This adds device tree support to tlv320dac33.c.

Signed-off-by: Pavel Machek <pavel@ucw.cz>

diff --git a/Documentation/devicetree/bindings/sound/tlv320dac33.txt b/Documentation/devicetree/bindings/sound/tlv320dac33.txt
new file mode 100644
index 0000000..6cbd311
--- /dev/null
+++ b/Documentation/devicetree/bindings/sound/tlv320dac33.txt
@@ -0,0 +1,32 @@
+Texas Instruments - tlv320dac33 Codec module
+
+The tlv320dac33 serial control bus communicates through I2C protocols.
+
+Required properties:
+
+- compatible - "ti,tlv320dac33"
+- reg - I2C slave address
+
+Optional properties:
+
+- power-gpios - gpio pin to power the device, active high
+
+- interrupts       - The interrupt output from the device.
+- interrupt-parent - The parent interrupt controller.
+
+- ti,keep-bclk 	- Keep the BCLK running in FIFO modes
+- ti,burst-bclkdiv - BCLK divider value in burst mode
+
+Example:
+
+tlv320dac33: audio-codec@19 {
+	compatible = "ti,tlv320dac33";
+	reg = <0x19>;
+
+	interrupt-parent = <&gpio2>;
+	interrupts = <21 1>; /* gpio_53, IRQF_TRIGGER_RISING */
+	power-gpio = <&gpio2 28 0>; /* gpio_60 */
+
+	ti,keep-bclk;
+	ti,burst-bclkdiv = <3>;
+};
diff --git a/sound/soc/codecs/tlv320dac33.c b/sound/soc/codecs/tlv320dac33.c
index 5b94a15..2a0fe06 100644
--- a/sound/soc/codecs/tlv320dac33.c
+++ b/sound/soc/codecs/tlv320dac33.c
@@ -30,6 +32,7 @@
 #include <linux/interrupt.h>
 #include <linux/gpio.h>
 #include <linux/regulator/consumer.h>
+#include <linux/of_gpio.h>
 #include <linux/slab.h>
 #include <sound/core.h>
 #include <sound/pcm.h>
@@ -105,7 +108,7 @@ struct tlv320dac33_priv {
 	unsigned int nsample;		/* burst read amount from host */
 	int mode1_latency;		/* latency caused by the i2c writes in
 					 * us */
-	u8 burst_bclkdiv;		/* BCLK divider value in burst mode */
+	u32 burst_bclkdiv;		/* BCLK divider value in burst mode */
 	unsigned int burst_rate;	/* Interface speed in Burst modes */
 
 	int keep_bclk;			/* Keep the BCLK continuously running
@@ -1484,16 +1487,11 @@ static struct snd_soc_dai_driver dac33_dai = {
 static int dac33_i2c_probe(struct i2c_client *client,
 			   const struct i2c_device_id *id)
 {
-	struct tlv320dac33_platform_data *pdata;
+	struct tlv320dac33_platform_data *pdata = client->dev.platform_data;
 	struct tlv320dac33_priv *dac33;
+	struct device_node *np = client->dev.of_node;
 	int ret, i;
 
-	if (client->dev.platform_data == NULL) {
-		dev_err(&client->dev, "Platform data not set\n");
-		return -ENODEV;
-	}
-	pdata = client->dev.platform_data;
-
 	dac33 = devm_kzalloc(&client->dev, sizeof(struct tlv320dac33_priv),
 			     GFP_KERNEL);
 	if (dac33 == NULL)
@@ -1505,10 +1503,26 @@ static int dac33_i2c_probe(struct i2c_client *client,
 
 	i2c_set_clientdata(client, dac33);
 
-	dac33->power_gpio = pdata->power_gpio;
-	dac33->burst_bclkdiv = pdata->burst_bclkdiv;
-	dac33->keep_bclk = pdata->keep_bclk;
-	dac33->mode1_latency = pdata->mode1_latency;
+	if (pdata) {
+		dac33->power_gpio = pdata->power_gpio;
+		dac33->burst_bclkdiv = pdata->burst_bclkdiv;
+		dac33->keep_bclk = pdata->keep_bclk;
+		dac33->mode1_latency = pdata->mode1_latency;
+	} else if (np) {
+		ret = of_get_named_gpio(np, "power-gpios", 0);
+		if (ret >= 0)
+			dac33->power_gpio = ret;
+		else
+			dac33->power_gpio = -1;
+
+		if (of_property_read_bool(np, "ti,keep-bclk"))
+			dac33->keep_bclk = true;
+
+		of_property_read_u32(np, "ti,burst-bclkdiv", &dac33->burst_bclkdiv);
+	} else {
+		dev_err(&client->dev, "Platform data not set\n");
+		return -ENODEV;
+	}
 	if (!dac33->mode1_latency)
 		dac33->mode1_latency = 10000; /* 10ms */
 	dac33->irq = client->irq;
@@ -1574,9 +1588,16 @@ static const struct i2c_device_id tlv320dac33_i2c_id[] = {
 };
 MODULE_DEVICE_TABLE(i2c, tlv320dac33_i2c_id);
 
+static const struct of_device_id tlv320dac33_of_match[] = {
+	{ .compatible = "ti,tlv320dac33", },
+	{},
+};
+MODULE_DEVICE_TABLE(i2c, tlv320dac33_of_match);
+
 static struct i2c_driver tlv320dac33_i2c_driver = {
 	.driver = {
 		.name = "tlv320dac33-codec",
+		.of_match_table = of_match_ptr(tlv320dac33_of_match),
 	},
 	.probe		= dac33_i2c_probe,
 	.remove		= dac33_i2c_remove,

-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html