On May 20, 2020, at 2:40 AM, Alex Zhuravlev wrote: > > > >> On 17 May 2020, at 10:55, Andreas Dilger wrote: >> >> The question is whether this is situation is affecting only a few inode >> allocations for a short time after mount, or does this persist for a long >> time? I think that it _should_ be only a short time, because these other >> threads should all start prefetch on their preferred groups, so even if a >> few inodes have their blocks allocated in the "wrong" group, it shouldn't >> be a long term problem since the prefetched bitmaps will finish loading >> and allow the blocks to be allocated, or skipped if group is fragmented. > > Yes, that’s the idea - there is a short window when buddy data is being > populated. And for each “cluster” (not just a single group) prefetching > will be initiated by allocation. > It’s possible that some number of inodes will get “bad” blocks right after > after mount. > If you think this is a bad scenario I can introduce couple more things: > 1) few times discussed prefetching thread > 2) let mballoc wait for the goal group to get ready - this essentials one > more check in ext4_mb_good_group() IMHO, this is an acceptable "cache warmup" behavior, not really different than mballoc doing limited scanning when looking for any other allocation. Since we already separate inode table blocks and data blocks into separate groups due to flex_bg, I don't think any group is "better" than another, so long as the allocations are avoiding worst-case fragmentation (i.e. a series of one-block allocations). Cheers, Andreas