From: Dan Murphy <dmurphy@ti.com>
To: <andrew@lunn.ch>, <f.fainelli@gmail.com>, <hkallweit1@gmail.com>,
<bunk@kernel.org>
Cc: <netdev@vger.kernel.org>, <devicetree@vger.kernel.org>,
<linux-kernel@vger.kernel.org>, <grygorii.strashko@ti.com>,
Dan Murphy <dmurphy@ti.com>
Subject: [PATCH net-next v3 2/2] net: phy: dp83867: Add rx-fifo-depth and tx-fifo-depth
Date: Mon, 9 Dec 2019 14:10:25 -0600 [thread overview]
Message-ID: <20191209201025.5757-3-dmurphy@ti.com> (raw)
In-Reply-To: <20191209201025.5757-1-dmurphy@ti.com>
This code changes the TI specific ti,fifo-depth to the common
tx-fifo-depth property. The tx depth is applicable for both RGMII and
SGMII modes of operation.
rx-fifo-depth was added as well but this is only applicable for SGMII
mode.
So in summary
if RGMII mode write tx fifo depth only
if SGMII mode write both rx and tx fifo depths
If the property is not populated in the device tree then set the value
to the default values.
Signed-off-by: Dan Murphy <dmurphy@ti.com>
Reported-by: Adrian Bunk <bunk@kernel.org>
---
v3 - No changes
v2 - Rebase on linux-net next as the patch would not apply
drivers/net/phy/dp83867.c | 62 +++++++++++++++++++++++++++++++--------
1 file changed, 49 insertions(+), 13 deletions(-)
diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c
index 9cd9dcee4eb2..adda0d0eab80 100644
--- a/drivers/net/phy/dp83867.c
+++ b/drivers/net/phy/dp83867.c
@@ -93,9 +93,11 @@
#define DP83867_STRAP_STS2_CLK_SKEW_NONE BIT(2)
/* PHY CTRL bits */
-#define DP83867_PHYCR_FIFO_DEPTH_SHIFT 14
+#define DP83867_PHYCR_TX_FIFO_DEPTH_SHIFT 14
+#define DP83867_PHYCR_RX_FIFO_DEPTH_SHIFT 12
#define DP83867_PHYCR_FIFO_DEPTH_MAX 0x03
-#define DP83867_PHYCR_FIFO_DEPTH_MASK GENMASK(15, 14)
+#define DP83867_PHYCR_TX_FIFO_DEPTH_MASK GENMASK(15, 14)
+#define DP83867_PHYCR_RX_FIFO_DEPTH_MASK GENMASK(13, 12)
#define DP83867_PHYCR_RESERVED_MASK BIT(11)
/* RGMIIDCTL bits */
@@ -131,7 +133,8 @@ enum {
struct dp83867_private {
u32 rx_id_delay;
u32 tx_id_delay;
- u32 fifo_depth;
+ u32 tx_fifo_depth;
+ u32 rx_fifo_depth;
int io_impedance;
int port_mirroring;
bool rxctrl_strap_quirk;
@@ -408,18 +411,32 @@ static int dp83867_of_init(struct phy_device *phydev)
dp83867->port_mirroring = DP83867_PORT_MIRROING_DIS;
ret = of_property_read_u32(of_node, "ti,fifo-depth",
- &dp83867->fifo_depth);
+ &dp83867->tx_fifo_depth);
if (ret) {
- phydev_err(phydev,
- "ti,fifo-depth property is required\n");
- return ret;
+ ret = of_property_read_u32(of_node, "tx-fifo-depth",
+ &dp83867->tx_fifo_depth);
+ if (ret)
+ dp83867->tx_fifo_depth =
+ DP83867_PHYCR_FIFO_DEPTH_4_B_NIB;
}
- if (dp83867->fifo_depth > DP83867_PHYCR_FIFO_DEPTH_MAX) {
- phydev_err(phydev,
- "ti,fifo-depth value %u out of range\n",
- dp83867->fifo_depth);
+
+ if (dp83867->tx_fifo_depth > DP83867_PHYCR_FIFO_DEPTH_MAX) {
+ phydev_err(phydev, "tx-fifo-depth value %u out of range\n",
+ dp83867->tx_fifo_depth);
+ return -EINVAL;
+ }
+
+ ret = of_property_read_u32(of_node, "rx-fifo-depth",
+ &dp83867->rx_fifo_depth);
+ if (ret)
+ dp83867->rx_fifo_depth = DP83867_PHYCR_FIFO_DEPTH_4_B_NIB;
+
+ if (dp83867->rx_fifo_depth > DP83867_PHYCR_FIFO_DEPTH_MAX) {
+ phydev_err(phydev, "rx-fifo-depth value %u out of range\n",
+ dp83867->rx_fifo_depth);
return -EINVAL;
}
+
return 0;
}
#else
@@ -458,12 +475,31 @@ static int dp83867_config_init(struct phy_device *phydev)
phy_clear_bits_mmd(phydev, DP83867_DEVADDR, DP83867_CFG4,
BIT(7));
+ if (phy_interface_is_rgmii(phydev) ||
+ phydev->interface == PHY_INTERFACE_MODE_SGMII) {
+ val = phy_read(phydev, MII_DP83867_PHYCTRL);
+ if (val < 0)
+ return val;
+
+ val &= ~DP83867_PHYCR_TX_FIFO_DEPTH_MASK;
+ val |= (dp83867->tx_fifo_depth <<
+ DP83867_PHYCR_TX_FIFO_DEPTH_SHIFT);
+
+ if (phydev->interface == PHY_INTERFACE_MODE_SGMII) {
+ val &= ~DP83867_PHYCR_RX_FIFO_DEPTH_MASK;
+ val |= (dp83867->rx_fifo_depth <<
+ DP83867_PHYCR_RX_FIFO_DEPTH_SHIFT);
+ }
+
+ ret = phy_write(phydev, MII_DP83867_PHYCTRL, val);
+ if (ret)
+ return ret;
+ }
+
if (phy_interface_is_rgmii(phydev)) {
val = phy_read(phydev, MII_DP83867_PHYCTRL);
if (val < 0)
return val;
- val &= ~DP83867_PHYCR_FIFO_DEPTH_MASK;
- val |= (dp83867->fifo_depth << DP83867_PHYCR_FIFO_DEPTH_SHIFT);
/* The code below checks if "port mirroring" N/A MODE4 has been
* enabled during power on bootstrap.
--
2.23.0
next prev parent reply other threads:[~2019-12-09 20:12 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-12-09 20:10 [PATCH net-next v3 0/2] Fix Tx/Rx FIFO depth for DP83867 Dan Murphy
2019-12-09 20:10 ` [PATCH net-next v3 1/2] dt-bindings: dp83867: Convert fifo-depth to common fifo-depth and make optional Dan Murphy
2019-12-09 20:10 ` Dan Murphy [this message]
2019-12-10 4:19 ` [PATCH net-next v3 0/2] Fix Tx/Rx FIFO depth for DP83867 David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20191209201025.5757-3-dmurphy@ti.com \
--to=dmurphy@ti.com \
--cc=andrew@lunn.ch \
--cc=bunk@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=f.fainelli@gmail.com \
--cc=grygorii.strashko@ti.com \
--cc=hkallweit1@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).