Linux-LEDs Archive on lore.kernel.org
 help / color / Atom feed
From: Lee Jones <lee.jones@linaro.org>
To: "Vaittinen, Matti" <Matti.Vaittinen@fi.rohmeurope.com>
Cc: "mazziesaccount@gmail.com" <mazziesaccount@gmail.com>,
	"dmurphy@ti.com" <dmurphy@ti.com>,
	"linux-leds@vger.kernel.org" <linux-leds@vger.kernel.org>,
	"linux-rtc@vger.kernel.org" <linux-rtc@vger.kernel.org>,
	"linux-gpio@vger.kernel.org" <linux-gpio@vger.kernel.org>,
	"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
	"alexandre.belloni@bootlin.com" <alexandre.belloni@bootlin.com>,
	"mturquette@baylibre.com" <mturquette@baylibre.com>,
	"lgirdwood@gmail.com" <lgirdwood@gmail.com>,
	"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
	"jacek.anaszewski@gmail.com" <jacek.anaszewski@gmail.com>,
	"a.zummo@towertech.it" <a.zummo@towertech.it>,
	"linus.walleij@linaro.org" <linus.walleij@linaro.org>,
	"mark.rutland@arm.com" <mark.rutland@arm.com>,
	"robh+dt@kernel.org" <robh+dt@kernel.org>,
	"bgolaszewski@baylibre.com" <bgolaszewski@baylibre.com>,
	"linux-clk@vger.kernel.org" <linux-clk@vger.kernel.org>,
	"sboyd@kernel.org" <sboyd@kernel.org>,
	"pavel@ucw.cz" <pavel@ucw.cz>,
	"broonie@kernel.org" <broonie@kernel.org>
Subject: Re: [RFC PATCH v2 02/13] dt-bindings: mfd: Document ROHM BD71828 bindings
Date: Tue, 29 Oct 2019 12:08:20 +0000
Message-ID: <20191029120820.GA4484@dell> (raw)
In-Reply-To: <5c793f1308ccc6e787260b64fe6a875a8d0eb9d0.camel@fi.rohmeurope.com>

On Fri, 25 Oct 2019, Vaittinen, Matti wrote:

> Hello Dan,
> 
> Thanks again for checking this :)
> 
> On Thu, 2019-10-24 at 14:35 -0500, Dan Murphy wrote:
> > Matti
> > 
> > On 10/24/19 6:41 AM, Matti Vaittinen wrote:
> > > ROHM BD71828 Power management IC integrates 7 buck converters, 7
> > > LDOs,
> > > a real-time clock (RTC), 3 GPO/regulator control pins, HALL input
> > > and a 32.768 kHz clock gate.
> > > 
> > > Document the dt bindings drivers are using.
> > > 
> > > Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
> > > ---
> > > 
> > > No changes since v1
> > > 
> > >   .../bindings/mfd/rohm,bd71828-pmic.txt        | 180
> > > ++++++++++++++++++
> > >   1 file changed, 180 insertions(+)
> > >   create mode 100644
> > > Documentation/devicetree/bindings/mfd/rohm,bd71828-pmic.txt
> > 
> > I will let maintainers weigh in here but if this is new this should 
> > probably be in the yaml format to avoid conversion in the future

Yes please.

> Oh... This is new to me. I guess there are reasons for this - but I
> must say I am not excited as I have never used yaml for anything. I'll
> do as you suggest and wait for what others have to say :) Thanks for
> pointing this out though.

-- 
Lee Jones [李琼斯]
Linaro Services Technical Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog

  reply index

Thread overview: 29+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-10-24 11:40 [RFC PATCH v2 00/13] Support ROHM BD71828 PMIC Matti Vaittinen
2019-10-24 11:41 ` [RFC PATCH v2 01/13] mfd: bd71828: Support ROHM BD71828 PMIC - core Matti Vaittinen
2019-10-24 11:41 ` [RFC PATCH v2 02/13] dt-bindings: mfd: Document ROHM BD71828 bindings Matti Vaittinen
2019-10-24 19:35   ` Dan Murphy
2019-10-25  5:49     ` Vaittinen, Matti
2019-10-29 12:08       ` Lee Jones [this message]
2019-10-29 19:34       ` Rob Herring
2019-10-30  8:26         ` Vaittinen, Matti
2019-10-30 19:22           ` Rob Herring
2019-10-31 12:54             ` Vaittinen, Matti
2019-10-31 17:50               ` Rob Herring
2019-11-01 12:52                 ` Vaittinen, Matti
2019-11-04 19:28                   ` Rob Herring
2019-10-24 11:42 ` [RFC PATCH v2 03/13] dt-bindings: regulator: Document ROHM BD71282 regulator bindings Matti Vaittinen
2019-10-24 11:44 ` [RFC PATCH v2 04/13] mfd: input: bd71828: Add power-key support Matti Vaittinen
2019-10-24 11:44 ` [RFC PATCH v2 05/13] clk: bd718x7: Support ROHM BD71828 clk block Matti Vaittinen
2019-10-28 23:32   ` Stephen Boyd
2019-10-29  6:28     ` Vaittinen, Matti
     [not found]       ` <20191105005541.7913220717@mail.kernel.org>
2019-11-05  8:11         ` Vaittinen, Matti
2019-10-24 11:45 ` [RFC PATCH v2 06/13] regulator: bd718x7: Split driver to common and bd718x7 specific parts Matti Vaittinen
2019-10-24 11:46 ` [RFC PATCH v2 07/13] regulator: bd71828: Basic support for ROHM bd71828 PMIC regulators Matti Vaittinen
2019-10-24 11:46 ` [RFC PATCH v2 08/13] regulator: bd71828: Add GPIO based run-level control for regulators Matti Vaittinen
2019-10-24 11:47 ` [RFC PATCH v2 09/13] regulator: bd71828: enhanced run-level support Matti Vaittinen
2019-10-24 11:47 ` [RFC PATCH v2 10/13] regulator: bd71828: Support in-kernel APIs to change run-level Matti Vaittinen
2019-10-24 11:50 ` [RFC PATCH v2 11/13] rtc: bd70528 add BD71828 support Matti Vaittinen
2019-10-24 11:50 ` [RFC PATCH v2 12/13] gpio: bd71828: Initial support for ROHM BD71828 PMIC GPIOs Matti Vaittinen
2019-10-24 11:59   ` Linus Walleij
2019-10-24 13:34     ` Vaittinen, Matti
2019-10-24 11:52 ` [RFC PATCH v2 13/13] led: bd71828: Support LED outputs on ROHM BD71828 PMIC Matti Vaittinen

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20191029120820.GA4484@dell \
    --to=lee.jones@linaro.org \
    --cc=Matti.Vaittinen@fi.rohmeurope.com \
    --cc=a.zummo@towertech.it \
    --cc=alexandre.belloni@bootlin.com \
    --cc=bgolaszewski@baylibre.com \
    --cc=broonie@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=dmurphy@ti.com \
    --cc=jacek.anaszewski@gmail.com \
    --cc=lgirdwood@gmail.com \
    --cc=linus.walleij@linaro.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-gpio@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-leds@vger.kernel.org \
    --cc=linux-rtc@vger.kernel.org \
    --cc=mark.rutland@arm.com \
    --cc=mazziesaccount@gmail.com \
    --cc=mturquette@baylibre.com \
    --cc=pavel@ucw.cz \
    --cc=robh+dt@kernel.org \
    --cc=sboyd@kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-LEDs Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-leds/0 linux-leds/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-leds linux-leds/ https://lore.kernel.org/linux-leds \
		linux-leds@vger.kernel.org
	public-inbox-index linux-leds

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-leds


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git