From: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
To: Linus Walleij <linus.walleij@linaro.org>
Cc: Andy Gross <agross@kernel.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
Rob Herring <robh+dt@kernel.org>,
"open list:GPIO SUBSYSTEM" <linux-gpio@vger.kernel.org>,
"open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS"
<devicetree@vger.kernel.org>, MSM <linux-arm-msm@vger.kernel.org>
Subject: Re:
Date: Wed, 13 Oct 2021 06:46:43 +0300 [thread overview]
Message-ID: <CAA8EJpoqawEDKfKiPzU1zYACa8hU16Ly00tsb0d6BU_jLQMEWQ@mail.gmail.com> (raw)
In-Reply-To: <CACRpkda_hW7vbvC1jizRa05ZdgeL-FkU3_zF+rvCfRBuRB3+VQ@mail.gmail.com>
On Wed, 13 Oct 2021 at 02:59, Linus Walleij <linus.walleij@linaro.org> wrote:
>
> On Fri, Oct 8, 2021 at 3:25 AM Dmitry Baryshkov
> <dmitry.baryshkov@linaro.org> wrote:
>
> > In 2019 (in kernel 5.4) spmi-gpio and ssbi-gpio drivers were converted
> > to hierarchical IRQ helpers, however MPP drivers were not converted at
> > that moment. Complete this by converting MPP drivers.
> >
> > Changes since v2:
> > - Add patches fixing/updating mpps nodes in the existing device trees
>
> Thanks a *lot* for being thorough and fixing all this properly!
>
> I am happy to apply the pinctrl portions to the pinctrl tree, I'm
> uncertain about Rob's syntax checker robot here, are there real
> problems? Sometimes it complains about things being changed
> in the DTS files at the same time.
Rob's checker reports issue that are being fixed by respective
patches. I think I've updated all dts entries for the mpp devices tree
nodes.
> I could apply all of this (including DTS changes) to an immutable
> branch and offer to Bjorn if he is fine with the patches and
> the general approach.
I'm fine with either approach.
--
With best wishes
Dmitry
next prev parent reply other threads:[~2021-10-13 3:46 UTC|newest]
Thread overview: 48+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-10-08 1:24 Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 01/25] dt-bindings: pinctrl: qcom,pmic-mpp: Convert qcom pmic mpp bindings to YAML Dmitry Baryshkov
2021-10-08 2:46 ` Rob Herring
2021-10-08 1:25 ` [PATCH v3 02/25] dt-bindings: mfd: qcom-pm8xxx: add missing child nodes Dmitry Baryshkov
2021-10-08 2:46 ` Rob Herring
2021-10-17 21:28 ` Linus Walleij
2021-10-18 18:40 ` Rob Herring
2021-10-08 1:25 ` [PATCH v3 03/25] ARM: dts: qcom-apq8064: add gpio-ranges to mpps nodes Dmitry Baryshkov
2021-10-12 23:54 ` Linus Walleij
2021-10-08 1:25 ` [PATCH v3 04/25] ARM: dts: qcom-msm8660: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 05/25] ARM: dts: qcom-pm8841: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 06/25] ARM: dts: qcom-pm8941: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 07/25] ARM: dts: qcom-pma8084: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 08/25] ARM: dts: qcom-mdm9615: add gpio-ranges to mpps node, fix its name Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 09/25] ARM: dts: qcom-apq8060-dragonboard: fix mpps state names Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 10/25] arm64: dts: qcom: pm8916: fix mpps device tree node Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 11/25] arm64: dts: qcom: pm8994: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 12/25] arm64: dts: qcom: apq8016-sbc: fix mpps state names Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 13/25] pinctrl: qcom: ssbi-mpp: hardcode IRQ counts Dmitry Baryshkov
2021-10-17 16:52 ` Bjorn Andersson
2021-10-08 1:25 ` [PATCH v3 14/25] pinctrl: qcom: ssbi-mpp: add support for hierarchical IRQ chip Dmitry Baryshkov
2021-10-17 16:53 ` Bjorn Andersson
2021-10-08 1:25 ` [PATCH v3 15/25] pinctrl: qcom: spmi-mpp: hardcode IRQ counts Dmitry Baryshkov
2021-10-17 16:53 ` Bjorn Andersson
2021-10-08 1:25 ` [PATCH v3 16/25] pinctrl: qcom: spmi-mpp: add support for hierarchical IRQ chip Dmitry Baryshkov
2021-10-17 16:53 ` Bjorn Andersson
2021-10-08 1:25 ` [PATCH v3 17/25] dt-bindings: pinctrl: qcom,pmic-mpp: switch to #interrupt-cells Dmitry Baryshkov
2021-10-08 2:46 ` Rob Herring
2021-10-08 1:25 ` [PATCH v3 18/25] ARM: dts: qcom-apq8064: add interrupt controller properties Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 19/25] ARM: dts: qcom-mdm9615: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 20/25] ARM: dts: qcom-msm8660: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 21/25] ARM: dts: qcom-pm8841: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 22/25] ARM: dts: qcom-pm8941: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 23/25] ARM: dts: qcom-pma8084: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 24/25] arm64: dts: qcom: pm8916: " Dmitry Baryshkov
2021-10-08 1:25 ` [PATCH v3 25/25] arm64: dts: qcom: pm8994: " Dmitry Baryshkov
2021-10-12 23:59 ` Linus Walleij
2021-10-13 3:46 ` Dmitry Baryshkov [this message]
2021-10-13 23:39 ` Re: Linus Walleij
2021-10-17 16:54 ` Re: Bjorn Andersson
2021-10-17 21:31 ` Re: Linus Walleij
2021-10-17 21:35 ` Re: Linus Walleij
2021-10-18 0:13 ` (subset) Bjorn Andersson
-- strict thread matches above, loose matches on Subject: below --
2021-05-15 22:57 Dmitry Baryshkov
2021-06-02 21:45 ` Dmitry Baryshkov
2020-08-05 11:02 [PATCH v4] arm64: dts: qcom: Add support for Xiaomi Poco F1 (Beryllium) Amit Pundir
2020-08-06 22:31 ` Konrad Dybcio
2020-08-12 13:37 ` Amit Pundir
2017-11-13 14:55 Re: Amos Kalonzo
2017-02-23 15:09 Qin's Yanjun
2012-05-20 22:20 Mr. Peter Wong
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=CAA8EJpoqawEDKfKiPzU1zYACa8hU16Ly00tsb0d6BU_jLQMEWQ@mail.gmail.com \
--to=dmitry.baryshkov@linaro.org \
--cc=agross@kernel.org \
--cc=bjorn.andersson@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=robh+dt@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).