Linux-Bluetooth Archive on lore.kernel.org
 help / color / Atom feed
* [RFC Bluez PATCH 0/3] adapter: Reconnect audio when resuming from suspend
@ 2020-07-29  1:55 Abhishek Pandit-Subedi
  2020-07-29  1:55 ` [RFC Bluez PATCH 1/3] mgmt: Add controller suspend and resume events Abhishek Pandit-Subedi
                   ` (3 more replies)
  0 siblings, 4 replies; 8+ messages in thread
From: Abhishek Pandit-Subedi @ 2020-07-29  1:55 UTC (permalink / raw)
  To: luiz.dentz, marcel
  Cc: chromeos-bluetooth-upstreaming, linux-bluetooth, Abhishek Pandit-Subedi


Hi Luiz and Marcel,

This is a quality of life improvement for the behavior of audio devices
during system suspend. This depends on a kernel change that emits
suspend/resume events:

https://patchwork.kernel.org/project/bluetooth/list/?series=325771

Right now, audio devices will be disconnected as part of suspend but
won't be reconnected when the system resumes without user interaction.
This is annoying to some users as it causes an interruption to their
normal work flow.

This change reconnects audio devices that were disconnected for suspend
using the following logic:

 * In the Device Disconnected management event, if the disconnect reason
   was 0x5 (Disconnected by Local Host for Suspend) and the device is an
   audio sink (implements major services Audio + Rendering), then it is
   queued for reconnect.
 * When the Controller Resumed management event is seen, we check if
   an audio device needs to be reconnected. If yes, we queue a delayed
   callback to do the reconnection. The delay is 5s by default and is
   meant to allow sufficient time for any Wi-Fi activity that may occur
   during resume (since Bluetooth connect may adversely affect that).

A reconnect is only attempted once after the controller resumes and the
delay between resume and reconnect is configurable via the
ReconnectAudioDelay key in the General settings. The 5s delay was chosen
arbitrarily and I think anywhere up to 10s is probably ok. A longer
delay is better to account for spurious wakeups and Wi-Fi reconnection
time (avoiding any co-ex issues) at the downside of reconnection speed.

Here are the tests I have done with this:
- Single suspend and verified the headphones reconnect
- Suspend stress test for 25 iterations and verify both Wi-Fi and
  Bluetooth audio reconnect on resume. (Ran with wake minimum time of
  10s)
- Suspend test with wake time < 5s to verify that BT reconnect isn't
  attempted. Ran 5 iterations with low wake time and then let it stay
  awake to confirm reconnect finally completed after 5s+ wake time.
- Suspend test with wake time between 3s - 6s. Ran with 5 iterations and
  verified it wasn't connected at the end. A connection attempt was
  made but not completed due to suspend. A reconnect attempt was not
  made afterwards, which is by design.

  Luiz@ Marcel@: Does this sound ok (give up after an attempt)?

I've tested this on a Pixelbook Go (AC-9260 controller) and HP
Chromebook 14a (RTL8822CE controller) with GID6B headset. I'm hoping to
test this with a few more headsets to make sure this is ok and I'm
looking for some early feedback.

Thanks
Abhishek



Abhishek Pandit-Subedi (3):
  mgmt: Add controller suspend and resume events
  monitor: Add btmon support for Suspend and Resume events
  adapter: Reconnect audio on controller resume

 lib/mgmt.h       | 14 +++++++++
 monitor/packet.c | 55 ++++++++++++++++++++++++++++++++
 src/adapter.c    | 82 ++++++++++++++++++++++++++++++++++++++++++++++++
 src/device.c     | 27 ++++++++++++++++
 src/device.h     |  2 ++
 src/main.conf    |  6 ++++
 6 files changed, 186 insertions(+)

-- 
2.28.0.rc0.142.g3c755180ce-goog


^ permalink raw reply	[flat|nested] 8+ messages in thread

end of thread, back to index

Thread overview: 8+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2020-07-29  1:55 [RFC Bluez PATCH 0/3] adapter: Reconnect audio when resuming from suspend Abhishek Pandit-Subedi
2020-07-29  1:55 ` [RFC Bluez PATCH 1/3] mgmt: Add controller suspend and resume events Abhishek Pandit-Subedi
2020-07-29  1:55 ` [RFC Bluez PATCH 2/3] monitor: Add btmon support for Suspend and Resume events Abhishek Pandit-Subedi
2020-07-29  1:55 ` [RFC Bluez PATCH 3/3] adapter: Reconnect audio on controller resume Abhishek Pandit-Subedi
2020-08-04 18:54   ` Luiz Augusto von Dentz
2020-08-06  3:48     ` Abhishek Pandit-Subedi
2020-08-06 17:20       ` Luiz Augusto von Dentz
2020-08-04 17:12 ` [RFC Bluez PATCH 0/3] adapter: Reconnect audio when resuming from suspend Abhishek Pandit-Subedi

Linux-Bluetooth Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-bluetooth/0 linux-bluetooth/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-bluetooth linux-bluetooth/ https://lore.kernel.org/linux-bluetooth \
		linux-bluetooth@vger.kernel.org
	public-inbox-index linux-bluetooth

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-bluetooth


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git