On Fri, Sep 03, 2021 at 08:20:55AM -0500, Rob Herring wrote: > On Wed, Sep 1, 2021 at 9:13 AM Thierry Reding wrote: > > > > On Fri, Jul 02, 2021 at 05:16:25PM +0300, Dmitry Osipenko wrote: > > > 01.07.2021 21:14, Thierry Reding пишет: > > > > On Tue, Jun 08, 2021 at 06:51:40PM +0200, Thierry Reding wrote: > > > >> On Fri, May 28, 2021 at 06:54:55PM +0200, Thierry Reding wrote: > > > >>> On Thu, May 20, 2021 at 05:03:06PM -0500, Rob Herring wrote: > > > >>>> On Fri, Apr 23, 2021 at 06:32:30PM +0200, Thierry Reding wrote: > > > >>>>> From: Thierry Reding > > > >>>>> > > > >>>>> Reserved memory region phandle references can be accompanied by a > > > >>>>> specifier that provides additional information about how that specific > > > >>>>> reference should be treated. > > > >>>>> > > > >>>>> One use-case is to mark a memory region as needing an identity mapping > > > >>>>> in the system's IOMMU for the device that references the region. This is > > > >>>>> needed for example when the bootloader has set up hardware (such as a > > > >>>>> display controller) to actively access a memory region (e.g. a boot > > > >>>>> splash screen framebuffer) during boot. The operating system can use the > > > >>>>> identity mapping flag from the specifier to make sure an IOMMU identity > > > >>>>> mapping is set up for the framebuffer before IOMMU translations are > > > >>>>> enabled for the display controller. > > > >>>>> > > > >>>>> Signed-off-by: Thierry Reding > > > >>>>> --- > > > >>>>> .../reserved-memory/reserved-memory.txt | 21 +++++++++++++++++++ > > > >>>>> include/dt-bindings/reserved-memory.h | 8 +++++++ > > > >>>>> 2 files changed, 29 insertions(+) > > > >>>>> create mode 100644 include/dt-bindings/reserved-memory.h > > > >>>> > > > >>>> Sorry for being slow on this. I have 2 concerns. > > > >>>> > > > >>>> First, this creates an ABI issue. A DT with cells in 'memory-region' > > > >>>> will not be understood by an existing OS. I'm less concerned about this > > > >>>> if we address that with a stable fix. (Though I'm pretty sure we've > > > >>>> naively added #?-cells in the past ignoring this issue.) > > > >>> > > > >>> A while ago I had proposed adding memory-region*s* as an alternative > > > >>> name for memory-region to make the naming more consistent with other > > > >>> types of properties (think clocks, resets, gpios, ...). If we added > > > >>> that, we could easily differentiate between the "legacy" cases where > > > >>> no #memory-region-cells was allowed and the new cases where it was. > > > >>> > > > >>>> Second, it could be the bootloader setting up the reserved region. If a > > > >>>> node already has 'memory-region', then adding more regions is more > > > >>>> complicated compared to adding new properties. And defining what each > > > >>>> memory-region entry is or how many in schemas is impossible. > > > >>> > > > >>> It's true that updating the property gets a bit complicated, but it's > > > >>> not exactly rocket science. We really just need to splice the array. I > > > >>> have a working implemention for this in U-Boot. > > > >>> > > > >>> For what it's worth, we could run into the same issue with any new > > > >>> property that we add. Even if we renamed this to iommu-memory-region, > > > >>> it's still possible that a bootloader may have to update this property > > > >>> if it already exists (it could be hard-coded in DT, or it could have > > > >>> been added by some earlier bootloader or firmware). > > > >>> > > > >>>> Both could be addressed with a new property. Perhaps something like > > > >>>> 'iommu-memory-region = <&phandle>;'. I think the 'iommu' prefix is > > > >>>> appropriate given this is entirely because of the IOMMU being in the > > > >>>> mix. I might feel differently if we had other uses for cells, but I > > > >>>> don't really see it in this case. > > > >>> > > > >>> I'm afraid that down the road we'll end up with other cases and then we > > > >>> might proliferate a number of *-memory-region properties with varying > > > >>> prefixes. > > > >>> > > > >>> I am aware of one other case where we might need something like this: on > > > >>> some Tegra SoCs we have audio processors that will access memory buffers > > > >>> using a DMA engine. These processors are booted from early firmware > > > >>> using firmware from system memory. In order to avoid trashing the > > > >>> firmware, we need to reserve memory. We can do this using reserved > > > >>> memory nodes. However, the audio DMA engine also uses the SMMU, so we > > > >>> need to make sure that the firmware memory is marked as reserved within > > > >>> the SMMU. This is similar to the identity mapping case, but not exactly > > > >>> the same. Instead of creating a 1:1 mapping, we just want that IOVA > > > >>> region to be reserved (i.e. IOMMU_RESV_RESERVED instead of > > > >>> IOMMU_RESV_DIRECT{,_RELAXABLE}). > > > >>> > > > >>> That would also fall into the IOMMU domain, but we can't reuse the > > > >>> iommu-memory-region property for that because then we don't have enough > > > >>> information to decide which type of reservation we need. > > > >>> > > > >>> We could obviously make iommu-memory-region take a specifier, but we > > > >>> could just as well use memory-regions in that case since we have > > > >>> something more generic anyway. > > > >>> > > > >>> With the #memory-region-cells proposal, we can easily extend the cell in > > > >>> the specifier with an additional MEMORY_REGION_IOMMU_RESERVE flag to > > > >>> take that other use case into account. If we than also change to the new > > > >>> memory-regions property name, we avoid the ABI issue (and we gain a bit > > > >>> of consistency while at it). > > > >> > > > >> Ping? Rob, do you want me to add this second use-case to the patch > > > >> series to make it more obvious that this isn't just a one-off thing? Or > > > >> how do we proceed? > > > > > > > > Rob, given that additional use-case, do you want me to run with this > > > > proposal and send out an updated series? > > > > > > > > > What about variant with a "descriptor" properties that will describe > > > each region: > > > > > > fb_desc: display-framebuffer-memory-descriptor { > > > needs-identity-mapping; > > > } > > > > > > display@52400000 { > > > memory-region = <&fb ...>; > > > memory-region-descriptor = <&fb_desc ...>; > > > }; > > > > > > It could be a more flexible/extendible variant. > > > > This problem recently came up on #dri-devel again. Adding Alyssa and > > Sven who are facing a similar challenge on their work on Apple M1 (if I > > understood correctly). Also adding dri-devel for visibility since this > > is a very common problem for display in particular. > > > > On M1 the situation is slightly more complicated: the firmware will > > allocate a couple of buffers (including the framebuffer) in high memory > > (> 4 GiB) and use the IOMMU to map that into an IOVA region below 4 GiB > > so that the display hardware can access it. This makes it impossible to > > bypass the IOMMU like we do on other chips (in particular to work around > > the fault-by-default policy of the ARM SMMU driver). It also means that > > in addition to the simple reserved regions I mentioned we need for audio > > use-cases and identity mapping use-cases we need for display on Tegra, > > we now also need to be able to convey physical to IOVA mappings. > > > > Fitting the latter into the original proposal sounds difficult. A quick > > fix would've been to generate a mapping table in memory and pass that to > > the kernel using a reserved-memory node (similar to what's done for > > example on Tegra for the EMC frequency table on Tegra210) and mark it as > > such using a special flag. But that then involves two layers of parsing, > > which seems a bit suboptimal. Another way to shoehorn that into the > > original proposal would've been to add flags for physical and virtual > > address regions and use pairs to pass them using special flags. Again, > > this is a bit wonky because it needs these to be carefully parsed and > > matched up. > > > > Another downside is that we now have a situation where some of these > > regions are no longer "reserved-memory regions" in the traditional > > sense. This would require an additional flag in the reserved-memory > > region nodes to prevent the IOVA regions from being reserved. By the > > way, this is something that would also be needed for the audio use-case > > I mentioned before, because the physical memory at that address can > > still be used by an operating system. > > > > A more general solution would be to draw a bit from Dmitry's proposal > > and introduce a new top-level "iov-reserved-memory" node. This could be > > modelled on the existing reserved-memory node, except that the physical > > memory pages for regions represented by child nodes would not be marked > > as reserved. Only the IOVA range described by the region would be > > reserved subsequently by the IOMMU framework and/or IOMMU driver. > > > > The simplest case where we just want to reserve some IOVA region could > > then be done like this: > > > > iov-reserved-memory { > > /* > > * Probably safest to default to <2>, <2> here given > > * that most IOMMUs support either > 32 bits of IAS > > * or OAS. > > */ > > #address-cells = <2>; > > #size-cells = <2>; > > > > firmware: firmware@80000000 { > > reg = <0 0x80000000 0 0x01000000>; > > }; > > }; > > > > audio@30000000 { > > ... > > iov-memory-regions = <&firmware>; > > ... > > }; > > > > Mappings could be represented by an IOV reserved region taking a > > reference to the reserved-region that they map: > > > > reserved-memory { > > #address-cells = <2>; > > #size-cells = <2>; > > > > /* 16 MiB of framebuffer at top-of-memory */ > > framebuffer: framebuffer@1,ff000000 { > > reg = <0x1 0xff000000 0 0x01000000>; > > no-map; > > }; > > }; > > > > iov-reserved-memory { > > /* IOMMU supports only 32-bit output address space */ > > #address-cells = <1>; > > #size-cells = <1>; > > > > /* 16 MiB of framebuffer mapped to top of IOVA */ > > fb: fb@ff000000 { > > reg = <0 0xff000000 0 0x01000000>; > > memory-region = <&framebuffer>; > > }; > > }; > > > > display@40000000 { > > ... > > /* optional? */ > > memory-region = <&framebuffer>; > > iov-memory-regions = <&fb>; > > ... > > }; > > > > It's interesting how identity mapped regions now become a trivial > > special case of mappings. All that is needed is to make the reg property > > of the IOV reserved region correspond to the reg property of the normal > > reserved region. Alternatively, as a small optimization for lazy people > > like me, we could just allow these cases to omit the reg property and > > instead inherit it from the referenced reserved region. > > > > As the second example shows it might be convenient if memory-region > > could be derived from iov-memory-regions. This could be useful for cases > > where the driver wants to do something with the physical pages of the > > reserved region (such as mapping them and copying out the framebuffer > > data to another buffer so that the reserved memory can be recycled). If > > we have the IOV reserved region, we could provide an API to extract the > > physical reserved region (if it exists). That way we could avoid > > referencing it twice in DT. Then again, there's something elegant about > > the explicit second reference to. It indicates the intent that we may > > want to use the region for something other than just the IOV mapping. > > > > Anyway, this has been long enough. Let me know what you think. Alyssa, > > Sven, it'd be interesting to hear if you think this could work as a > > solution to the problem on M1. > > > > Rob, I think you might like this alternative because it basically gets > > rid of all the points in the original proposal that you were concerned > > about. Let me know what you think. > > Couldn't we keep this all in /reserved-memory? Just add an iova > version of reg. Perhaps abuse 'assigned-address' for this purpose. The > issue I see would be handling reserved iova areas without a physical > area. That can be handled with just a iova and no reg. We already have > a no reg case. I had thought about that initially. One thing I'm worried about is that every child node in /reserved-memory will effectively cause the memory that it described to be reserved. But we don't want that for regions that are "virtual only" (i.e. IOMMU reservations). Obviously we can fix that in Linux, but what about other operating systems? Currently "reg" is a required property for statically allocated regions (which all of these would be). Do you have an idea of how widely that's used? What about other OSes, or bootloaders, what if they encounter these nodes that don't have a "reg" property? If you don't see any concerns with that, I think we could make it work. I don't have any strong opinions about the naming for the IOVA regions. With a tiny stretch of the imagination, "assigned-addresses" even makes sense in this context. Thierry