From: Chanwoo Choi <cw00.choi@samsung.com>
To: Kamil Konieczny <k.konieczny@partner.samsung.com>
Cc: Mark Rutland <mark.rutland@arm.com>, Nishanth Menon <nm@ti.com>,
linux-samsung-soc@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>,
Stephen Boyd <sboyd@kernel.org>,
Viresh Kumar <vireshk@kernel.org>,
linux-pm@vger.kernel.org, linux-kernel@vger.kernel.org,
Krzysztof Kozlowski <krzk@kernel.org>,
Rob Herring <robh+dt@kernel.org>,
Kyungmin Park <kyungmin.park@samsung.com>,
Kukjin Kim <kgene@kernel.org>,
MyungJoo Ham <myungjoo.ham@samsung.com>,
devicetree@vger.kernel.org,
Marek Szyprowski <m.szyprowski@samsung.com>
Subject: Re: [PATCH v2 4/4] dt-bindings: devfreq: exynos-bus: remove unused property
Date: Tue, 16 Jul 2019 17:54:12 +0900 [thread overview]
Message-ID: <dd74212e-a422-13ab-8237-fcaf372ab3eb@samsung.com> (raw)
In-Reply-To: <20190715120416.3561-5-k.konieczny@partner.samsung.com>
Hi,
On 19. 7. 15. 오후 9:04, Kamil Konieczny wrote:
> Remove unused DT property "exynos,voltage-tolerance".
>
> Signed-off-by: Kamil Konieczny <k.konieczny@partner.samsung.com>
> ---
> Documentation/devicetree/bindings/devfreq/exynos-bus.txt | 2 --
> 1 file changed, 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
> index f8e946471a58..e71f752cc18f 100644
> --- a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
> +++ b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
> @@ -50,8 +50,6 @@ Required properties only for passive bus device:
> Optional properties only for parent bus device:
> - exynos,saturation-ratio: the percentage value which is used to calibrate
> the performance count against total cycle count.
> -- exynos,voltage-tolerance: the percentage value for bus voltage tolerance
> - which is used to calculate the max voltage.
>
> Detailed correlation between sub-blocks and power line according to Exynos SoC:
> - In case of Exynos3250, there are two power line as following:
>
Acked-by: Chanwoo Choi <cw00.choi@samsung.com>
--
Best Regards,
Chanwoo Choi
Samsung Electronics
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
prev parent reply other threads:[~2019-07-16 8:51 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <CGME20190715120430eucas1p1dd216e552403899e614845295373e467@eucas1p1.samsung.com>
2019-07-15 12:04 ` [PATCH v2 0/4] add coupled regulators for Exynos5422/5800 Kamil Konieczny
[not found] ` <CGME20190715120430eucas1p19dddcc93756e6a110d3476229f9428b3@eucas1p1.samsung.com>
2019-07-15 12:04 ` [PATCH v2 1/4] opp: core: add regulators enable and disable Kamil Konieczny
2019-07-16 4:03 ` Chanwoo Choi
2019-07-17 14:12 ` Kamil Konieczny
2019-07-16 10:05 ` Viresh Kumar
2019-07-17 14:14 ` Kamil Konieczny
[not found] ` <CGME20190715120431eucas1p215eae81d0ca772d7e2a22a803669068a@eucas1p2.samsung.com>
2019-07-15 12:04 ` [PATCH v2 2/4] devfreq: exynos-bus: convert to use dev_pm_opp_set_rate() Kamil Konieczny
2019-07-16 3:56 ` Chanwoo Choi
2019-07-16 10:13 ` Bartlomiej Zolnierkiewicz
2019-07-16 10:33 ` Chanwoo Choi
2019-07-16 10:59 ` Bartlomiej Zolnierkiewicz
2019-07-16 11:26 ` Chanwoo Choi
2019-07-16 11:39 ` Bartlomiej Zolnierkiewicz
2019-07-16 11:56 ` Bartlomiej Zolnierkiewicz
[not found] ` <CGME20190715120432eucas1p1b32d72d239420b861bf8596d4e8a053d@eucas1p1.samsung.com>
2019-07-15 12:04 ` [PATCH v2 3/4] ARM: dts: exynos: add initial data for coupled regulators for Exynos5422/5800 Kamil Konieczny
2019-07-16 9:00 ` Chanwoo Choi
2019-07-16 9:22 ` Krzysztof Kozlowski
2019-07-16 10:30 ` Bartlomiej Zolnierkiewicz
[not found] ` <CGME20190715120433eucas1p26681c5c2d87423253b651d88446c538c@eucas1p2.samsung.com>
2019-07-15 12:04 ` [PATCH v2 4/4] dt-bindings: devfreq: exynos-bus: remove unused property Kamil Konieczny
2019-07-16 8:54 ` Chanwoo Choi [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=dd74212e-a422-13ab-8237-fcaf372ab3eb@samsung.com \
--to=cw00.choi@samsung.com \
--cc=b.zolnierkie@samsung.com \
--cc=devicetree@vger.kernel.org \
--cc=k.konieczny@partner.samsung.com \
--cc=kgene@kernel.org \
--cc=krzk@kernel.org \
--cc=kyungmin.park@samsung.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux-samsung-soc@vger.kernel.org \
--cc=m.szyprowski@samsung.com \
--cc=mark.rutland@arm.com \
--cc=myungjoo.ham@samsung.com \
--cc=nm@ti.com \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
--cc=vireshk@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).