Linux-Clk Archive on lore.kernel.org
 help / color / Atom feed
From: Taniya Das <tdas@codeaurora.org>
To: "Stephen Boyd" <sboyd@kernel.org>,
	"Michael Turquette  " <mturquette@baylibre.com>
Cc: David Brown <david.brown@linaro.org>,
	Rajendra Nayak <rnayak@codeaurora.org>,
	linux-arm-msm@vger.kernel.org, linux-soc@vger.kernel.org,
	linux-clk@vger.kernel.org, linux-kernel@vger.kernel.org,
	Andy Gross <agross@kernel.org>,
	devicetree@vger.kernel.org, robh@kernel.org, robh+dt@kernel.org,
	Taniya Das <tdas@codeaurora.org>
Subject: [PATCH v1 1/7] clk: qcom: clk-alpha-pll: Add support for Fabia PLL calibration
Date: Thu, 31 Oct 2019 17:51:07 +0530
Message-ID: <1572524473-19344-2-git-send-email-tdas@codeaurora.org> (raw)
In-Reply-To: <1572524473-19344-1-git-send-email-tdas@codeaurora.org>

In the cases where the PLL is not calibrated the PLL could fail to lock.
Add support for prepare ops which would take care of the same.

Fabia PLL user/test control registers might required to be configured, so
add support for configuring them.

Signed-off-by: Taniya Das <tdas@codeaurora.org>
---
 drivers/clk/qcom/clk-alpha-pll.c | 84 +++++++++++++++++++++++++++++++++++++---
 drivers/clk/qcom/clk-alpha-pll.h |  4 ++
 2 files changed, 83 insertions(+), 5 deletions(-)

diff --git a/drivers/clk/qcom/clk-alpha-pll.c b/drivers/clk/qcom/clk-alpha-pll.c
index 055318f..8cb77ca 100644
--- a/drivers/clk/qcom/clk-alpha-pll.c
+++ b/drivers/clk/qcom/clk-alpha-pll.c
@@ -1024,6 +1024,25 @@ void clk_fabia_pll_configure(struct clk_alpha_pll *pll, struct regmap *regmap,
 		regmap_write(regmap, PLL_CONFIG_CTL(pll),
 						config->config_ctl_val);

+	if (config->config_ctl_hi_val)
+		regmap_write(regmap, PLL_CONFIG_CTL_U(pll),
+						config->config_ctl_hi_val);
+
+	if (config->user_ctl_val)
+		regmap_write(regmap, PLL_USER_CTL(pll), config->user_ctl_val);
+
+	if (config->user_ctl_hi_val)
+		regmap_write(regmap, PLL_USER_CTL_U(pll),
+						config->user_ctl_hi_val);
+
+	if (config->test_ctl_val)
+		regmap_write(regmap, PLL_TEST_CTL(pll),
+						config->test_ctl_val);
+
+	if (config->test_ctl_hi_val)
+		regmap_write(regmap, PLL_TEST_CTL_U(pll),
+						config->test_ctl_hi_val);
+
 	if (config->post_div_mask) {
 		mask = config->post_div_mask;
 		val = config->post_div_val;
@@ -1141,15 +1160,11 @@ static int alpha_pll_fabia_set_rate(struct clk_hw *hw, unsigned long rate,
 						unsigned long prate)
 {
 	struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
-	u32 val, l, alpha_width = pll_alpha_width(pll);
+	u32 l, alpha_width = pll_alpha_width(pll);
 	u64 a;
 	unsigned long rrate;
 	int ret = 0;

-	ret = regmap_read(pll->clkr.regmap, PLL_MODE(pll), &val);
-	if (ret)
-		return ret;
-
 	rrate = alpha_pll_round_rate(rate, prate, &l, &a, alpha_width);

 	/*
@@ -1167,7 +1182,66 @@ static int alpha_pll_fabia_set_rate(struct clk_hw *hw, unsigned long rate,
 	return __clk_alpha_pll_update_latch(pll);
 }

+static int alpha_pll_fabia_prepare(struct clk_hw *hw)
+{
+	struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
+	const struct pll_vco *vco;
+	struct clk_hw *parent_hw;
+	unsigned long cal_freq, rrate;
+	u32 cal_l, regval, alpha_width = pll_alpha_width(pll);
+	u64 a;
+	int ret;
+
+	/* Check if calibration needs to be done i.e. PLL is in reset */
+	ret = regmap_read(pll->clkr.regmap, PLL_MODE(pll), &regval);
+	if (ret)
+		return ret;
+
+	/* Return early if calibration is not needed. */
+	if (regval & PLL_RESET_N)
+		return 0;
+
+	vco = alpha_pll_find_vco(pll, clk_hw_get_rate(hw));
+	if (!vco) {
+		pr_err("alpha pll: not in a valid vco range\n");
+		return -EINVAL;
+	}
+
+	cal_freq = DIV_ROUND_CLOSEST((pll->vco_table[0].min_freq +
+				pll->vco_table[0].max_freq) * 54, 100);
+
+	parent_hw = clk_hw_get_parent(hw);
+	if (!parent_hw)
+		return -EINVAL;
+
+	rrate = alpha_pll_round_rate(cal_freq, clk_hw_get_rate(parent_hw),
+					&cal_l, &a, alpha_width);
+	/*
+	 * Due to a limited number of bits for fractional rate programming, the
+	 * rounded up rate could be marginally higher than the requested rate.
+	 */
+	if (rrate > (cal_freq + FABIA_PLL_RATE_MARGIN) || rrate < cal_freq) {
+		pr_err("Call set rate on the PLL with rounded rates!\n");
+		return -EINVAL;
+	}
+
+	/* Setup PLL for calibration frequency */
+	regmap_write(pll->clkr.regmap, PLL_ALPHA_VAL(pll), cal_l);
+
+	/* Bringup the pll at calibration frequency */
+	ret = clk_alpha_pll_enable(hw);
+	if (ret) {
+		pr_err("alpha pll calibration failed\n");
+		return ret;
+	}
+
+	clk_alpha_pll_disable(hw);
+
+	return 0;
+}
+
 const struct clk_ops clk_alpha_pll_fabia_ops = {
+	.prepare = alpha_pll_fabia_prepare,
 	.enable = alpha_pll_fabia_enable,
 	.disable = alpha_pll_fabia_disable,
 	.is_enabled = clk_alpha_pll_is_enabled,
diff --git a/drivers/clk/qcom/clk-alpha-pll.h b/drivers/clk/qcom/clk-alpha-pll.h
index 15f27f4..b03eea0 100644
--- a/drivers/clk/qcom/clk-alpha-pll.h
+++ b/drivers/clk/qcom/clk-alpha-pll.h
@@ -94,6 +94,10 @@ struct alpha_pll_config {
 	u32 alpha_hi;
 	u32 config_ctl_val;
 	u32 config_ctl_hi_val;
+	u32 user_ctl_val;
+	u32 user_ctl_hi_val;
+	u32 test_ctl_val;
+	u32 test_ctl_hi_val;
 	u32 main_output_mask;
 	u32 aux_output_mask;
 	u32 aux2_output_mask;
--
Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc.is a member
of the Code Aurora Forum, hosted by the  Linux Foundation.


  reply index

Thread overview: 23+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-10-31 12:21 [PATCH v1 0/7] Add GPU & Video Clock controller driver for SC7180 Taniya Das
2019-10-31 12:21 ` Taniya Das [this message]
2019-11-06  0:36   ` [PATCH v1 1/7] clk: qcom: clk-alpha-pll: Add support for Fabia PLL calibration Stephen Boyd
2019-11-15  8:11     ` Taniya Das
2019-11-07  4:24   ` Doug Anderson
2019-11-15  8:11     ` Taniya Das
2019-10-31 12:21 ` [PATCH v1 2/7] dt-bindings: clock: Add YAML schemas for the QCOM GPUCC clock bindings Taniya Das
2019-11-06  0:26   ` Stephen Boyd
2019-11-06  3:18     ` Rob Herring
2019-10-31 12:21 ` [PATCH v1 3/7] dt-bindings: clock: Introduce QCOM Graphics " Taniya Das
2019-11-06  3:59   ` Rob Herring
2019-10-31 12:21 ` [PATCH v1 4/7] clk: qcom: Add graphics clock controller driver for SC7180 Taniya Das
2019-11-06  0:30   ` Stephen Boyd
2019-11-15  8:11     ` Taniya Das
2019-11-16  5:50       ` Stephen Boyd
2019-10-31 12:21 ` [PATCH v1 5/7] dt-bindings: clock: Add YAML schemas for the QCOM VIDEOCC clock bindings Taniya Das
2019-11-06  4:00   ` Rob Herring
2019-10-31 12:21 ` [PATCH v1 6/7] dt-bindings: clock: Introduce QCOM Video " Taniya Das
2019-11-06  0:37   ` Stephen Boyd
2019-10-31 12:21 ` [PATCH v1 7/7] clk: qcom: Add video clock controller driver for SC7180 Taniya Das
2019-11-06  0:39   ` Stephen Boyd
2019-11-15  8:11     ` Taniya Das
2019-11-16  5:51       ` Stephen Boyd

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1572524473-19344-2-git-send-email-tdas@codeaurora.org \
    --to=tdas@codeaurora.org \
    --cc=agross@kernel.org \
    --cc=david.brown@linaro.org \
    --cc=devicetree@vger.kernel.org \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-soc@vger.kernel.org \
    --cc=mturquette@baylibre.com \
    --cc=rnayak@codeaurora.org \
    --cc=robh+dt@kernel.org \
    --cc=robh@kernel.org \
    --cc=sboyd@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-Clk Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-clk/0 linux-clk/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-clk linux-clk/ https://lore.kernel.org/linux-clk \
		linux-clk@vger.kernel.org
	public-inbox-index linux-clk

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-clk


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git