[PATCH v2 7/7] arm64: dts: meson-sm1-odroid-c4: remove invalid hub_5v regulator

[Neil Armstrong <narmstrong@baylibre.com>]

Drop the hub_5v regulator which controls the HUB Reset line with GPIOH_4 which
is already controlled by a GPIO HOG.

Until we can properly describe how to control USB HUBs reset lines, keeping
the GPIO HOG is an acceptable solution we use on multiple boards.

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
---
 .../boot/dts/amlogic/meson-sm1-odroid-c4.dts    | 17 -----------------
 1 file changed, 17 deletions(-)

diff --git a/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts b/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
index 8c327c03d845..8c30ce63686e 100644
--- a/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-sm1-odroid-c4.dts
@@ -23,18 +23,6 @@ led-blue {
 		};
 	};
 
-	hub_5v: regulator-hub_5v {
-		compatible = "regulator-fixed";
-		regulator-name = "HUB_5V";
-		regulator-min-microvolt = <5000000>;
-		regulator-max-microvolt = <5000000>;
-		vin-supply = <&vcc_5v>;
-
-		/* Connected to the Hub CHIPENABLE, LOW sets low power state */
-		gpio = <&gpio GPIOH_4 GPIO_ACTIVE_HIGH>;
-		enable-active-high;
-	};
-
 	sound {
 		model = "ODROID-C4";
 	};
@@ -58,8 +46,3 @@ hog-0 {
 &ir {
 	linux,rc-map-name = "rc-odroid";
 };
-
-&usb2_phy1 {
-	/* Enable the hub which is connected to this port */
-	phy-supply = <&hub_5v>;
-};
-- 
2.25.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel