[PATCH 2/3] dt-bindings: clock: Add bindings for ZynqMP clock driver

[robh@kernel.org (Rob Herring)]

On Wed, Mar 7, 2018 at 4:47 PM, Jolly Shah <JOLLYS@xilinx.com> wrote:
> Hi Rob,
>
>
>> -----Original Message-----
>> From: Rob Herring [mailto:robh at kernel.org]
>> Sent: Monday, March 05, 2018 5:46 PM
>> To: Jolly Shah <JOLLYS@xilinx.com>
>> Cc: mturquette at baylibre.com; sboyd at codeaurora.org;
>> michal.simek at xilinx.com; mark.rutland at arm.com; linux-clk at vger.kernel.org;
>> devicetree at vger.kernel.org; Shubhrajyoti Datta <shubhraj@xilinx.com>; linux-
>> kernel at vger.kernel.org; Jolly Shah <JOLLYS@xilinx.com>; Rajan Vaja
>> <RAJANV@xilinx.com>; linux-arm-kernel at lists.infradead.org
>> Subject: Re: [PATCH 2/3] dt-bindings: clock: Add bindings for ZynqMP clock
>> driver
>>
>> On Wed, Feb 28, 2018 at 02:27:40PM -0800, Jolly Shah wrote:
>> > Add documentation to describe Xilinx ZynqMP clock driver bindings.
>> >
>> > Signed-off-by: Jolly Shah <jollys@xilinx.com>
>> > Signed-off-by: Rajan Vaja <rajanv@xilinx.com>
>> > Signed-off-by: Shubhrajyoti Datta <shubhrajyoti.datta@xilinx.com>
>> > ---

>> > +95         dpll_post_src
>> > +96         vpll_int
>> > +97         vpll_pre_src
>> > +98         vpll_half
>> > +99         vpll_int_mux
>> > +100                vpll_post_src
>> > +101                can0_mio
>> > +102                can1_mio
>> > +
>> > +Example:
>> > +
>> > +clk: clk {
>> > +   #clock-cells = <1>;
>> > +   compatible = "xlnx,zynqmp-clk";
>>
>> How do you control the clocks?
>
> Clocks are controlled by a dedicated platform management controller. Above clock ids are used to identify clocks between master and PMU.

What is the interface to the "platform management controller"? Because
you have no registers, I'm guessing a firmware interface? If so, then
just define the firmware node as a clock provider.

Rob