Re: [PATCH 3/3] arm64: allwinner: a64: enable Bluetooth On Pinebook

[Vasily Khoruzhick <anarsoul@gmail.com>]

On Mon, Jul 6, 2020 at 4:47 AM Maxime Ripard <maxime@cerno.tech> wrote:
>
> Hi,
>
> On Sun, Jul 05, 2020 at 12:51:10PM -0700, Vasily Khoruzhick wrote:
> > Pinebook has an RTL8723CS WiFi + BT chip, BT is connected to UART1
> > and uses PL5 as device wake GPIO, PL6 as host wake GPIO the I2C
> > controlling signals are connected to R_I2C bus.
> >
> > Enable it in the device tree.
> >
> > Signed-off-by: Vasily Khoruzhick <anarsoul@gmail.com>
> > ---
> >  .../arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts | 12 ++++++++++++
> >  1 file changed, 12 insertions(+)
> >
> > diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> > index 64b1c54f87c0..e63ff271be4e 100644
> > --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> > +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> > @@ -408,6 +408,18 @@ &uart0 {
> >       status = "okay";
> >  };
> >
> > +&uart1 {
> > +     pinctrl-names = "default";
> > +     pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
> > +     status = "okay";
>
> You probably need uart-has-rtscts here

Will add in v2

> > +
> > +     bluetooth {
> > +             compatible = "realtek,rtl8723cs-bt";
> > +             device-wake-gpios = <&r_pio 0 5 GPIO_ACTIVE_LOW>; /* PL5 */
> > +             host-wake-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
> > +     };
>
> And max-speed I guess?

There's no max-speed in the schema for this bluetooth controller.
Moreover it reads uart settings from firmware config. See
btrtl_get_uart_settings() in drivers/bluetooth/btrtl.c

> Maxime
> >