messages from 2018-04-10 18:32:57 to 2018-05-25 20:18:49 UTC [more...]
[PATCH] MAINTAINERS: hwmon: Add Documentation/devicetree/bindings/hwmon
2018-05-25 20:18 UTC
[PATCH V3 0/6] hwmon: Add support for Raspberry Pi voltage sensor
2018-05-25 19:37 UTC (8+ messages)
` [PATCH V3 1/6] ARM: bcm2835: Add GET_THROTTLED firmware property
` [PATCH V3 2/6] hwmon: Add support for RPi voltage sensor
` [PATCH V3 3/6] firmware: raspberrypi: Register hwmon driver
` [PATCH V3 4/6] ARM: bcm2835_defconfig: Enable RPi voltage sensor
` [PATCH V3 5/6] ARM: multi_v7_defconfig: "
` [PATCH V3 6/6] arm64: defconfig: "
[PATCH 0/3] Add support for energy sensors
2018-05-25 11:41 UTC (11+ messages)
` [PATCH 1/3] powernv: opal-sensor: Add support to read 64bit sensor values
` [1/3] "
` [PATCH 2/3] hwmon: (ibmpowernv): Add support to read 64 bit sensors
` [2/3] "
` [PATCH 3/3] hwmon: (ibmpowernv) Add energy sensors
` [3/3] "
[PATCH RFC V2 0/6] hwmon: Add support for Raspberry Pi voltage sensor
2018-05-23 18:12 UTC (13+ messages)
` [PATCH RFC V2 1/6] ARM: bcm2835: Add GET_THROTTLED firmware property
` [PATCH RFC V2 2/6] hwmon: Add support for RPi voltage sensor
` [PATCH RFC V2 3/6] firmware: raspberrypi: Register hwmon driver
` [PATCH RFC V2 4/6] ARM: bcm2835_defconfig: Enable RPi voltage sensor
` [PATCH RFC V2 5/6] ARM: multi_v7_defconfig: "
` [PATCH RFC V2 6/6] arm64: defconfig: "
hwmon driver with misc interface
2018-05-22 1:36 UTC (2+ messages)
[v4 09/11] drivers/hwmon: Add PECI cputemp driver
2018-05-21 21:36 UTC (9+ messages)
[v4 10/11] drivers/hwmon: Add PECI dimmtemp driver
2018-05-21 20:46 UTC (3+ messages)
[v4 08/11] Documentation: hwmon: Add documents for PECI hwmon client drivers
2018-05-21 19:59 UTC
[PATCH v4 00/10] PECI device driver introduction
2018-05-21 19:56 UTC
Units for measurements and page 1 temperature for LTM4676A
2018-05-18 22:34 UTC (8+ messages)
[PATCH 0/3] Add support to disable sensor groups in P9
2018-05-18 4:03 UTC (5+ messages)
[GIT PULL] hwmon fixes for v4.17-rc6
2018-05-17 22:16 UTC
[PATCH RFC 0/6] hwmon: Add support for Raspberry Pi voltage sensor
2018-05-17 17:25 UTC (17+ messages)
` [PATCH RFC 1/6] ARM: bcm2835: Add GET_THROTTLED firmware property
` [PATCH RFC 2/6] dt-bindings: hwmon: Add Raspberry Pi voltage sensor
` [PATCH RFC 3/6] hwmon: Add support for RPi "
` [PATCH RFC 4/6] ARM: bcm2835_defconfig: Enable "
` [PATCH RFC 5/6] ARM: multi_v7_defconfig: "
` [PATCH RFC 6/6] arm64: defconfig: "
Units of measurement and page 1 temperature for LTM4676A
2018-05-16 21:45 UTC
[PATCH v3 1/2] x86/amd_nb: Add support for Raven Ridge CPUs
2018-05-13 14:32 UTC (4+ messages)
` [PATCH v3 2/2] hwmon: (k10temp) Use API function to access System Management Network
[PATCH] hwmon: (aspeed-pwm-tacho) Use 24MHz clock
2018-05-09 4:03 UTC (6+ messages)
hwmon_device_register_with_info registration API issue
2018-05-08 22:16 UTC (5+ messages)
` [PATCH] hwmon: (core) check parent dev != NULL when chip != NULL
` "
[PATCH 0/9] tree-wide: fix typo 'can by' to 'can be'
2018-05-08 4:42 UTC (3+ messages)
` [PATCH 4/9] hwmon: fschmd: "
hwmon: How should we represent Apple SMC's temperature sensors?
2018-05-06 21:56 UTC (2+ messages)
[PATCH v2 1/2] x86/amd_nb: Add support for Raven Ridge CPUs
2018-05-01 20:35 UTC (5+ messages)
` [PATCH v2 2/2] hwmon: (k10temp) Use API function to access System Management Network
[PATCH 1/2] x86/amd_nb: Add support for Raven Ridge CPUs
2018-04-30 16:01 UTC (12+ messages)
` [PATCH 2/2] hwmon: (k10temp) Use API function to access System Management Network
[PATCH V2 0/9] Implementation of Tegra Tachometer driver
2018-04-30 9:51 UTC (3+ messages)
` [PATCH V2 1/9] pwm: core: Add support for PWM HW driver with pwm capture only
[PATCH] hwmon: (k10temp) Add support for Stoney Ridge and Bristol Ridge CPUs
2018-04-29 16:30 UTC (3+ messages)
[PATCH 1/2] hwmon: (k10temp) Fix reading critical temperature register
2018-04-29 16:27 UTC (5+ messages)
` [PATCH 2/2] hwmon: (k10temp) Display both Tctl and Tdie
` [1/2] hwmon: (k10temp) Fix reading critical temperature register
[PATCH v2] hwmon: (k10temp) Fix reading critical temperature register
2018-04-29 16:12 UTC (3+ messages)
[PATCH] hwmon: (k10temp) Add support for Raven Ridge (Ryzen APU)
2018-04-27 19:34 UTC (3+ messages)
[GIT PULL] hwmon fixes for v4.17-rc3
2018-04-26 18:49 UTC
[PATCH v2] hwmon: (k10temp) Add temperature offset for Ryzen 2700X
2018-04-25 12:27 UTC
[PATCH v2] hwmon: (k10temp) Add temperature offset for Ryzen 2700X
2018-04-25 12:22 UTC
[PATCH v3 00/10] PECI device driver introduction
2018-04-24 16:29 UTC (53+ messages)
` [PATCH v3 01/10] Documentations: dt-bindings: Add documents of generic PECI bus, adapter and client drivers
` [PATCH v3 03/10] drivers/peci: Add support for PECI bus driver core
` [PATCH v3 04/10] Documentations: dt-bindings: Add a document of PECI adapter driver for Aspeed AST24xx/25xx SoCs
` [PATCH v3 05/10] ARM: dts: aspeed: peci: Add PECI node
` [PATCH v3 06/10] drivers/peci: Add a PECI adapter driver for Aspeed AST24xx/AST25xx
` [PATCH v3 07/10] Documentation: dt-bindings: Add documents for PECI hwmon client drivers
` [PATCH v3 08/10] Documentation: hwmon: "
` [PATCH v3 09/10] drivers/hwmon: Add "
` [PATCH v3 10/10] Add a maintainer for the PECI subsystem
[PATCH] hwmon: (k10temp) Add support for AMD Ryzen w/ Vega graphics
2018-04-24 15:59 UTC
[PATCH] hwmon: (nct6683) Enable EC access if disabled at boot
2018-04-23 13:14 UTC (2+ messages)
[PATCH] hwmon: (nct6683) Enable EC access if disabled at boot
2018-04-23 1:27 UTC
[PATCH] hwmon:ibm: Change ipmi_user_t to struct ipmi_user *
2018-04-18 17:18 UTC (4+ messages)
` [Openipmi-developer] "
[PATCH 1/1] hwmon: (ina2xx) initialize mutex before locking
2018-04-16 18:37 UTC (2+ messages)
[PATCH 1/1] hwmon: (ina2xx) initialize mutex before locking
2018-04-16 17:51 UTC (4+ messages)
[PATCH v3] hwmon: MC13783: add uid and die temperature sensor inputs
2018-04-16 12:06 UTC (2+ messages)
` [GIT PULL] Immutable branch between MFD and HWMON due for the v4.18 merge window
[PATCH] hwmon: (scmi) handle absence of few types of sensors
2018-04-10 20:14 UTC (2+ messages)
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).