Re: [RESENDPATCH v15 2/2] mtd: rawnand: Add NAND controller support on Intel LGM SoC

[Miquel Raynal <miquel.raynal@bootlin.com>]

Hello,

> >> +static const struct nand_controller_ops ebu_nand_controller_ops = {
> >> +	.attach_chip = ebu_nand_attach_chip,
> >> +	.setup_interface = ebu_nand_set_timings,
> >> +	.exec_op = ebu_nand_exec_op,
> >> +};
> >> +
> >> +static void ebu_dma_cleanup(struct ebu_nand_controller *ebu_host)
> >> +{
> >> +	if (ebu_host->dma_rx)
> >> +		dma_release_channel(ebu_host->dma_rx);
> >> +
> >> +	if (ebu_host->dma_tx)
> >> +		dma_release_channel(ebu_host->dma_tx);
> >> +}
> >> +
> >> +static int ebu_nand_probe(struct platform_device *pdev)
> >> +{
> >> +	struct device *dev = &pdev->dev;
> >> +	struct ebu_nand_controller *ebu_host;
> >> +	struct nand_chip *nand;
> >> +	struct mtd_info *mtd;
> >> +	struct resource *res;
> >> +	char *resname;
> >> +	int ret, i;
> >> +	u32 reg;
> >> +
> >> +	ebu_host = devm_kzalloc(dev, sizeof(*ebu_host), GFP_KERNEL);
> >> +	if (!ebu_host)
> >> +		return -ENOMEM;
> >> +
> >> +	ebu_host->dev = dev;
> >> +	nand_controller_init(&ebu_host->controller);
> >> +
> >> +	res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "ebunand");
> >> +	ebu_host->ebu = devm_ioremap_resource(&pdev->dev, res);
> >> +	if (IS_ERR(ebu_host->ebu))
> >> +		return PTR_ERR(ebu_host->ebu);
> >> +
> >> +	res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "hsnand");
> >> +	ebu_host->hsnand = devm_ioremap_resource(&pdev->dev, res);
> >> +	if (IS_ERR(ebu_host->hsnand))
> >> +		return PTR_ERR(ebu_host->hsnand);
> >> +
> >> +	ret = device_property_read_u32(dev, "nand,cs", &reg);  
> > 
> > There is no nand,cs property. Use 'reg' instead.  
> Noted.
> >   
> >> +	if (ret) {
> >> +		dev_err(dev, "failed to get chip select: %d\n", ret);
> >> +		return ret;
> >> +	}
> >> +	ebu_host->cs_num = reg;  
> > 
> > The following for loop is weird, above you can only store a single cs
> > number, while below you seem to reserve serveral memory areas. Please
> > clarify this code.  
> This IP supports 2 chip select for 2 different memory regions so we used the below for loop, as per reviewers comment updated.
> 		 EBU_CS0_BASE     0xE1C0_0000 (Memory-Mapped)
> 		 EBU_CS0_IO_BASE  0x1740_0000 (FPI I/O Mapped)
> 
>                   EBU_CS1_BASE     0xE140_0000 (Memory-Mapped)
>                   EBU_CS1_IO_BASE  0x17C0_0000 (FPI I/O Mapped)

Please make a difference between, "there are two CS, either can be
picked but we can use only one in this driver" or "there are two CS,
one or both can be used". You can start with supporting a single CS (no
matter which one is picked by the user with the reg property) but in
this case there is no such for loop because only 1 CS is used. Or you
can decide that both CS can be populated and in this case you must
handle this in ->select_chip().

> 
> >   
> >> +
> >> +	for (i = 0; i < MAX_CS; i++) {
> >> +		resname = devm_kasprintf(dev, GFP_KERNEL, "nand_cs%d", i);
> >> +		res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
> >> +						   resname);
> >> +		ebu_host->cs[i].chipaddr = devm_ioremap_resource(dev, res);
> >> +		ebu_host->cs[i].nand_pa = res->start;
> >> +		if (IS_ERR(ebu_host->cs[i].chipaddr))
> >> +			return PTR_ERR(ebu_host->cs[i].chipaddr);
> >> +	}
> >> +
> >> +	ebu_host->clk = devm_clk_get(dev, NULL);
> >> +	if (IS_ERR(ebu_host->clk))
> >> +		return dev_err_probe(dev, PTR_ERR(ebu_host->clk),
> >> +				     "failed to get clock\n");
> >> +
> >> +	ret = clk_prepare_enable(ebu_host->clk);
> >> +	if (ret) {
> >> +		dev_err(dev, "failed to enable clock: %d\n", ret);
> >> +		return ret;
> >> +	}
> >> +	ebu_host->clk_rate = clk_get_rate(ebu_host->clk);
> >> +
> >> +	ebu_host->dma_tx = dma_request_chan(dev, "tx");
> >> +	if (IS_ERR(ebu_host->dma_tx))
> >> +		return dev_err_probe(dev, PTR_ERR(ebu_host->dma_tx),
> >> +				     "failed to request DMA tx chan!.\n");
> >> +
> >> +	ebu_host->dma_rx = dma_request_chan(dev, "rx");
> >> +	if (IS_ERR(ebu_host->dma_rx))
> >> +		return dev_err_probe(dev, PTR_ERR(ebu_host->dma_rx),
> >> +				     "failed to request DMA rx chan!.\n");
> >> +
> >> +	for (i = 0; i < MAX_CS; i++) {
> >> +		resname = devm_kasprintf(dev, GFP_KERNEL, "addr_sel%d", i);
> >> +		res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
> >> +						   resname);
> >> +		if (!res)
> >> +			return -EINVAL;
> >> +		ebu_host->cs[i].addr_sel = res->start;
> >> +		writel(ebu_host->cs[i].addr_sel | EBU_ADDR_MASK(5) |
> >> +		       EBU_ADDR_SEL_REGEN, ebu_host->ebu + EBU_ADDR_SEL(i));
> >> +	}
> >> +
> >> +	nand_set_flash_node(&ebu_host->chip, dev->of_node);
> >> +	if (!mtd->name) {
> >> +		dev_err(ebu_host->dev, "NAND label property is mandatory\n");
> >> +		return -EINVAL;
> >> +	}
> >> +
> >> +	mtd = nand_to_mtd(&ebu_host->chip);
> >> +	mtd->dev.parent = dev;
> >> +	ebu_host->dev = dev;
> >> +
> >> +	platform_set_drvdata(pdev, ebu_host);
> >> +	nand_set_controller_data(&ebu_host->chip, ebu_host);
> >> +
> >> +	nand = &ebu_host->chip;
> >> +	nand->controller = &ebu_host->controller;
> >> +	nand->controller->ops = &ebu_nand_controller_ops;
> >> +
> >> +	/* Scan to find existence of the device */
> >> +	ret = nand_scan(&ebu_host->chip, 1);
> >> +	if (ret)
> >> +		goto err_cleanup_dma;
> >> +
> >> +	ret = mtd_device_register(mtd, NULL, 0);
> >> +	if (ret)
> >> +		goto err_clean_nand;
> >> +
> >> +	return 0;
> >> +
> >> +err_clean_nand:
> >> +	nand_cleanup(&ebu_host->chip);
> >> +err_cleanup_dma:
> >> +	ebu_dma_cleanup(ebu_host);
> >> +	clk_disable_unprepare(ebu_host->clk);
> >> +
> >> +	return ret;
> >> +}
> >> +
> >> +static int ebu_nand_remove(struct platform_device *pdev)
> >> +{
> >> +	struct ebu_nand_controller *ebu_host = platform_get_drvdata(pdev);
> >> +	int ret;
> >> +
> >> +	ret = mtd_device_unregister(nand_to_mtd(&ebu_host->chip));
> >> +	WARN_ON(ret);
> >> +	nand_cleanup(&ebu_host->chip);
> >> +	ebu_nand_disable(&ebu_host->chip);
> >> +	ebu_dma_cleanup(ebu_host);
> >> +	clk_disable_unprepare(ebu_host->clk);
> >> +
> >> +	return 0;
> >> +}
> >> +
> >> +static const struct of_device_id ebu_nand_match[] = {
> >> +	{ .compatible = "intel,nand-controller", },  
> > 
> > No version or soc in the compatible? (not mandatory).  
> Yes, you're right, it should be "intel,lgm-ebunand", but this same driver supports 2 dfferent SOC's , that's the reason kept as generic
> "intel,nand-controller"

In this case I guess declaring two compatibles is the way to go.


Thanks,
Miquèl