Re: [PATCH v3 2/2] ARM: dts: imx25-pinfunc: Always set SION for eSDHC CMD

[Rob Herring <robh-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>]

On Wed, Jan 31, 2018 at 10:35:44PM +0100, Benoît Thébaudeau wrote:
> The eSDHC does not work properly if the SION bit is not set for the
> bidirectional CMD signal, whatever the eSDHC instance and the selected
> pad. Therefore, setting SION is mandatory for all eSDHC CMD ports. Do
> this for MX25_PAD_*__ESDHCn_CMD in imx25-pinfunc.h in order to enforce
> this behavior for all boards.
> 
> This had already been done for eSDHC1, but not for eSDHC2. Also, define
> MX25_PAD_FEC_MDC__ESDHC2_CMD so that all the possible cases are covered
> from now on.
> 
> Cc: Uwe Kleine-König <u.kleine-koenig-bIcnvbaLZ9MEGnE8C9+IrQ@public.gmane.org>
> Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau.dev-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
> Reviewed-by: Fabio Estevam <fabio.estevam-3arQi8VN3Tc@public.gmane.org>
> ---
> Changes v2 -> v3:
>  - Quickly mention SION in each comment, besides the reference to the
>    verbose comment (suggested by Uwe).
> Changes v1 -> v2:
>  - Update eSDHC instance and port naming following the addition of "ARM:
>    dts: imx25-pinfunc: Use consistent naming for eSDHC".
>  - Reference the more verbose comment for MX25_PAD_SD1_CMD__ESDHC1_CMD
>    instead of copying the same less detailed comment everywhere
>    (suggested by Uwe).
> ---
>  arch/arm/boot/dts/imx25-pinfunc.h | 18 +++++++++++-------
>  1 file changed, 11 insertions(+), 7 deletions(-)

Reviewed-by: Rob Herring <robh-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html