From: Chen-Yu Tsai <wens-jdAy2FN1RRM@public.gmane.org>
To: Mark Brown <broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
Lee Jones <lee.jones-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org>,
Alessandro Zummo
<a.zummo-BfzFCNDTiLLj+vYz1yj4TQ@public.gmane.org>,
Alexandre Belloni
<alexandre.belloni-wi1+55ScJUtKEb57/3fJTNBPR1lH4CV8@public.gmane.org>,
Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
Pawel Moll <pawel.moll-5wv7dgnIgG8@public.gmane.org>,
Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>,
Ian Campbell
<ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org>,
Kumar Gala <galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>,
Maxime Ripard
<maxime.ripard-wi1+55ScJUtKEb57/3fJTNBPR1lH4CV8@public.gmane.org>,
Michael Turquette
<mturquette-rdvid1DuHRBWk0Htik3J/w@public.gmane.org>,
Stephen Boyd <sboyd-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
Cc: Chen-Yu Tsai <wens-jdAy2FN1RRM@public.gmane.org>,
rtc-linux-/JYPxA39Uh5TLH3MbocFFw@public.gmane.org,
linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org,
linux-clk-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
Subject: [PATCH v2 02/10] mfd: ac100: Add device tree bindings for X-Powers AC100 codec/RTC combo IC
Date: Wed, 15 Jun 2016 18:27:39 +0800 [thread overview]
Message-ID: <1465986467-14802-3-git-send-email-wens@csie.org> (raw)
In-Reply-To: <1465986467-14802-1-git-send-email-wens-jdAy2FN1RRM@public.gmane.org>
Signed-off-by: Chen-Yu Tsai <wens-jdAy2FN1RRM@public.gmane.org>
---
Documentation/devicetree/bindings/mfd/ac100.txt | 42 +++++++++++++++++++++++++
1 file changed, 42 insertions(+)
create mode 100644 Documentation/devicetree/bindings/mfd/ac100.txt
diff --git a/Documentation/devicetree/bindings/mfd/ac100.txt b/Documentation/devicetree/bindings/mfd/ac100.txt
new file mode 100644
index 000000000000..fbab623e6fba
--- /dev/null
+++ b/Documentation/devicetree/bindings/mfd/ac100.txt
@@ -0,0 +1,42 @@
+X-Powers AC100 Codec/RTC IC device tree bindings
+
+AC100 is a audio codec and RTC subsystem combo IC. The 2 parts are
+separated, including power supplies and interrupt lines, but share
+a common register address space and host interface.
+
+Required properties:
+- compatible: "x-powers,ac100"
+- reg: The I2C slave address or RSB hardware address for the chip
+- sub-nodes:
+ - codec
+ - compatible: "x-powers,ac100-codec"
+ - interrupt-parent: The parent interrupt controller
+ - interrupts: SoC NMI / GPIO interrupt connected to the IRQ_AUDIO pin
+ - rtc
+ - compatible: "x-powers,ac100-rtc"
+ - interrupt-parent: The parent interrupt controller
+ - interrupts: SoC NMI / GPIO interrupt connected to the IRQ_RTC pin
+ - #clock-cells: shall be 1
+ - clock-output-names: "cko1_rtc", "cko2_rtc", "cko3_rtc"
+ - see clock/clock-bindings.txt for common clock bindings
+
+Example:
+
+ac100: codec@e89 {
+ compatible = "x-powers,ac100";
+ reg = <0xe89>;
+
+ ac100_codec {
+ compatible = "x-powers,ac100-codec";
+ interrupt-parent = <&nmi_intc>;
+ interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+ };
+
+ ac100_rtc {
+ compatible = "x-powers,ac100-rtc";
+ interrupt-parent = <&nmi_intc>;
+ interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
+ #clock-cells = <1>;
+ clock-output-names = "cko1_rtc", "cko2_rtc", "cko3_rtc";
+ };
+};
--
2.8.1
--
You received this message because you are subscribed to "rtc-linux".
Membership options at http://groups.google.com/group/rtc-linux .
Please read http://groups.google.com/group/rtc-linux/web/checklist
before submitting a driver.
---
You received this message because you are subscribed to the Google Groups "rtc-linux" group.
To unsubscribe from this group and stop receiving emails from it, send an email to rtc-linux+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/Ez6ZCGd0@public.gmane.org
For more options, visit https://groups.google.com/d/optout.
next prev parent reply other threads:[~2016-06-15 10:27 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-06-15 10:27 [PATCH v2 00/10] mfd: ac100: Add support for X-Powers AC100 audio codec / RTC combo IC Chen-Yu Tsai
2016-06-15 10:27 ` [PATCH v2 01/10] regmap: Support bulk writes for devices without raw formatting Chen-Yu Tsai
[not found] ` <1465986467-14802-1-git-send-email-wens-jdAy2FN1RRM@public.gmane.org>
2016-06-15 10:27 ` Chen-Yu Tsai [this message]
[not found] ` <1465986467-14802-3-git-send-email-wens-jdAy2FN1RRM@public.gmane.org>
2016-06-15 12:49 ` [PATCH v2 02/10] mfd: ac100: Add device tree bindings for X-Powers AC100 codec/RTC combo IC Lee Jones
2016-06-15 13:17 ` Chen-Yu Tsai
2016-06-19 14:34 ` Rob Herring
2016-06-15 10:27 ` [PATCH v2 03/10] mfd: ac100: Add driver for X-Powers AC100 audio codec / RTC " Chen-Yu Tsai
[not found] ` <1465986467-14802-4-git-send-email-wens-jdAy2FN1RRM@public.gmane.org>
2016-06-15 12:36 ` Lee Jones
2016-06-15 12:41 ` Chen-Yu Tsai
[not found] ` <CAGb2v669g6G4aK5UssyLLve1a-AbdVfo4CPYrt+YWmCUURz9qQ-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2016-06-16 10:32 ` Lee Jones
2016-06-15 10:27 ` [PATCH v2 04/10] rtc: ac100: Add RTC driver for X-Powers AC100 Chen-Yu Tsai
2016-06-15 10:27 ` [PATCH v2 05/10] rtc: ac100: Add clk output support Chen-Yu Tsai
2016-06-15 10:27 ` [PATCH v2 06/10] ARM: dts: sun9i: a80-optimus: Add device node for AC100 Chen-Yu Tsai
2016-06-15 10:27 ` [PATCH v2 07/10] ARM: dts: sun9i: cubieboard4: " Chen-Yu Tsai
2016-06-15 10:27 ` [PATCH v2 08/10] ARM: dts: sun9i: cubieboard4: Order nodes by alphabetical order Chen-Yu Tsai
[not found] ` <1465986467-14802-9-git-send-email-wens-jdAy2FN1RRM@public.gmane.org>
2016-06-16 8:14 ` Maxime Ripard
2016-06-15 10:27 ` [PATCH v2 09/10] ARM: dts: sun9i: a80-optimus: " Chen-Yu Tsai
[not found] ` <1465986467-14802-10-git-send-email-wens-jdAy2FN1RRM@public.gmane.org>
2016-06-16 8:14 ` Maxime Ripard
2016-06-15 10:27 ` [PATCH v2 10/10] ARM: dts: sun9i: Switch to the AC100 RTC clock outputs for osc32k Chen-Yu Tsai
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1465986467-14802-3-git-send-email-wens@csie.org \
--to=wens-jday2fn1rrm@public.gmane.org \
--cc=a.zummo-BfzFCNDTiLLj+vYz1yj4TQ@public.gmane.org \
--cc=alexandre.belloni-wi1+55ScJUtKEb57/3fJTNBPR1lH4CV8@public.gmane.org \
--cc=broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
--cc=ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org \
--cc=lee.jones-QSEj5FYQhm4dnm+yROfE0A@public.gmane.org \
--cc=linux-arm-kernel-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=linux-clk-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=maxime.ripard-wi1+55ScJUtKEb57/3fJTNBPR1lH4CV8@public.gmane.org \
--cc=mturquette-rdvid1DuHRBWk0Htik3J/w@public.gmane.org \
--cc=pawel.moll-5wv7dgnIgG8@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=rtc-linux-/JYPxA39Uh5TLH3MbocFFw@public.gmane.org \
--cc=sboyd-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).