Re: [PATCH 02/10] dt-bindings: iio: adc: at91-sama5d2: add rtc-trigger optional property

[Jonathan Cameron <jic23@kernel.org>]

On Wed, 18 Dec 2019 16:23:58 +0000
<Eugen.Hristev@microchip.com> wrote:

> From: Eugen Hristev <eugen.hristev@microchip.com>
> 
> Add property to connect RTC-type trigger to the ADC block.
> The ADC is connected internally with a line to the RTC block.
> The RTC can provide a trigger signal to the ADC to start conversions.
> 
> Signed-off-by: Eugen Hristev <eugen.hristev@microchip.com>
As discussed, might want to just be the rtc handle rather than a new
trigger one.

> ---
>  Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt b/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt
> index 4a3c1d4..1980f0e 100644
> --- a/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt
> +++ b/Documentation/devicetree/bindings/iio/adc/at91-sama5d2_adc.txt
> @@ -23,6 +23,9 @@ Optional properties:
>    See ../../dma/dma.txt for details.
>    - #io-channel-cells: in case consumer drivers are attached, this must be 1.
>    See <Documentation/devicetree/bindings/iio/iio-bindings.txt> for details.
> +  - atmel,rtc-trigger: The ADC IP block can be triggered by the RTC block
> +inside the SoC. This property is a phandle to a node that provides a
> +trigger device, if the ADC block supports it.

Do we want to be more specific on devices that do support it?
Maybe it's enough of a complex mess that we don't.

>  
>  Properties for consumer drivers:
>    - Consumer drivers can be connected to this producer device, as specified
> @@ -44,6 +47,7 @@ adc: adc@fc030000 {
>  	vddana-supply = <&vdd_3v3_lp_reg>;
>  	vref-supply = <&vdd_3v3_lp_reg>;
>  	atmel,trigger-edge-type = <IRQ_TYPE_EDGE_BOTH>;
> +	atmel,rtc-trigger = <&rtc_adc_trigger>;
>  	dmas = <&dma0 (AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) | AT91_XDMAC_DT_PERID(25))>;
>  	dma-names = "rx";
>  	#io-channel-cells = <1>;