Re: [PATCH v2 04/11] mmc: bcm2835: stop setting chan_config->slave_id

[Ulf Hansson <ulf.hansson@linaro.org>]

On Mon, 22 Nov 2021 at 23:23, Arnd Bergmann <arnd@kernel.org> wrote:
>
> From: Arnd Bergmann <arnd@arndb.de>
>
> The field is not interpreted by the DMA engine driver, as all the data
> is passed from devicetree instead. Remove the assignment so the field
> can eventually be deleted.
>
> Reviewed-by: Nicolas Saenz Julienne <nsaenz@kernel.org>
> Signed-off-by: Arnd Bergmann <arnd@arndb.de>

I think I acked the previous version, but nevermind:

Acked-by: Ulf Hansson <ulf.hansson@linaro.org>

Kind regards
Uffe

> ---
>  drivers/mmc/host/bcm2835.c | 2 --
>  1 file changed, 2 deletions(-)
>
> diff --git a/drivers/mmc/host/bcm2835.c b/drivers/mmc/host/bcm2835.c
> index 8c2361e66277..463b707d9e99 100644
> --- a/drivers/mmc/host/bcm2835.c
> +++ b/drivers/mmc/host/bcm2835.c
> @@ -1293,14 +1293,12 @@ static int bcm2835_add_host(struct bcm2835_host *host)
>
>                 host->dma_cfg_tx.src_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
>                 host->dma_cfg_tx.dst_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
> -               host->dma_cfg_tx.slave_id = 13;         /* DREQ channel */
>                 host->dma_cfg_tx.direction = DMA_MEM_TO_DEV;
>                 host->dma_cfg_tx.src_addr = 0;
>                 host->dma_cfg_tx.dst_addr = host->phys_addr + SDDATA;
>
>                 host->dma_cfg_rx.src_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
>                 host->dma_cfg_rx.dst_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
> -               host->dma_cfg_rx.slave_id = 13;         /* DREQ channel */
>                 host->dma_cfg_rx.direction = DMA_DEV_TO_MEM;
>                 host->dma_cfg_rx.src_addr = host->phys_addr + SDDATA;
>                 host->dma_cfg_rx.dst_addr = 0;
> --
> 2.29.2
>