From: "Vaittinen, Matti" <Matti.Vaittinen@fi.rohmeurope.com>
To: "linus.walleij@linaro.org" <linus.walleij@linaro.org>
Cc: "linux-leds@vger.kernel.org" <linux-leds@vger.kernel.org>,
"dmurphy@ti.com" <dmurphy@ti.com>,
"linux-rtc@vger.kernel.org" <linux-rtc@vger.kernel.org>,
"linux-gpio@vger.kernel.org" <linux-gpio@vger.kernel.org>,
"alexandre.belloni@bootlin.com" <alexandre.belloni@bootlin.com>,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
"mturquette@baylibre.com" <mturquette@baylibre.com>,
"lgirdwood@gmail.com" <lgirdwood@gmail.com>,
"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
"mazziesaccount@gmail.com" <mazziesaccount@gmail.com>,
"a.zummo@towertech.it" <a.zummo@towertech.it>,
"jacek.anaszewski@gmail.com" <jacek.anaszewski@gmail.com>,
"mark.rutland@arm.com" <mark.rutland@arm.com>,
"robh+dt@kernel.org" <robh+dt@kernel.org>,
"bgolaszewski@baylibre.com" <bgolaszewski@baylibre.com>,
"linux-clk@vger.kernel.org" <linux-clk@vger.kernel.org>,
"sboyd@kernel.org" <sboyd@kernel.org>,
"lee.jones@linaro.org" <lee.jones@linaro.org>,
"broonie@kernel.org" <broonie@kernel.org>,
"pavel@ucw.cz" <pavel@ucw.cz>
Subject: Re: [RFC PATCH v3 14/15] gpio: Add definition for GPIO direction
Date: Mon, 4 Nov 2019 15:48:17 +0000
Message-ID: <411ac5e107cd2a6c628d1fb46e7d284c8f594768.camel@fi.rohmeurope.com> (raw)
In-Reply-To: <CACRpkdYhasTEQq2btQ_3GSo=hMJetp128jFo-6hE=JMeX4MJSA@mail.gmail.com>
Hello All,
On Sun, 2019-11-03 at 23:30 +0100, Linus Walleij wrote:
> Hi Matti!
>
> Good initiative (and I will see a ton of janitorial patches as a
> result of this...)
I have somewhere near 62 patches waiting to be sent =) They're pretty
small but I'd appreciate thorough review as they're mostly untested...
Do you mind receiving them all in one go? Or do you think I should send
the series in smaller chuncks?
> On Fri, Nov 1, 2019 at 12:50 PM Matti Vaittinen
> <matti.vaittinen@fi.rohmeurope.com> wrote:
>
> > At least for me it is difficult to remember the meaning of GPIO
> > direction values. Define GPIO_IN and GPIO_OUT so that occasional
> > GPIO contributors would not need to always check the meaning of
> > hard coded values 1 and 0.
> >
> > Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
> (...)
> > +#define GPIO_IN 1
> > +#define GPIO_OUT 0
>
> Please spell it out or people will be confused:
>
> GPIO_LINE_DIRECTION_IN
> GPIO_LINE_DIRECTION_OUT
>
> Yours,
> Linus Walleij
next prev parent reply index
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-11-01 11:28 [RFC PATCH v3 00/15] Support ROHM BD71828 PMIC Matti Vaittinen
2019-11-01 11:29 ` [RFC PATCH v3 01/15] mfd: bd71828: Support ROHM BD71828 PMIC - core Matti Vaittinen
2019-11-11 10:57 ` Lee Jones
2019-11-11 11:20 ` Vaittinen, Matti
2019-11-01 11:31 ` [RFC PATCH v3 02/15] dt-bindings: mfd: Document ROHM BD71828 bindings Matti Vaittinen
2019-11-05 20:43 ` Rob Herring
2019-11-06 12:55 ` SPAM (R/EU IT) // " Vaittinen, Matti
2019-11-01 11:31 ` [RFC PATCH v3 03/15] dt-bindings: regulator: Document ROHM BD71282 regulator bindings Matti Vaittinen
2019-11-05 20:52 ` Rob Herring
2019-11-07 6:50 ` SPAM (R/EU IT) // " Vaittinen, Matti
2019-11-01 11:32 ` [RFC PATCH v3 04/15] dt-bindings: leds: ROHM BD71282 PMIC LED driver Matti Vaittinen
2019-11-05 19:14 ` Dan Murphy
2019-11-05 20:59 ` Rob Herring
2019-11-06 13:05 ` Vaittinen, Matti
2019-11-05 20:57 ` Rob Herring
2019-11-01 11:33 ` [RFC PATCH v3 05/15] mfd: input: bd71828: Add power-key support Matti Vaittinen
2019-11-11 10:59 ` Lee Jones
2019-11-11 11:07 ` Vaittinen, Matti
2019-11-01 11:38 ` [RFC PATCH v3 06/15] clk: bd718x7: Support ROHM BD71828 clk block Matti Vaittinen
2019-11-01 11:39 ` [RFC PATCH v3 07/15] clk: bd718x7: simplify header dependencies Matti Vaittinen
2019-11-01 11:41 ` [RFC PATCH v3 08/15] regulator: bd718x7: Split driver to common and bd718x7 specific parts Matti Vaittinen
2019-11-01 11:42 ` [RFC PATCH v3 09/15] regulator: bd71828: Basic support for ROHM bd71828 PMIC regulators Matti Vaittinen
2019-11-01 11:43 ` [RFC PATCH v3 10/15] regulator: bd71828: Add GPIO based run-level control for regulators Matti Vaittinen
2019-11-03 22:27 ` Linus Walleij
2019-11-04 7:05 ` Vaittinen, Matti
2019-11-05 13:24 ` Linus Walleij
2019-11-05 14:07 ` Vaittinen, Matti
2019-11-01 11:44 ` [RFC PATCH v3 11/15] regulator: bd71828: enhanced run-level support Matti Vaittinen
2019-11-01 11:45 ` [RFC PATCH v3 12/15] regulator: bd71828: Support in-kernel APIs to change run-level Matti Vaittinen
2019-11-01 11:49 ` [RFC PATCH v3 13/15] rtc: bd70528 add BD71828 support Matti Vaittinen
2019-11-01 11:49 ` [RFC PATCH v3 14/15] gpio: Add definition for GPIO direction Matti Vaittinen
2019-11-03 22:30 ` Linus Walleij
2019-11-04 6:57 ` Vaittinen, Matti
2019-11-04 15:48 ` Vaittinen, Matti [this message]
2019-11-05 15:05 ` Linus Walleij
2019-11-06 6:51 ` Vaittinen, Matti
2019-11-01 11:51 ` [RFC PATCH v3 15/15] gpio: bd71828: Initial support for ROHM BD71828 PMIC GPIOs Matti Vaittinen
2019-11-01 11:53 ` [RFC PATCH v3 00/15] Support ROHM BD71828 PMIC Vaittinen, Matti
Reply instructions:
You may reply publically to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=411ac5e107cd2a6c628d1fb46e7d284c8f594768.camel@fi.rohmeurope.com \
--to=matti.vaittinen@fi.rohmeurope.com \
--cc=a.zummo@towertech.it \
--cc=alexandre.belloni@bootlin.com \
--cc=bgolaszewski@baylibre.com \
--cc=broonie@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=dmurphy@ti.com \
--cc=jacek.anaszewski@gmail.com \
--cc=lee.jones@linaro.org \
--cc=lgirdwood@gmail.com \
--cc=linus.walleij@linaro.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-leds@vger.kernel.org \
--cc=linux-rtc@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=mazziesaccount@gmail.com \
--cc=mturquette@baylibre.com \
--cc=pavel@ucw.cz \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Linux-Clk Archive on lore.kernel.org
Archives are clonable:
git clone --mirror https://lore.kernel.org/linux-clk/0 linux-clk/git/0.git
# If you have public-inbox 1.1+ installed, you may
# initialize and index your mirror using the following commands:
public-inbox-init -V2 linux-clk linux-clk/ https://lore.kernel.org/linux-clk \
linux-clk@vger.kernel.org
public-inbox-index linux-clk
Example config snippet for mirrors
Newsgroup available over NNTP:
nntp://nntp.lore.kernel.org/org.kernel.vger.linux-clk
AGPL code for this site: git clone https://public-inbox.org/public-inbox.git