From: Sibi Sankar <sibis@codeaurora.org>
To: Stephen Boyd <swboyd@chromium.org>
Cc: bjorn.andersson@linaro.org, mka@chromium.org, robh+dt@kernel.org,
saiprakash.ranjan@codeaurora.org, will@kernel.org,
ohad@wizery.com, agross@kernel.org, mathieu.poirier@linaro.org,
robin.murphy@arm.com, joro@8bytes.org, p.zabel@pengutronix.de,
linux-arm-msm@vger.kernel.org, linux-remoteproc@vger.kernel.org,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-arm-kernel@lists.infradead.org, evgreen@chromium.org,
dianders@chromium.org
Subject: Re: [PATCH v2 10/10] arm64: dts: qcom: sc7280: Update Q6V5 MSS node
Date: Wed, 21 Jul 2021 22:46:14 +0530 [thread overview]
Message-ID: <a021012616af266905099e0563d0fff5@codeaurora.org> (raw)
In-Reply-To: <CAE-0n53bRGouiycpcukPYB_+Gyz_Dr=rCAnb2MH64=+Q899aOA@mail.gmail.com>
On 2021-07-21 11:17, Stephen Boyd wrote:
> Quoting Sibi Sankar (2021-07-20 03:13:00)
>> Update MSS node to support MSA based modem boot on SC7280 SoCs.
>>
>> Signed-off-by: Sibi Sankar <sibis@codeaurora.org>
>> ---
>> arch/arm64/boot/dts/qcom/sc7280-idp.dts | 7 +++++++
>> arch/arm64/boot/dts/qcom/sc7280.dtsi | 19 ++++++++++++++++---
>> 2 files changed, 23 insertions(+), 3 deletions(-)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/sc7280-idp.dts
>> b/arch/arm64/boot/dts/qcom/sc7280-idp.dts
>> index 191e8a92d153..d66e3ca42ad5 100644
>> --- a/arch/arm64/boot/dts/qcom/sc7280-idp.dts
>> +++ b/arch/arm64/boot/dts/qcom/sc7280-idp.dts
>> @@ -343,3 +343,10 @@
>> bias-pull-up;
>> };
>> };
>> +
>> +&remoteproc_mpss {
>> + status = "okay";
>> + compatible = "qcom,sc7280-mss-pil";
>> + iommus = <&apps_smmu 0x124 0x0>, <&apps_smmu 0x488 0x7>;
>> + memory-region = <&mba_mem &mpss_mem>;
>> +};
>
> Can this go above the pinctrl zone in this file? Preferably sorted
> alphabetically by phandle.
Sure, looks like I just added
it based on sort order. Didn't
notice that it fell below the
pinctrl zone.
>
>> diff --git a/arch/arm64/boot/dts/qcom/sc7280.dtsi
>> b/arch/arm64/boot/dts/qcom/sc7280.dtsi
>> index 56ea172f641f..6d3687744440 100644
>> --- a/arch/arm64/boot/dts/qcom/sc7280.dtsi
>> +++ b/arch/arm64/boot/dts/qcom/sc7280.dtsi
>> @@ -586,7 +586,8 @@
>>
>> remoteproc_mpss: remoteproc@4080000 {
>> compatible = "qcom,sc7280-mpss-pas";
>> - reg = <0 0x04080000 0 0x10000>;
>> + reg = <0 0x04080000 0 0x10000>, <0 0x04180000
>> 0 0x48>;
>> + reg-names = "qdsp6", "rmb";
>>
>> interrupts-extended = <&intc GIC_SPI 264
>> IRQ_TYPE_EDGE_RISING>,
>> <&modem_smp2p_in 0
>> IRQ_TYPE_EDGE_RISING>,
>> @@ -597,8 +598,11 @@
>> interrupt-names = "wdog", "fatal", "ready",
>> "handover",
>> "stop-ack", "shutdown-ack";
>>
>> - clocks = <&rpmhcc RPMH_CXO_CLK>;
>> - clock-names = "xo";
>> + clocks = <&gcc GCC_MSS_CFG_AHB_CLK>,
>> + <&gcc GCC_MSS_OFFLINE_AXI_CLK>,
>> + <&gcc GCC_MSS_SNOC_AXI_CLK>,
>> + <&rpmhcc RPMH_CXO_CLK>;
>> + clock-names = "iface", "offline", "snoc_axi",
>> "xo";
>>
>> power-domains = <&rpmhpd SC7280_CX>,
>> <&rpmhpd SC7280_MSS>;
>> @@ -611,6 +615,15 @@
>> qcom,smem-states = <&modem_smp2p_out 0>;
>> qcom,smem-state-names = "stop";
>>
>> + resets = <&aoss_reset AOSS_CC_MSS_RESTART>,
>> + <&pdc_reset PDC_MODEM_SYNC_RESET>;
>> + reset-names = "mss_restart", "pdc_reset";
>> +
>> + qcom,halt-regs = <&tcsr_mutex 0x23000 0x25000
>> 0x28000 0x33000>;
>> + qcom,ext-regs = <&tcsr_regs 0x10000 0x10004
>> + &tcsr_mutex 0x26004 0x26008>;
>> + qcom,qaccept-regs = <&tcsr_mutex 0x23030
>> 0x23040 0x23020>;
>> +
>> status = "disabled";
>>
>> glink-edge {
>
> Any reason to not combine this stuff with the previous patch?
I split it into two separate
patches just to show that sc7280
supports two ways of bringing
modem out of reset and method
used is determined by the platform.
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project.
next prev parent reply other threads:[~2021-07-21 17:16 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-07-20 10:12 [PATCH v2 00/10] Add Modem support on SC7280 SoCs Sibi Sankar
2021-07-20 10:12 ` [PATCH v2 01/10] dt-bindings: remoteproc: qcom: pas: Add SC7280 MPSS support Sibi Sankar
2021-07-20 10:12 ` [PATCH v2 02/10] remoteproc: qcom: pas: Add SC7280 Modem support Sibi Sankar
2021-07-20 10:12 ` [PATCH v2 03/10] dt-bindings: remoteproc: qcom: Update Q6V5 Modem PIL binding Sibi Sankar
2021-07-21 5:39 ` Stephen Boyd
2021-07-21 17:04 ` Sibi Sankar
2021-07-20 10:12 ` [PATCH v2 04/10] iommu/arm-smmu-qcom: Request direct mapping for modem device Sibi Sankar
2021-07-21 5:39 ` Stephen Boyd
2021-07-20 10:12 ` [PATCH v2 05/10] remoteproc: mss: q6v5-mss: Add modem support on SC7280 Sibi Sankar
2021-07-20 10:12 ` [PATCH v2 06/10] arm64: dts: qcom: sc7280: Update reserved memory map Sibi Sankar
2021-07-21 5:42 ` Stephen Boyd
2021-07-20 10:12 ` [PATCH v2 07/10] arm64: dts: qcom: sc7280: Add/Delete/Update reserved memory nodes Sibi Sankar
2021-07-21 5:43 ` Stephen Boyd
2021-07-20 10:12 ` [PATCH v2 08/10] arm64: dts: qcom: sc7280: Add nodes to boot modem Sibi Sankar
2021-07-21 5:44 ` Stephen Boyd
2021-07-21 17:41 ` Sibi Sankar
2021-07-20 10:12 ` [PATCH v2 09/10] arm64: dts: qcom: sc7280: Add Q6V5 MSS node Sibi Sankar
2021-07-21 5:45 ` Stephen Boyd
2021-07-20 10:13 ` [PATCH v2 10/10] arm64: dts: qcom: sc7280: Update " Sibi Sankar
2021-07-21 5:47 ` Stephen Boyd
2021-07-21 17:16 ` Sibi Sankar [this message]
2021-07-21 22:53 ` Stephen Boyd
2021-07-22 17:34 ` Sibi Sankar
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=a021012616af266905099e0563d0fff5@codeaurora.org \
--to=sibis@codeaurora.org \
--cc=agross@kernel.org \
--cc=bjorn.andersson@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=dianders@chromium.org \
--cc=evgreen@chromium.org \
--cc=joro@8bytes.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-remoteproc@vger.kernel.org \
--cc=mathieu.poirier@linaro.org \
--cc=mka@chromium.org \
--cc=ohad@wizery.com \
--cc=p.zabel@pengutronix.de \
--cc=robh+dt@kernel.org \
--cc=robin.murphy@arm.com \
--cc=saiprakash.ranjan@codeaurora.org \
--cc=swboyd@chromium.org \
--cc=will@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).