From mboxrd@z Thu Jan  1 00:00:00 1970
From: hanjun.guo@linaro.org (Hanjun Guo)
Date: Thu, 31 Jul 2014 18:57:20 +0800
Subject: [PATCH 10/19] ARM64 / ACPI: Get the enable method for SMP
 initialization in ACPI way
In-Reply-To: <20140731065426.GA876@quad.lixom.net>
References: <1406206825-15590-1-git-send-email-hanjun.guo@linaro.org>
 <1406206825-15590-11-git-send-email-hanjun.guo@linaro.org>
 <20140731065426.GA876@quad.lixom.net>
Message-ID: <53DA2110.8060000@linaro.org>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

On 2014-7-31 14:54, Olof Johansson wrote:
> Hi,
> 
> On Thu, Jul 24, 2014 at 09:00:16PM +0800, Hanjun Guo wrote:
>> +/*
>> + * In ACPI mode, the cpu possible map was enumerated before SMP
>> + * initialization when MADT table was parsed, so we can get the
>> + * possible map here to initialize CPUs.
>> + */
> 
> The DT smp init will warn if the kernel has been build with too low NR_CPUS.
> Does the ACPI core already warn, or did that go missing with this separate code
> path?

ACPI code will warn, it is in PATCH 07/19,

+	if (enabled_cpus >=  NR_CPUS) {
+		pr_warn("NR_CPUS limit of %d reached, Processor %d/0x%llx ignored.\n",
+			NR_CPUS, total_cpus, mpidr);
+		return -EINVAL;
+	}

> 
>> +static void __init acpi_smp_init_cpus(void)
>> +{
>> +	int cpu;
>> +
>> +	for_each_possible_cpu(cpu) {
>> +		if (cpu_acpi_read_ops(cpu) != 0)
>> +			continue;
>> +
>> +		cpu_ops[cpu]->cpu_init(NULL, cpu);
>> +	}
>> +}
>> +
>> +void __init smp_init_cpus(void)
>> +{
>> +	if (acpi_disabled)
>> +		of_smp_init_cpus();
>> +	else
>> +		acpi_smp_init_cpus();
> 
> I'm liking these deeply split code paths less and less every time I see
> them. :(
> 
> I would prefer to set up shared state in separate functions, but keep the
> control flow the same. Right now you're splitting it completely.
> 
> I.e. split data setup between the two, but do the loop calling cpu_init()
> the same way. (Yes, that will require you to refactor the DT code path
> a bit too...)

OK, I will dive into the code and figure out if I can fix that as you
suggested, thanks for your comments :)

Best Regards
Hanjun