On Tue, May 25, 2021 at 05:03:36PM +0200, Jean Delvare wrote:
> Now that the i2c-i801 driver supports interrupts, setting the KILL bit
> in a attempt to recover from a timed out transaction triggers an
> interrupt. Unfortunately, the interrupt handler (i801_isr) is not
> prepared for this situation and will try to process the interrupt as
> if it was signaling the end of a successful transaction. In the case
> of a block transaction, this can result in an out-of-range memory
> access.
> 
> This condition was reproduced several times by syzbot:
> https://syzkaller.appspot.com/bug?extid=ed71512d469895b5b34e
> https://syzkaller.appspot.com/bug?extid=8c8dedc0ba9e03f6c79e
> https://syzkaller.appspot.com/bug?extid=c8ff0b6d6c73d81b610e
> https://syzkaller.appspot.com/bug?extid=33f6c360821c399d69eb
> https://syzkaller.appspot.com/bug?extid=be15dc0b1933f04b043a
> https://syzkaller.appspot.com/bug?extid=b4d3fd1dfd53e90afd79
> 
> So disable interrupts while trying to reset the bus. Interrupts will
> be enabled again for the following transaction.
> 
> Fixes: 636752bcb517 ("i2c-i801: Enable IRQ for SMBus transactions")
> Reported-by: syzbot+b4d3fd1dfd53e90afd79@syzkaller.appspotmail.com
> Signed-off-by: Jean Delvare <jdelvare@suse.de>
> Acked-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
> Cc: Jarkko Nikula <jarkko.nikula@linux.intel.com>

Applied to for-current, thanks!