devicetree.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Karthikeyan Ramasubramanian <kramasub@codeaurora.org>
To: linux-arm-msm@vger.kernel.org, linux-i2c@vger.kernel.org,
	linux-serial@vger.kernel.org
Cc: Karthikeyan Ramasubramanian <kramasub@codeaurora.org>,
	linux-doc@vger.kernel.org, devicetree@vger.kernel.org,
	andy.gross@linaro.org, david.brown@linaro.org,
	robh+dt@kernel.org, mark.rutland@arm.com, corbet@lwn.net,
	wsa@the-dreams.de, gregkh@linuxfoundation.org, jslaby@suse.com
Subject: [PATCH RFC 0/7] Introduce GENI SE Controller Driver
Date: Wed, 27 Dec 2017 09:27:19 -0700	[thread overview]
Message-ID: <1514392046-30602-1-git-send-email-kramasub@codeaurora.org> (raw)

Generic Interface (GENI) firmware based Qualcomm Universal Peripheral (QUP)
Wrapper is a next generation programmable module for supporting a wide
range of serial interfaces like UART, SPI, I2C, I3C, etc. A single QUP
module can provide upto 8 Serial Interfaces using its internal Serial
Engines (SE). The protocol supported by each interface is determined by
the firmware loaded to the Serial Engine.

This patch series introduces GENI SE Driver to manage the GENI based QUP
Wrapper and the common aspects of all SEs inside the QUP Wrapper. This
patch series also introduces the UART and I2C Controller drivers to
drive the SEs that are programmed with the respective protocols.

Karthikeyan Ramasubramanian (7):
  qcom-geni-se: Add QCOM GENI SE Driver summary
  soc: qcom: Add device tree binding for GENI SE
  soc: qcom: Add GENI based QUP Wrapper driver
  i2c: Add device tree bindings for GENI I2C Controller
  i2c: i2c-qcom-geni: Add bus driver for the Qualcomm GENI I2C
    controller
  serial: Add device tree bindings for GENI based UART Controller
  tty: serial: msm_geni_serial: Add serial driver support for GENI based
    QUP

 .../devicetree/bindings/i2c/i2c-qcom-geni.txt      |   39 +
 .../devicetree/bindings/serial/qcom,geni-uart.txt  |   31 +
 .../devicetree/bindings/soc/qcom/qcom,geni-se.txt  |   15 +
 Documentation/qcom-geni-se.txt                     |   56 +
 drivers/i2c/busses/Kconfig                         |   10 +
 drivers/i2c/busses/Makefile                        |    1 +
 drivers/i2c/busses/i2c-qcom-geni.c                 |  685 +++++++++
 drivers/soc/qcom/Kconfig                           |    8 +
 drivers/soc/qcom/Makefile                          |    1 +
 drivers/soc/qcom/qcom-geni-se.c                    |  973 +++++++++++++
 drivers/tty/serial/Kconfig                         |   10 +
 drivers/tty/serial/Makefile                        |    1 +
 drivers/tty/serial/qcom_geni_serial.c              | 1447 ++++++++++++++++++++
 include/linux/qcom-geni-se.h                       |  811 +++++++++++
 14 files changed, 4088 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/i2c/i2c-qcom-geni.txt
 create mode 100644 Documentation/devicetree/bindings/serial/qcom,geni-uart.txt
 create mode 100644 Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
 create mode 100644 Documentation/qcom-geni-se.txt
 create mode 100644 drivers/i2c/busses/i2c-qcom-geni.c
 create mode 100644 drivers/soc/qcom/qcom-geni-se.c
 create mode 100644 drivers/tty/serial/qcom_geni_serial.c
 create mode 100644 include/linux/qcom-geni-se.h

-- 
Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

             reply	other threads:[~2017-12-27 16:27 UTC|newest]

Thread overview: 20+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-12-27 16:27 Karthikeyan Ramasubramanian [this message]
2017-12-27 16:27 ` [PATCH RFC 1/7] qcom-geni-se: Add QCOM GENI SE Driver summary Karthikeyan Ramasubramanian
     [not found] ` <1514392046-30602-1-git-send-email-kramasub-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>
2017-12-27 16:27   ` [PATCH RFC 2/7] soc: qcom: Add device tree binding for GENI SE Karthikeyan Ramasubramanian
2018-01-02 15:46     ` Rob Herring
2018-01-08 23:57       ` Karthik Ramasubramanian
2018-01-02 15:47     ` Rob Herring
2018-01-08 23:59       ` Karthik Ramasubramanian
2017-12-27 16:27   ` [PATCH RFC 3/7] soc: qcom: Add GENI based QUP Wrapper driver Karthikeyan Ramasubramanian
2017-12-27 16:27   ` [PATCH RFC 5/7] i2c: i2c-qcom-geni: Add bus driver for the Qualcomm GENI I2C controller Karthikeyan Ramasubramanian
2017-12-27 16:27 ` [PATCH RFC 4/7] i2c: Add device tree bindings for GENI I2C Controller Karthikeyan Ramasubramanian
2018-01-02 15:51   ` Rob Herring
2018-01-09  0:33     ` Karthik Ramasubramanian
2018-01-11 15:19       ` Rob Herring
2018-01-12 21:35         ` Karthik Ramasubramanian
2017-12-27 16:27 ` [PATCH RFC 6/7] serial: Add device tree bindings for GENI based UART Controller Karthikeyan Ramasubramanian
2018-01-02 15:55   ` Rob Herring
2018-01-09 18:36     ` Karthik Ramasubramanian
2018-01-11 15:12       ` Rob Herring
     [not found]         ` <CAL_JsqL1=NAn1T_HaetO5hT+fdgxmkcNwtOr1+XaxGzSh-n6Sg-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2018-01-12 21:24           ` Karthik Ramasubramanian
2017-12-27 16:27 ` [PATCH RFC 7/7] tty: serial: msm_geni_serial: Add serial driver support for GENI based QUP Karthikeyan Ramasubramanian

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1514392046-30602-1-git-send-email-kramasub@codeaurora.org \
    --to=kramasub@codeaurora.org \
    --cc=andy.gross@linaro.org \
    --cc=corbet@lwn.net \
    --cc=david.brown@linaro.org \
    --cc=devicetree@vger.kernel.org \
    --cc=gregkh@linuxfoundation.org \
    --cc=jslaby@suse.com \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=linux-doc@vger.kernel.org \
    --cc=linux-i2c@vger.kernel.org \
    --cc=linux-serial@vger.kernel.org \
    --cc=mark.rutland@arm.com \
    --cc=robh+dt@kernel.org \
    --cc=wsa@the-dreams.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).