Re: [PATCH v2 6/7] spi: s3c64xx: restore removed comments

[Michael Turquette <mturquette@baylibre.com>]

Quoting Andi Shyti (2016-07-08 07:46:40)
> Patch a9e93e8 has erroneously removed some comments which are
> important to understand why the bus frequency is multiplied by
> two during the spi transfer.
> =

> Signed-off-by: Andi Shyti <andi.shyti@samsung.com>
> ---
>  drivers/spi/spi-s3c64xx.c | 1 +
>  1 file changed, 1 insertion(+)
> =

> diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
> index 6da663f..32b66f0 100644
> --- a/drivers/spi/spi-s3c64xx.c
> +++ b/drivers/spi/spi-s3c64xx.c
> @@ -639,6 +639,7 @@ static void s3c64xx_spi_config(struct s3c64xx_spi_dri=
ver_data *sdd)
>         writel(val, regs + S3C64XX_SPI_MODE_CFG);
>  =

>         if (sdd->port_conf->clk_from_cmu) {
> +               /* There is half-multiplier before the SPI */
>                 clk_set_rate(sdd->src_clk, sdd->cur_speed * 2);

Just a small comment, but if the fixed-factor divide-by-two clock was
modeled in Linux, then this driver could call clk_set_rate on that clock
with the "correct" rate.

I guess that this driver would be the provider of that clock?

Regards,
Mike

>         } else {
>                 /* Configure Clock */
> -- =

> 2.8.1
>=20