_tfsr_el1();
+}
+
+static inline void mte_check_tfsr_exit(void)
+{
+ /*
+ * The asynchronous faults are sync'ed automatically with
+ * TFSR_EL1 on kernel entry but for exit an explicit dsb()
+ * is required.
+ */
+ dsb(nsh);
+ isb();
+
+ mte_check_tfsr_el1();
+}
#else
static inline bool system_uses_mte_async_mode(void)
{
return false;
}
+static inline void mte_check_tfsr_el1(void)
+{
+}
+static inline void mte_check_tfsr_entry(void)
+{
+}
+static inline void mte_check_tfsr_exit(void)
+{
+}
#endif /* CONFIG_KASAN_HW_TAGS */
#endif /* __ASSEMBLY__ */
diff --git a/arch/arm64/kernel/entry-common.c b/arch/arm64/kernel/entry-common.c
index 9d3588450473..a1ec351c36bd 100644
--- a/arch/arm64/kernel/entry-common.c
+++ b/arch/arm64/kernel/entry-common.c
@@ -37,6 +37,8 @@ static void noinstr enter_from_kernel_mode(struct pt_regs *regs)
lockdep_hardirqs_off(CALLER_ADDR0);
rcu_irq_enter_check_tick();
trace_hardirqs_off_finish();
+
+ mte_check_tfsr_entry();
}
/*
@@ -47,6 +49,8 @@ static void noinstr exit_to_kernel_mode(struct pt_regs *regs)
{
lockdep_assert_irqs_disabled();
+ mte_check_tfsr_exit();
+
if (interrupts_enabled(regs)) {
if (regs->exit_rcu) {
trace_hardirqs_on_prepare();
@@ -293,6 +297,8 @@ asmlinkage void noinstr enter_from_user_mode(void)
asmlinkage void noinstr exit_to_user_mode(void)
{
+ mte_check_tfsr_exit();
+
trace_hardirqs_on_prepare();
lockdep_hardirqs_on_prepare(CALLER_ADDR0);
user_enter_irqoff();
diff --git a/arch/arm64/kernel/mte.c b/arch/arm64/kernel/mte.c
index 50f0724c8d8f..b6336fbe4c14 100644
--- a/arch/arm64/kernel/mte.c
+++ b/arch/arm64/kernel/mte.c
@@ -162,6 +162,29 @@ bool mte_report_once(void)
return READ_ONCE(report_fault_once);
}
+#ifdef CONFIG_KASAN_HW_TAGS
+void mte_check_tfsr_el1(void)
+{
+ u64 tfsr_el1;
+
+ if (!system_supports_mte())
+ return;
+
+ tfsr_el1 = read_sysreg_s(SYS_TFSR_EL1);
+
+ if (unlikely(tfsr_el1 & SYS_TFSR_EL1_TF1)) {
+ /*
+ * Note: isb() is not required after this direct write
+ * because there is no indirect read subsequent to it
+ * (per ARM DDI 0487F.c table D13-1).
+ */
+ write_sysreg_s(0, SYS_TFSR_EL1);
+
+ kasan_report_async();
+ }
+}
+#endif
+
static void update_sctlr_el1_tcf0(u64 tcf0)
{
/* ISB required for the kernel uaccess routines */
@@ -227,6 +250,19 @@ void mte_thread_switch(struct task_struct *next)
/* avoid expensive SCTLR_EL1 accesses if no change */
if (current->thread.sctlr_tcf0 != next->thread.sctlr_tcf0)
update_sctlr_el1_tcf0(next->thread.sctlr_tcf0);
+ else
+ isb();
+
+ /*
+ * Check if an async tag exception occurred at EL1.
+ *
+ * Note: On the context switch path we rely on the dsb() present
+ * in __switch_to() to guarantee that the indirect writes to TFSR_EL1
+ * are synchronized before this point.
+ * isb() above is required for the same reason.
+ *
+ */
+ mte_check_tfsr_el1();
}
void mte_suspend_exit(void)
--
2.30.2
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2021-03-15 13:26 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-03-15 13:20 [PATCH v16 0/9] arm64: ARMv8.5-A: MTE: Add async mode support Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 1/9] arm64: mte: Add asynchronous " Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 2/9] kasan: Add KASAN mode kernel parameter Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 3/9] arm64: mte: Drop arch_enable_tagging() Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 4/9] kasan: Add report for async mode Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 5/9] arm64: mte: Enable TCO in functions that can read beyond buffer limits Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 6/9] arm64: mte: Conditionally compile mte_enable_kernel_*() Vincenzo Frascino
2021-03-15 18:41 ` Catalin Marinas
2021-03-16 10:06 ` Vincenzo Frascino
2021-03-15 13:20 ` Vincenzo Frascino [this message]
2021-03-15 13:20 ` [PATCH v16 8/9] arm64: mte: Report async tag faults before suspend Vincenzo Frascino
2021-03-15 13:20 ` [PATCH v16 9/9] kasan, arm64: tests supports for HW_TAGS async mode Vincenzo Frascino
2021-03-18 18:56 ` [PATCH v16 0/9] arm64: ARMv8.5-A: MTE: Add async mode support Catalin Marinas
2021-03-18 19:03 ` Andrey Konovalov
2021-03-23 15:08 ` Andrey Konovalov
2021-04-11 13:02 ` Catalin Marinas
2021-04-13 9:47 ` Catalin Marinas
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20210315132019.33202-8-vincenzo.frascino@arm.com \
--to=vincenzo.frascino@arm.com \
--cc=Branislav.Rankov@arm.com \
--cc=akpm@linux-foundation.org \
--cc=andreyknvl@google.com \
--cc=aryabinin@virtuozzo.com \
--cc=catalin.marinas@arm.com \
--cc=dvyukov@google.com \
--cc=elver@google.com \
--cc=eugenis@google.com \
--cc=glider@google.com \
--cc=kasan-dev@googlegroups.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=lorenzo.pieralisi@arm.com \
--cc=will@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).