Re: [PATCH 00/11] clk: ti: clkctrl data split based on clkdm boundaries

From: Tony Lindgren <tony@atomide.com>
To: Tero Kristo <t-kristo@ti.com>
Cc: linux-clk@vger.kernel.org, sboyd@kernel.org,
	mturquette@baylibre.com, linux-omap@vger.kernel.org
Subject: Re: [PATCH 00/11] clk: ti: clkctrl data split based on clkdm boundaries
Date: Tue, 4 Sep 2018 08:36:57 -0700	[thread overview]
Message-ID: <20180904153657.GB5662@atomide.com> (raw)
In-Reply-To: <1535728027-24573-1-git-send-email-t-kristo@ti.com>

* Tero Kristo <t-kristo@ti.com> [180831 15:11]:
> Hi,
> 
> This series splits up the clkctrl data for TI SoCs based on clockdomain
> boundaries, instead of the current CM boundaries. For rest of the SoCs,
> the CM boundaries are actually the same as clockdomains, only am3/am4/dra7
> are mutants.
> 
> This is done in preparation for better supporting Tony's upcoming
> interconnect driver data introduction for these SoCs.
> 
> One thing to note is that we maintain backwards compatibility with this
> series, the compat data is introduced temporarily for this purpose. The
> compat data can be ditched after couple of release cycles when nobody
> needs it anymore.
> 
> The series can be applied independently, as the compat data support
> makes care that the switch is only done once DT changes are in place.

When this is ready for merging, can you guys please set up an
immutable branch against v4.19-rc1 with the drivers/clk changes
for me to merge in too?

I've tested this on am335x and am437x so far and it works fine
for me, so for the whole series:

Tested-by: Tony Lindgren <tony@atomide.com>