From mboxrd@z Thu Jan 1 00:00:00 1970 From: Rob Herring Subject: Re: [PATCH v4 3/5] dt-bindings: phy: tegra: Add Tegra194 support Date: Mon, 14 Oct 2019 08:40:37 -0500 Message-ID: References: <20191009024343.30218-1-jckuo@nvidia.com> <20191009024343.30218-4-jckuo@nvidia.com> <20191009233900.GA9109@bogus> <20191014131752.GF422231@ulmo> Mime-Version: 1.0 Content-Type: text/plain; charset="UTF-8" Return-path: In-Reply-To: <20191014131752.GF422231@ulmo> Sender: linux-kernel-owner@vger.kernel.org To: Thierry Reding Cc: JC Kuo , Greg Kroah-Hartman , Jon Hunter , Kishon Vijay Abraham I , linux-tegra@vger.kernel.org, Linux USB List , "linux-kernel@vger.kernel.org" , devicetree@vger.kernel.org, Nagarjuna Kristam List-Id: devicetree@vger.kernel.org On Mon, Oct 14, 2019 at 8:17 AM Thierry Reding wrote: > > On Wed, Oct 09, 2019 at 06:39:00PM -0500, Rob Herring wrote: > > On Wed, Oct 09, 2019 at 10:43:41AM +0800, JC Kuo wrote: > > > Extend the bindings to cover the set of features found in Tegra194. > > > Note that, technically, there are four more supplies connected to the > > > XUSB pad controller (DVDD_PEX, DVDD_PEX_PLL, HVDD_PEX and HVDD_PEX_PLL) > > > , but the power sequencing requirements of Tegra194 require these to be > > > under the control of the PMIC. > > > > > > Tegra194 XUSB PADCTL supports up to USB 3.1 Gen 2 speed, however, it is > > > possible for some platforms have long signal trace that could not > > > provide sufficient electrical environment for Gen 2 speed. To deal with > > > this, a new device node property "nvidia,disable-gen2" was added to > > > Tegra194 that be used to specifically disable Gen 2 speed for a > > > particular USB 3.0 port so that the port can be limited to Gen 1 speed > > > and avoid the instability. > > > > I suspect this may be a common issue and we should have a common > > property. Typically, this kind of property is in the controller though > > and supports multiple speed limits. See PCI bindings for inspiration. > > Given that support for gen 2 speeds is dependent on signal trace length, > it doesn't really make sense to restrict the whole controller to a given > speed if only the signal trace for a single port exceeds the limit for > which gen 2 would work. > > Also, the USB PHYs are in a different hardware block than the USB > controller, so this really is a property of the PHY block, not the USB > controller. Okay, but still should be common for USB PHYs IMO. Rob