From: mani@kernel.org
To: gregkh@linuxfoundation.org
Cc: hemantk@codeaurora.org, jhugo@codeaurora.org,
linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org,
Bhaumik Bhatt <bbhatt@codeaurora.org>,
Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Subject: [PATCH 06/14] bus: mhi: core: Return appropriate error codes for AMSS load failure
Date: Thu, 21 May 2020 20:55:32 +0530 [thread overview]
Message-ID: <20200521152540.17335-7-mani@kernel.org> (raw)
In-Reply-To: <20200521152540.17335-1-mani@kernel.org>
From: Bhaumik Bhatt <bbhatt@codeaurora.org>
When loading AMSS firmware using BHIe protocol, return -ETIMEDOUT if no
response is received within the timeout or return -EIO in case of a
protocol returned failure or an MHI error state.
Signed-off-by: Bhaumik Bhatt <bbhatt@codeaurora.org>
Reviewed-by: Jeffrey Hugo <jhugo@codeaurora.org>
Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
drivers/bus/mhi/core/boot.c | 23 ++++++++++++-----------
1 file changed, 12 insertions(+), 11 deletions(-)
diff --git a/drivers/bus/mhi/core/boot.c b/drivers/bus/mhi/core/boot.c
index 17c636b4bc6e..cf6dc5a2361c 100644
--- a/drivers/bus/mhi/core/boot.c
+++ b/drivers/bus/mhi/core/boot.c
@@ -176,6 +176,7 @@ static int mhi_fw_load_amss(struct mhi_controller *mhi_cntrl,
void __iomem *base = mhi_cntrl->bhie;
rwlock_t *pm_lock = &mhi_cntrl->pm_lock;
u32 tx_status, sequence_id;
+ int ret;
read_lock_bh(pm_lock);
if (!MHI_REG_ACCESS_VALID(mhi_cntrl->pm_state)) {
@@ -198,19 +199,19 @@ static int mhi_fw_load_amss(struct mhi_controller *mhi_cntrl,
read_unlock_bh(pm_lock);
/* Wait for the image download to complete */
- wait_event_timeout(mhi_cntrl->state_event,
- MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state) ||
- mhi_read_reg_field(mhi_cntrl, base,
- BHIE_TXVECSTATUS_OFFS,
- BHIE_TXVECSTATUS_STATUS_BMSK,
- BHIE_TXVECSTATUS_STATUS_SHFT,
- &tx_status) || tx_status,
- msecs_to_jiffies(mhi_cntrl->timeout_ms));
-
- if (MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state))
+ ret = wait_event_timeout(mhi_cntrl->state_event,
+ MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state) ||
+ mhi_read_reg_field(mhi_cntrl, base,
+ BHIE_TXVECSTATUS_OFFS,
+ BHIE_TXVECSTATUS_STATUS_BMSK,
+ BHIE_TXVECSTATUS_STATUS_SHFT,
+ &tx_status) || tx_status,
+ msecs_to_jiffies(mhi_cntrl->timeout_ms));
+ if (MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state) ||
+ tx_status != BHIE_TXVECSTATUS_STATUS_XFER_COMPL)
return -EIO;
- return (tx_status == BHIE_TXVECSTATUS_STATUS_XFER_COMPL) ? 0 : -EIO;
+ return (!ret) ? -ETIMEDOUT : 0;
}
static int mhi_fw_load_sbl(struct mhi_controller *mhi_cntrl,
--
2.26.GIT
next prev parent reply other threads:[~2020-05-21 15:26 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-05-21 15:25 [PATCH 00/14] MHI patches for v5.8 mani
2020-05-21 15:25 ` [PATCH 01/14] bus: mhi: core: Refactor mhi queue APIs mani
2020-05-21 15:25 ` [PATCH 02/14] bus: mhi: core: Cache intmod from mhi event to mhi channel mani
2020-05-21 15:25 ` [PATCH 03/14] bus: mhi: core: Add range check for channel id received in event ring mani
2020-05-21 15:25 ` [PATCH 04/14] bus: mhi: core: Read transfer length from an event properly mani
2020-05-21 15:25 ` [PATCH 05/14] bus: mhi: core: Handle firmware load using state worker mani
2020-05-21 15:25 ` mani [this message]
2020-05-21 15:25 ` [PATCH 07/14] bus: mhi: core: Improve debug logs for loading firmware mani
2020-05-21 15:25 ` [PATCH 08/14] bus: mhi: core: Ensure non-zero session or sequence ID values are used mani
2020-05-21 15:25 ` [PATCH 09/14] bus: mhi: core: Remove the system error worker thread mani
2020-05-21 15:25 ` [PATCH 10/14] bus: mhi: core: Handle disable transitions in state worker mani
2020-05-21 15:25 ` [PATCH 11/14] bus: mhi: core: Skip handling BHI irq if MHI reg access is not allowed mani
2020-05-21 15:25 ` [PATCH 12/14] bus: mhi: core: Do not process SYS_ERROR if RDDM is supported mani
2020-05-21 15:25 ` [PATCH 13/14] bus: mhi: core: Handle write lock properly in mhi_pm_m0_transition mani
2020-05-21 15:25 ` [PATCH 14/14] bus: mhi: core: Handle syserr during power_up mani
2020-05-21 15:29 ` [PATCH 00/14] MHI patches for v5.8 Manivannan Sadhasivam
2020-05-21 16:19 ` Greg KH
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200521152540.17335-7-mani@kernel.org \
--to=mani@kernel.org \
--cc=bbhatt@codeaurora.org \
--cc=gregkh@linuxfoundation.org \
--cc=hemantk@codeaurora.org \
--cc=jhugo@codeaurora.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=manivannan.sadhasivam@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).