Re: [PATCH] ARM64: dts: allwinner: Add devicetree for pine H64 modelA evaluation board

["Jernej Škrabec" <jernej.skrabec-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>]

Dne sreda, 14. avgust 2019 ob 15:28:53 CEST je Clément Péron napisal(a):
> Hi,
> 
> On Wed, 14 Aug 2019 at 15:20, Corentin Labbe <clabbe.montjoie-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org> 
wrote:
> > On Mon, Aug 12, 2019 at 12:56:56PM +0200, Jernej Škrabec wrote:
> > > Dne četrtek, 08. avgust 2019 ob 10:42:53 CEST je Corentin Labbe 
napisal(a):
> > > > This patch adds the evaluation variant of the model A of the PineH64.
> > > > The model A has the same size of the pine64 and has a PCIE slot.
> > > > 
> > > > The only devicetree difference with current pineH64, is the PHY
> > > > regulator.
> > > 
> > > I have Model A board which also needs ddc-en-gpios property for HDMI
> > > connector in order for HDMI to work correctly. Otherwise it will just
> > > use 1024x768 resolution. Can you confirm that?
> 
> Schematics Rev A:
> http://files.pine64.org/doc/Pine%20H64/Pine%20H64%20Ver1.1-20180104.pdf
> 
> Rev B:
> http://files.pine64.org/doc/Pine%20H64/PINE-H6-model-B-20181212-schematic.pd
> f
> 
> There is a DDC_EN on REV A not on REV B
> 
> Regards,
> Clément
> 
> > > Best regards,
> > > Jernej
> > 
> > Sorry I didnt use at all video stuff (like HDMI), so I cannot answer now.
> > 
> > Could you send me a patch against my future v2 and I could test
> > with/without.

I don't have access to my Model A board currently, but this should suffice:

&connector {
	ddc-en-gpios = <&pio 7 2 GPIO_ACTIVE_HIGH>; /* PH2 */
};

Best regards,
Jernej

> > 
> > Regards
> > 
> > --
> > You received this message because you are subscribed to the Google Groups
> > "linux-sunxi" group. To unsubscribe from this group and stop receiving
> > emails from it, send an email to
> > linux-sunxi+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/Ez6ZCGd0@public.gmane.org To view this discussion on the
> > web, visit
> > https://groups.google.com/d/msgid/linux-sunxi/20190814132001.GC24324%40Re
> > d.




-- 
You received this message because you are subscribed to the Google Groups "linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email to linux-sunxi+unsubscribe-/JYPxA39Uh5TLH3MbocFF+G/Ez6ZCGd0@public.gmane.org
To view this discussion on the web, visit https://groups.google.com/d/msgid/linux-sunxi/2361666.6tDiKGV9WF%40jernej-laptop.