From mboxrd@z Thu Jan 1 00:00:00 1970 From: gregory.clement@free-electrons.com (Gregory CLEMENT) Date: Wed, 27 Jul 2016 12:19:01 +0200 Subject: [PATCH] ARM: dts: armada388-clearfog: number LAN ports properly In-Reply-To: <20160708152616.GF8426@lunn.ch> (Andrew Lunn's message of "Fri, 8 Jul 2016 17:26:16 +0200") References: <20160708152616.GF8426@lunn.ch> Message-ID: <87vazro02y.fsf@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, On ven., juil. 08 2016, Andrew Lunn wrote: > On Fri, Jul 08, 2016 at 02:58:39PM +0100, Russell King wrote: >> Currently, the ports as seen from the rear number as: >> >> eth0 sfp lan5 lan4 lan3 lan2 lan1 lan6 >> >> which is illogical - this came about because the rev 2.0 boards have the >> LEDs on the front for the DSA switch (lan5-1) reversed. Rev 2.1 boards >> fixed the LED issue, and the Clearfog case numbers the lan ports >> increasing from left to right. >> >> Maintaining this illogical numbering causes confusion, with reports that >> "my link isn't coming up" and "my connection negotiates 10base-Half" >> both of which are due to people thinking that the port next to the SFP >> is lan1. >> >> Fix this by renumbering the ports to match people's expectations. >> >> Signed-off-by: Russell King > > Reviewed-by: Andrew Lunn I missed this patch, but I now applied it on mvebu/dt-4.9 Thanks, Gregory -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com