Re: [PATCH v2] arm64/dts/qcom/sc7180: Add Display Port dt node

[Stephen Boyd <swboyd@chromium.org>]

Quoting Bjorn Andersson (2021-06-08 15:26:23)
> On Tue 08 Jun 17:15 CDT 2021, Stephen Boyd wrote:
>
> > Quoting Bjorn Andersson (2021-06-07 16:31:47)
> > > On Mon 07 Jun 12:48 CDT 2021, khsieh@codeaurora.org wrote:
> > >
> > > > Sorry about the confusion. What I meant is that even though DP controller is
> > > > in the MDSS_GDSC
> > > > power domain, DP PHY/PLL sources out of CX. The DP link clocks have a direct
> > > > impact
> > > > on the CX voltage corners. Therefore, we need to mention the CX power domain
> > > > here. And, since
> > > > we can associate only one OPP table with one device, we picked the DP link
> > > > clock over other
> > > > clocks.
> > >
> > > Thank you, that's a much more useful answer.
> > >
> > > Naturally I would think it would make more sense for the PHY/PLL driver
> > > to ensure that CX is appropriately voted for then, but I think that
> > > would result in it being the clock driver performing such vote and I'm
> > > unsure how the opp table for that would look.
> > >
> > > @Stephen, what do you say?
> > >
> >
> > Wouldn't the PHY be the one that sets some vote? So it wouldn't be the
> > clk driver, and probably not from the clk ops, but instead come from the
> > phy ops via phy_enable() and phy_configure().
> >
>
> If I understand the logic correctly *_configure_dp_phy() will both
> configure the vco clock and "request" the clock framework to change the
> rate.
>
> So I presume what you're suggesting is that that would be the place to
> cast the CX corner vote?

Yes that would be a place to make the CX vote. The problem is then I
don't know where to drop the vote. Is that when the phy is disabled?