Linux-ARM-Kernel Archive on lore.kernel.org
 help / Atom feed
From: Lokesh Vutla <lokeshvutla@ti.com>
To: Tony Lindgren <tony@atomide.com>
Cc: Nishanth Menon <nm@ti.com>,
	Device Tree Mailing List <devicetree@vger.kernel.org>,
	jason@lakedaemon.net, Peter Ujfalusi <peter.ujfalusi@ti.com>,
	marc.zyngier@arm.com, Sekhar Nori <nsekhar@ti.com>,
	linux-kernel@vger.kernel.org, Tero Kristo <t-kristo@ti.com>,
	Rob Herring <robh+dt@kernel.org>,
	Santosh Shilimkar <ssantosh@kernel.org>,
	tglx@linutronix.de,
	Linux ARM Mailing List <linux-arm-kernel@lists.infradead.org>
Subject: Re: [PATCH v5 05/10] dt-bindings: irqchip: Introduce TISCI Interrupt router bindings
Date: Wed, 13 Feb 2019 09:55:22 +0530
Message-ID: <6a274588-0fb6-2ddf-3bcc-f9e4d849ac07@ti.com> (raw)
In-Reply-To: <20190212162247.GK5720@atomide.com>

Hi Tony,

On 12/02/19 9:52 PM, Tony Lindgren wrote:
> Hi,
> 
> * Lokesh Vutla <lokeshvutla@ti.com> [190212 07:43]:
>> +Example:
>> +--------
>> +The following example demonstrates both interrupt router node and the consumer
>> +node(main gpio) on the AM654 SoC:
>> +
>> +main_intr: interrupt-controller0 {
>> +	compatible = "ti,sci-intr";
>> +	interrupt-controller;
>> +	interrupt-parent = <&gic500>;
>> +	#interrupt-cells = <4>;
>> +	ti,sci = <&dmsc>;
>> +	ti,sci-dst-id = <56>;
>> +	ti,sci-rm-range-girq = <0x1>;
>> +};
> 
> Can you describe a bit what the "ti,sci-dst-id" is above?
> 
> These IDs seem to be listed at at [0] below, but is it really a property
> of the hardware? Or is it some enumeration of SoC devices in the firmware?

This is the way that sysfw describes the hardware. In this case it is GIC and it
is identified by this ID.

Thanks and regards,
Lokesh

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  reply index

Thread overview: 46+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-02-12  7:42 [PATCH v5 00/10] Add support for TISCI irqchip drivers Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 01/10] firmware: ti_sci: Add support to get TISCI handle using of_phandle Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 02/10] firmware: ti_sci: Add support for RM core ops Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 03/10] firmware: ti_sci: Add support for IRQ management Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 04/10] firmware: ti_sci: Add RM mapping table for am654 Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 05/10] dt-bindings: irqchip: Introduce TISCI Interrupt router bindings Lokesh Vutla
2019-02-12 16:22   ` Tony Lindgren
2019-02-13  4:25     ` Lokesh Vutla [this message]
2019-02-13 15:26       ` Tony Lindgren
2019-02-13 20:40         ` Rob Herring
2019-02-14  8:38         ` Lokesh Vutla
2019-02-14 15:41           ` Tony Lindgren
2019-02-14 17:32             ` Lokesh Vutla
2019-02-14 17:46               ` Tony Lindgren
2019-02-14 18:02                 ` Lokesh Vutla
2019-02-15 16:16                   ` Tony Lindgren
2019-02-16  3:29                     ` Lokesh Vutla
2019-02-18 14:32                       ` Tony Lindgren
2019-02-19  8:51                         ` Lokesh Vutla
2019-02-19 15:35                           ` Tony Lindgren
2019-02-19 16:19                             ` Lokesh Vutla
2019-02-19 17:11                               ` Tony Lindgren
2019-02-19 17:56                                 ` Tony Lindgren
2019-02-20  5:53                                   ` Lokesh Vutla
2019-02-20 16:36                             ` Tony Lindgren
2019-02-20 17:17                               ` Lokesh Vutla
2019-02-12 16:30   ` Tony Lindgren
2019-02-13  4:22     ` Lokesh Vutla
2019-02-13 15:32       ` Tony Lindgren
2019-02-14  8:40         ` Lokesh Vutla
2019-02-14 15:42           ` Tony Lindgren
2019-02-16  3:30   ` Lokesh Vutla
2019-02-18 14:35     ` Tony Lindgren
2019-02-22 10:10       ` Peter Ujfalusi
2019-02-18 15:12   ` Marc Zyngier
2019-02-18 15:27     ` Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 06/10] irqchip: ti-sci-intr: Add support for Interrupt Router driver Lokesh Vutla
2019-02-18 15:52   ` Marc Zyngier
2019-02-20 13:17     ` Lokesh Vutla
2019-03-19 12:44       ` Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 07/10] dt-bindings: irqchip: Introduce TISCI Interrupt Aggregator bindings Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 08/10] irqchip: ti-sci-inta: Add support for Interrupt Aggregator driver Lokesh Vutla
2019-02-12  7:42 ` [PATCH v5 09/10] soc: ti: Add MSI domain support for K3 Interrupt Aggregator Lokesh Vutla
2019-02-13 16:41   ` Tony Lindgren
2019-02-12  7:42 ` [PATCH v5 10/10] soc: ti: am6: Enable interrupt controller drivers Lokesh Vutla
2019-02-16  3:37 ` [PATCH v5 00/10] Add support for TISCI irqchip drivers Lokesh Vutla

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=6a274588-0fb6-2ddf-3bcc-f9e4d849ac07@ti.com \
    --to=lokeshvutla@ti.com \
    --cc=devicetree@vger.kernel.org \
    --cc=jason@lakedaemon.net \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=marc.zyngier@arm.com \
    --cc=nm@ti.com \
    --cc=nsekhar@ti.com \
    --cc=peter.ujfalusi@ti.com \
    --cc=robh+dt@kernel.org \
    --cc=ssantosh@kernel.org \
    --cc=t-kristo@ti.com \
    --cc=tglx@linutronix.de \
    --cc=tony@atomide.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ARM-Kernel Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/0 linux-arm-kernel/git/0.git
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/1 linux-arm-kernel/git/1.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-arm-kernel linux-arm-kernel/ https://lore.kernel.org/linux-arm-kernel \
		linux-arm-kernel@lists.infradead.org infradead-linux-arm-kernel@archiver.kernel.org
	public-inbox-index linux-arm-kernel


Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.infradead.lists.linux-arm-kernel


AGPL code for this site: git clone https://public-inbox.org/ public-inbox