Linux-ARM-Kernel Archive on lore.kernel.org
 help / color / Atom feed
* [PATCH] reset-socfpga: Fix nr_resets property
@ 2017-02-15 13:06 Rojhalat Ibrahim
  2017-02-15 14:57 ` Philipp Zabel
  0 siblings, 1 reply; 3+ messages in thread
From: Rojhalat Ibrahim @ 2017-02-15 13:06 UTC (permalink / raw)
  To: linux-arm-kernel

The SoC-FPGA reset controller driver defines NR_BANKS as 4 and uses that define
for two unrelated purposes. It is used
1. as an increment for reset line banks which are 32-bit registers with 4-byte
aligned addresses.
2. as the total number of reset line banks which together with the number of
resets per bank (32) limits the total number of useable resets to 96 and the
highest useable reset ID to 95.

This is clearly wrong as there are resets with higher IDs than 95 defined in
include/dt-bindings/reset/altr,rst-mgr.h and altr,rst-mgr-a10.h.

The patch introduces a new define BANK_INCREMENT for calculating the register
addresses as before and increases NR_BANKS to 6 for useable reset IDs up to 191.

Signed-off-by: Rojhalat Ibrahim <imr@rtschenk.de>
---
 reset-socfpga.c |   13 +++++++------
 1 file changed, 7 insertions(+), 6 deletions(-)

diff --git a/drivers/reset/reset-socfpga.c b/drivers/reset/reset-socfpga.c
index 43e4a9f..1c8e491 100644
--- a/drivers/reset/reset-socfpga.c
+++ b/drivers/reset/reset-socfpga.c
@@ -25,7 +25,8 @@
 #include <linux/spinlock.h>
 #include <linux/types.h>
 
-#define NR_BANKS		4
+#define BANK_INCREMENT		4
+#define NR_BANKS		6
 
 struct socfpga_reset_data {
 	spinlock_t			lock;
@@ -46,8 +47,8 @@ static int socfpga_reset_assert(struct reset_controller_dev *rcdev,
 
 	spin_lock_irqsave(&data->lock, flags);
 
-	reg = readl(data->membase + (bank * NR_BANKS));
-	writel(reg | BIT(offset), data->membase + (bank * NR_BANKS));
+	reg = readl(data->membase + (bank * BANK_INCREMENT));
+	writel(reg | BIT(offset), data->membase + (bank * BANK_INCREMENT));
 	spin_unlock_irqrestore(&data->lock, flags);
 
 	return 0;
@@ -67,8 +68,8 @@ static int socfpga_reset_deassert(struct reset_controller_dev *rcdev,
 
 	spin_lock_irqsave(&data->lock, flags);
 
-	reg = readl(data->membase + (bank * NR_BANKS));
-	writel(reg & ~BIT(offset), data->membase + (bank * NR_BANKS));
+	reg = readl(data->membase + (bank * BANK_INCREMENT));
+	writel(reg & ~BIT(offset), data->membase + (bank * BANK_INCREMENT));
 
 	spin_unlock_irqrestore(&data->lock, flags);
 
@@ -84,7 +85,7 @@ static int socfpga_reset_status(struct reset_controller_dev *rcdev,
 	int offset = id % BITS_PER_LONG;
 	u32 reg;
 
-	reg = readl(data->membase + (bank * NR_BANKS));
+	reg = readl(data->membase + (bank * BANK_INCREMENT));
 
 	return !(reg & BIT(offset));
 }

--
2.10.2

^ permalink raw reply	[flat|nested] 3+ messages in thread

end of thread, back to index

Thread overview: 3+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2017-02-15 13:06 [PATCH] reset-socfpga: Fix nr_resets property Rojhalat Ibrahim
2017-02-15 14:57 ` Philipp Zabel
2017-02-15 15:57   ` Dinh Nguyen

Linux-ARM-Kernel Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/0 linux-arm-kernel/git/0.git
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/1 linux-arm-kernel/git/1.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-arm-kernel linux-arm-kernel/ https://lore.kernel.org/linux-arm-kernel \
		linux-arm-kernel@lists.infradead.org
	public-inbox-index linux-arm-kernel

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.infradead.lists.linux-arm-kernel


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git