Re: [PATCH 4/4] dt-bindings: pci: layerscape-pci: define aer/pme interrupts

[Rob Herring <robh@kernel.org>]

On Fri, Nov 19, 2021 at 06:16:21PM -0600, Li Yang wrote:
> Some platforms using this controller have separated interrupt lines for
> aer or pme events instead of having a single interrupt line for
> miscellaneous events.  Define interrupts in the binding for these
> interrupt lines.
> 
> Signed-off-by: Li Yang <leoyang.li@nxp.com>
> ---
>  .../devicetree/bindings/pci/layerscape-pci.txt     | 14 ++++++++++----
>  1 file changed, 10 insertions(+), 4 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/pci/layerscape-pci.txt b/Documentation/devicetree/bindings/pci/layerscape-pci.txt
> index 8fd6039a826b..bcf11bfc4bab 100644
> --- a/Documentation/devicetree/bindings/pci/layerscape-pci.txt
> +++ b/Documentation/devicetree/bindings/pci/layerscape-pci.txt
> @@ -31,8 +31,13 @@ Required properties:
>  - reg: base addresses and lengths of the PCIe controller register blocks.
>  - interrupts: A list of interrupt outputs of the controller. Must contain an
>    entry for each entry in the interrupt-names property.
> -- interrupt-names: Must include the following entries:
> -  "intr": The interrupt that is asserted for controller interrupts
> +- interrupt-names: It could include the following entries:
> +  "aer": For interrupt line reporting aer events when non MSI/MSI-X/INTx mode
> +		is used
> +  "pme": For interrupt line reporting pme events when non MSI/MSI-X/INTx mode
> +		is used
> +  "intr": For interrupt line reporting miscellaneous controller events
> +  ......
>  - fsl,pcie-scfg: Must include two entries.
>    The first entry must be a link to the SCFG device node
>    The second entry is the physical PCIe controller index starting from '0'.
> @@ -52,8 +57,9 @@ Example:
>  		reg = <0x00 0x03400000 0x0 0x00010000   /* controller registers */
>  		       0x40 0x00000000 0x0 0x00002000>; /* configuration space */
>  		reg-names = "regs", "config";
> -		interrupts = <GIC_SPI 177 IRQ_TYPE_LEVEL_HIGH>; /* controller interrupt */
> -		interrupt-names = "intr";
> +		interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>, /* aer interrupt */
> +			<GIC_SPI 177 IRQ_TYPE_LEVEL_HIGH>; /* pme interrupt */
> +		interrupt-names = "aer", "pme";

This isn't a compatible change. The h/w suddenly has no 'intr' 
interrupt?

>  		fsl,pcie-scfg = <&scfg 0>;
>  		#address-cells = <3>;
>  		#size-cells = <2>;
> -- 
> 2.25.1
> 
>