Re: [PATCH 2/2] drm: sun4i: hdmi: Add support for sun4i HDMI encoder audio

[Stefan Mavrodiev <stefan@olimex.com>]

Hi,

On 1/10/20 6:26 PM, Maxime Ripard wrote:
> Hi,
>
> On Fri, Jan 10, 2020 at 04:11:40PM +0200, Stefan Mavrodiev wrote:
>> Add HDMI audio support for the sun4i-hdmi encoder, used on
>> the older Allwinner chips - A10, A20, A31.
>>
>> Most of the code is based on the BSP implementation. In it
>> dditional formats are supported (S20_3LE and S24_LE), however
>> there where some problems with them and only S16_LE is left.
>>
>> Signed-off-by: Stefan Mavrodiev <stefan@olimex.com>
>> ---
>>   drivers/gpu/drm/sun4i/Kconfig            |   1 +
>>   drivers/gpu/drm/sun4i/Makefile           |   1 +
>>   drivers/gpu/drm/sun4i/sun4i_hdmi.h       |  30 ++
>>   drivers/gpu/drm/sun4i/sun4i_hdmi_audio.c | 375 +++++++++++++++++++++++
>>   drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c   |   4 +
>>   5 files changed, 411 insertions(+)
>>   create mode 100644 drivers/gpu/drm/sun4i/sun4i_hdmi_audio.c
>>
>> diff --git a/drivers/gpu/drm/sun4i/Kconfig b/drivers/gpu/drm/sun4i/Kconfig
>> index 37e90e42943f..192b732b10cd 100644
>> --- a/drivers/gpu/drm/sun4i/Kconfig
>> +++ b/drivers/gpu/drm/sun4i/Kconfig
>> @@ -19,6 +19,7 @@ if DRM_SUN4I
>>   config DRM_SUN4I_HDMI
>>          tristate "Allwinner A10 HDMI Controller Support"
>>          default DRM_SUN4I
>> +       select SND_PCM_ELD
>>          help
>>   	  Choose this option if you have an Allwinner SoC with an HDMI
>>   	  controller.
>> diff --git a/drivers/gpu/drm/sun4i/Makefile b/drivers/gpu/drm/sun4i/Makefile
>> index 0d04f2447b01..e2d82b451c36 100644
>> --- a/drivers/gpu/drm/sun4i/Makefile
>> +++ b/drivers/gpu/drm/sun4i/Makefile
>> @@ -5,6 +5,7 @@ sun4i-frontend-y		+= sun4i_frontend.o
>>   sun4i-drm-y			+= sun4i_drv.o
>>   sun4i-drm-y			+= sun4i_framebuffer.o
>>
>> +sun4i-drm-hdmi-y		+= sun4i_hdmi_audio.o
>>   sun4i-drm-hdmi-y		+= sun4i_hdmi_ddc_clk.o
>>   sun4i-drm-hdmi-y		+= sun4i_hdmi_enc.o
>>   sun4i-drm-hdmi-y		+= sun4i_hdmi_i2c.o
>> diff --git a/drivers/gpu/drm/sun4i/sun4i_hdmi.h b/drivers/gpu/drm/sun4i/sun4i_hdmi.h
>> index 7ad3f06c127e..456964e681b0 100644
>> --- a/drivers/gpu/drm/sun4i/sun4i_hdmi.h
>> +++ b/drivers/gpu/drm/sun4i/sun4i_hdmi.h
>> @@ -42,7 +42,32 @@
>>   #define SUN4I_HDMI_VID_TIMING_POL_VSYNC		BIT(1)
>>   #define SUN4I_HDMI_VID_TIMING_POL_HSYNC		BIT(0)
>>
>> +#define SUN4I_HDMI_AUDIO_CTRL_REG	0x040
>> +#define SUN4I_HDMI_AUDIO_CTRL_ENABLE		BIT(31)
>> +#define SUN4I_HDMI_AUDIO_CTRL_RESET		BIT(30)
>> +
>> +#define SUN4I_HDMI_AUDIO_FMT_REG	0x048
>> +#define SUN4I_HDMI_AUDIO_FMT_SRC		BIT(31)
>> +#define SUN4I_HDMI_AUDIO_FMT_LAYOUT		BIT(3)
>> +#define SUN4I_HDMI_AUDIO_FMT_CH_CFG(n)		(n - 1)
> There's the issue multiple times in the headers, but you should wrap n
> in parentheses to make sure we have no issue with precedence when
> calling the macro.
>
>> +int sun4i_hdmi_audio_create(struct sun4i_hdmi *hdmi)
>> +{
>> +	struct snd_soc_card *card = &sun4i_hdmi_audio_card;
>> +	struct snd_soc_dai_link_component *comp;
>> +	struct snd_soc_dai_link *link;
>> +	int ret;
>> +
>> +	ret = devm_snd_dmaengine_pcm_register(hdmi->dev,
>> +					      &sun4i_hdmi_audio_pcm_config, 0);
>> +	if (ret) {
>> +		DRM_ERROR("Could not register PCM\n");
>> +		return ret;
>> +	}
>> +
>> +	ret = devm_snd_soc_register_component(hdmi->dev,
>> +					      &sun4i_hdmi_audio_component,
>> +					      &sun4i_hdmi_audio_dai, 1);
>> +	if (ret) {
>> +		DRM_ERROR("Could not register DAI\n");
>> +		return ret;
>> +	}
>> +
>> +	link = devm_kzalloc(hdmi->dev, sizeof(*link), GFP_KERNEL);
>> +	if (!link)
>> +		return -ENOMEM;
>> +
>> +	comp = devm_kzalloc(hdmi->dev, sizeof(*comp) * 3, GFP_KERNEL);
>> +	if (!comp)
>> +		return -ENOMEM;
>> +
>> +	link->cpus = &comp[0];
>> +	link->codecs = &comp[1];
>> +	link->platforms = &comp[2];
>> +
>> +	link->num_cpus = 1;
>> +	link->num_codecs = 1;
>> +	link->num_platforms = 1;
>> +
>> +	link->playback_only = 1;
>> +
>> +	link->name = "SUN4I-HDMI";
>> +	link->stream_name = "SUN4I-HDMI PCM";
>> +
>> +	link->codecs->name = dev_name(hdmi->dev);
>> +	link->codecs->dai_name	= sun4i_hdmi_audio_dai.name;
>> +
>> +	link->cpus->dai_name = dev_name(hdmi->dev);
>> +
>> +	link->platforms->name = dev_name(hdmi->dev);
>> +
>> +	link->dai_fmt = SND_SOC_DAIFMT_I2S;
>> +
>> +	card->dai_link = link;
>> +	card->num_links = 1;
>> +	card->dev = hdmi->dev;
>> +
>> +	snd_soc_card_set_drvdata(card, hdmi);
>> +	return devm_snd_soc_register_card(hdmi->dev, card);
> Out of curiosity, did you try to remove the module with that patch
> applied? IIRC, these functions will overwrite the device drvdata, and
> we will try to access them in unbind / remove.
Actually I did not. Just tried that and you're right. The module crashes 
at the unbind call.
I use sun4i_hdmi struct only for regmap. Maybe create separate private 
structure and copy only
regmap?
>
>> +}
>> diff --git a/drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c b/drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c
>> index a7c4654445c7..79ecd89fb705 100644
>> --- a/drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c
>> +++ b/drivers/gpu/drm/sun4i/sun4i_hdmi_enc.c
>> @@ -114,6 +114,9 @@ static void sun4i_hdmi_enable(struct drm_encoder *encoder)
>>   		val |= SUN4I_HDMI_VID_CTRL_HDMI_MODE;
>>
>>   	writel(val, hdmi->base + SUN4I_HDMI_VID_CTRL_REG);
>> +
>> +	if (hdmi->hdmi_audio && sun4i_hdmi_audio_create(hdmi))
>> +		DRM_ERROR("Couldn't create the HDMI audio adapter\n");
> So you create the audio card each time the display is enabled? I guess
> this is to deal with the hotplug?
Yes. See below.
>
> I'm not sure this is the right thing to do. If I remember well, the
> ELD are here precisely to let userspace know that the display is
> plugged (and audio-capable) or not.
>
> Also, you don't remove that card in the disable, which mean that if
> you end up in a situation where you would enable the display, disable
> it and then enable it again, you have two audio cards now.
There is issue with the hotplug. When inserting the cable, the event is 
detected
and the hdmi encoder is enabled. Thus the card is created. However 
further removal and
insertions are not detected. This is why I don't remove the card.

Also I count on devm_snd_soc_register_card() to release the card.
>
> Thanks!
> Maxime


Best regards,
Stefan


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel