[PATCH 2/3] docs: hwmon: Add support for ina2xx

[Franz Forstmayr <forstmayr.franz@gmail.com>]

Add documentation for INA260, power/current monitor with I2C interface.

Signed-off-by: Franz Forstmayr <forstmayr.franz@gmail.com>
---
 Documentation/hwmon/ina2xx.rst | 19 ++++++++++++++++---
 1 file changed, 16 insertions(+), 3 deletions(-)

diff --git a/Documentation/hwmon/ina2xx.rst b/Documentation/hwmon/ina2xx.rst
index 94b9a260c518..74267dd433dd 100644
--- a/Documentation/hwmon/ina2xx.rst
+++ b/Documentation/hwmon/ina2xx.rst
@@ -53,6 +53,16 @@ Supported chips:
 
 	       http://www.ti.com/
 
+  * Texas Instruments INA260
+
+    Prefix: 'ina260'
+
+    Addresses: I2C 0x40 - 0x4f
+
+    Datasheet: Publicly available at the Texas Instruments website
+
+         http://www.ti.com/
+
 Author: Lothar Felten <lothar.felten@gmail.com>
 
 Description
@@ -72,14 +82,17 @@ INA230 and INA231 are high or low side current shunt and power monitors
 with an I2C interface. The chips monitor both a shunt voltage drop and
 bus supply voltage.
 
+INA260 is a high or low side current and power monitor with an integrated
+shunt and I2C interface.
+
 The shunt value in micro-ohms can be set via platform data or device tree at
 compile-time or via the shunt_resistor attribute in sysfs at run-time. Please
 refer to the Documentation/devicetree/bindings/hwmon/ina2xx.txt for bindings
 if the device tree is used.
 
-Additionally ina226 supports update_interval attribute as described in
-Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum of
-bus and shunt voltage conversion times multiplied by the averaging rate. We
+Additionally ina226 and ina260 supports update_interval attribute as described
+in Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum
+of bus and shunt voltage conversion times multiplied by the averaging rate. We
 don't touch the conversion times and only modify the number of averages. The
 lower limit of the update_interval is 2 ms, the upper limit is 2253 ms.
 The actual programmed interval may vary from the desired value.
-- 
2.17.1