[RFC 15/24] drm/msm/dsi: limit vco_delay to 28nm PHY

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

Only 28nm PHY requires sleeping during the VCO rate setting procedure.
Rewrite sleeping for 28nm and drop vco_delay from the rest of PHYs.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
---
 drivers/gpu/drm/msm/dsi/phy/dsi_phy_10nm.c |  3 ---
 drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c |  4 ----
 drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c | 10 ++++------
 drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c  |  3 ---
 4 files changed, 4 insertions(+), 16 deletions(-)

diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_10nm.c b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_10nm.c
index 81ca0cf2a3ad..7533db8955a5 100644
--- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_10nm.c
+++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_10nm.c
@@ -96,7 +96,6 @@ struct dsi_pll_10nm {
 	/* protects REG_DSI_10nm_PHY_CMN_CLK_CFG0 register */
 	spinlock_t postdiv_lock;
 
-	int vco_delay;
 	struct dsi_pll_config pll_configuration;
 	struct dsi_pll_regs reg_setup;
 
@@ -768,8 +767,6 @@ static int dsi_pll_10nm_init(struct msm_dsi_phy *phy)
 	pll = &pll_10nm->base;
 	pll->cfg = phy->cfg;
 
-	pll_10nm->vco_delay = 1;
-
 	ret = pll_10nm_register(pll_10nm, phy->provided_clocks);
 	if (ret) {
 		DRM_DEV_ERROR(&pdev->dev, "failed to register PLL: %d\n", ret);
diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c
index c531ddf26521..023727623847 100644
--- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c
+++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_14nm.c
@@ -122,8 +122,6 @@ struct dsi_pll_14nm {
 	void __iomem *phy_cmn_mmio;
 	void __iomem *mmio;
 
-	int vco_delay;
-
 	struct dsi_pll_input in;
 	struct dsi_pll_output out;
 
@@ -1012,8 +1010,6 @@ static int dsi_pll_14nm_init(struct msm_dsi_phy *phy)
 	pll = &pll_14nm->base;
 	pll->cfg = phy->cfg;
 
-	pll_14nm->vco_delay = 1;
-
 	ret = pll_14nm_register(pll_14nm, phy->provided_clocks);
 	if (ret) {
 		DRM_DEV_ERROR(&pdev->dev, "failed to register PLL: %d\n", ret);
diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c
index fa96bfc21fdb..e77b21f0d3bf 100644
--- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c
+++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_28nm.c
@@ -69,8 +69,6 @@ struct dsi_pll_28nm {
 	struct platform_device *pdev;
 	void __iomem *mmio;
 
-	int vco_delay;
-
 	struct pll_28nm_cached_state cached_state;
 };
 
@@ -209,8 +207,10 @@ static int dsi_pll_28nm_clk_set_rate(struct clk_hw *hw, unsigned long rate,
 	pll_write(base + REG_DSI_28nm_PHY_PLL_SDM_CFG4, 0x00);
 
 	/* Add hardware recommended delay for correct PLL configuration */
-	if (pll_28nm->vco_delay)
-		udelay(pll_28nm->vco_delay);
+	if (pll->cfg->type == MSM_DSI_PHY_28NM_HPM)
+		udelay(1);
+	else /* LP */
+		udelay(1000);
 
 	pll_write(base + REG_DSI_28nm_PHY_PLL_REFCLK_CFG, refclk_cfg);
 	pll_write(base + REG_DSI_28nm_PHY_PLL_PWRGEN_CFG, 0x00);
@@ -576,7 +576,6 @@ static int dsi_pll_28nm_hpm_init(struct msm_dsi_phy *phy)
 	}
 
 	pll = &pll_28nm->base;
-	pll_28nm->vco_delay = 1;
 
 	pll->cfg = phy->cfg;
 
@@ -616,7 +615,6 @@ static int dsi_pll_28nm_lp_init(struct msm_dsi_phy *phy)
 	}
 
 	pll = &pll_28nm->base;
-	pll_28nm->vco_delay = 1000;
 
 	pll->cfg = phy->cfg;
 
diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
index c6f0aca66fa9..d3fea4a2b498 100644
--- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
+++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c
@@ -96,7 +96,6 @@ struct dsi_pll_7nm {
 	/* protects REG_DSI_7nm_PHY_CMN_CLK_CFG0 register */
 	spinlock_t postdiv_lock;
 
-	int vco_delay;
 	struct dsi_pll_config pll_configuration;
 	struct dsi_pll_regs reg_setup;
 
@@ -793,8 +792,6 @@ static int dsi_pll_7nm_init(struct msm_dsi_phy *phy)
 	pll = &pll_7nm->base;
 	pll->cfg = phy->cfg;
 
-	pll_7nm->vco_delay = 1;
-
 	ret = pll_7nm_register(pll_7nm, phy->provided_clocks);
 	if (ret) {
 		DRM_DEV_ERROR(&pdev->dev, "failed to register PLL: %d\n", ret);
-- 
2.30.0