Linux-Hwmon Archive on lore.kernel.org
 help / color / Atom feed
* [PATCH v6 1/2] hwmon: Add driver for Texas Instruments TMP512/513 sensor chips
@ 2019-10-29 15:04 Tremblay, Eric
  2019-11-02 15:15 ` Guenter Roeck
                   ` (2 more replies)
  0 siblings, 3 replies; 5+ messages in thread
From: Tremblay, Eric @ 2019-10-29 15:04 UTC (permalink / raw)
  To: linux-hwmon, devicetree, linux-doc
  Cc: Jean Delvare, Guenter Roeck, robh+dt, mark.rutland, Jonathan Corbet

dt-bindings: hwmon: Add TMP512/513

Add dt-binding for TMP512/513 sensor chips

Signed-off-by: Eric Tremblay <etremblay@distech-controls.com>
---
 .../devicetree/bindings/hwmon/ti,tmp513.yaml  | 88 +++++++++++++++++++
 1 file changed, 88 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/hwmon/ti,tmp513.yaml

diff --git a/Documentation/devicetree/bindings/hwmon/ti,tmp513.yaml b/Documentation/devicetree/bindings/hwmon/ti,tmp513.yaml
new file mode 100644
index 000000000000..e5f3c72ff548
--- /dev/null
+++ b/Documentation/devicetree/bindings/hwmon/ti,tmp513.yaml
@@ -0,0 +1,88 @@
+# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
+# Copyright 2018 Linaro Ltd.
+%YAML 1.2
+---
+
+$id: http://devicetree.org/schemas/hwmon/ti,tmp513.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: TMP513/512 system monitor sensor
+
+maintainers:
+  - Eric Tremblay <etremblay@distech-controls.com>
+
+description: |
+  The TMP512 (dual-channel) and TMP513 (triple-channel) are system monitors that include
+  remote sensors, a local temperature sensor, and a high-side current shunt monitor.
+  These system monitors have the capability of measuring remote temperatures,
+  on-chip temperatures, and system voltage/power/current consumption.
+
+  Datasheets:
+  http://www.ti.com/lit/gpn/tmp513
+  http://www.ti.com/lit/gpn/tmp512
+
+
+properties:
+  compatible:
+    enum:
+      - ti,tmp512
+      - ti,tmp513
+
+  reg:
+    maxItems: 1
+
+  shunt-resistor-micro-ohms:
+    description: |
+      If 0, the calibration process will be skiped and the current and power
+      measurement engine will not work. Temperature and voltage measurement
+      will continue to work.
+      The shunt value also need to respect : rshunt <= pga-gain * 40 * 1000 * 1000.
+      If not, it's not possible to compute a valid calibration value.
+    default: 1000
+
+  ti,pga-gain:
+    description: |
+      The gain value for the PGA function. This is 8, 4, 2 or 1.
+      The PGA gain affect the shunt voltage range.
+      The range will be equal to: pga-gain * 40mV
+    allOf:
+      - $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [1, 2, 4, 8]
+    default: 8
+
+  ti,bus-voltage-range-volt:
+    description: |
+      This is the operating range of the bus voltage
+    allOf:
+      - $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [16, 32]
+    default: 32
+
+  ti,nfactor:
+    description: |
+      Array of three(TMP513) or two(TMP512) n-Factor value for each remote
+      temperature channel.
+      See datasheet Table 11 for n-Factor range list and value interpretation.
+    allOf:
+      - $ref: /schemas/types.yaml#definitions/uint8-array
+      - minItems: 2
+        maxItems: 3
+        items:
+          default: 0
+
+required:
+  - compatible
+  - reg
+
+examples:
+  - |
+    i2c {
+        tmp513@5c {
+            compatible = "ti,tmp513";
+            reg = <0x5C>;
+            shunt-resistor-micro-ohms = <330000>;
+            ti,bus-voltage-range-volts = <32>;
+            ti,pga-gain = <8>;
+            ti,nfactor = [01 F3 00];
+        };
+    };
-- 
2.17.1


^ permalink raw reply	[flat|nested] 5+ messages in thread

end of thread, back to index

Thread overview: 5+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2019-10-29 15:04 [PATCH v6 1/2] hwmon: Add driver for Texas Instruments TMP512/513 sensor chips Tremblay, Eric
2019-11-02 15:15 ` Guenter Roeck
2019-11-02 15:30 ` Guenter Roeck
2019-11-04 14:28   ` Tremblay, Eric
2019-11-04 21:45 ` Rob Herring

Linux-Hwmon Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-hwmon/0 linux-hwmon/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-hwmon linux-hwmon/ https://lore.kernel.org/linux-hwmon \
		linux-hwmon@vger.kernel.org
	public-inbox-index linux-hwmon

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-hwmon


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git