Re: [PATCH v3 05/14] media: dt-bindings: marvell,mmp2-ccic: Add Marvell MMP2 camera

[Sakari Ailus <sakari.ailus@iki.fi>]

Hi Lubomir,

On Tue, Nov 20, 2018 at 11:03:10AM +0100, Lubomir Rintel wrote:
> Add Marvell MMP2 camera host interface.
> 
> Signed-off-by: Lubomir Rintel <lkundrak@v3.sk>
> 
> ---
> Changes since v2:
> - Added #clock-cells, clock-names, port
> 
>  .../bindings/media/marvell,mmp2-ccic.txt      | 37 +++++++++++++++++++
>  1 file changed, 37 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/media/marvell,mmp2-ccic.txt
> 
> diff --git a/Documentation/devicetree/bindings/media/marvell,mmp2-ccic.txt b/Documentation/devicetree/bindings/media/marvell,mmp2-ccic.txt
> new file mode 100644
> index 000000000000..e5e8ca90e7f7
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/marvell,mmp2-ccic.txt
> @@ -0,0 +1,37 @@
> +Marvell MMP2 camera host interface
> +
> +Required properties:
> + - compatible: Should be "marvell,mmp2-ccic"
> + - reg: register base and size
> + - interrupts: the interrupt number
> + - #clock-cells: must be 0
> + - any required generic properties defined in video-interfaces.txt

Could you document what is relevant for the hardware? There are quite a few
properties documented there...

> +
> +Optional properties:
> + - clocks: input clock (see clock-bindings.txt)
> + - clock-names: names of the clocks used, may include "axi", "func" and
> +                "phy"
> + - clock-output-names: should contain the name of the clock driving the
> +                       sensor master clock MCLK
> +
> +Required subnodes:
> + - port: the parallel bus interface port with a single endpoint linked to
> +         the sensor's endpoint as described in video-interfaces.txt

Please use the full path to video-interfaces.txt. Same above, as well as
for clock-bindings.txt.

Are there endpoint properties that are applicable for the hardware?

> +
> +Example:
> +
> +	camera0: camera@d420a000 {
> +		compatible = "marvell,mmp2-ccic";
> +		reg = <0xd420a000 0x800>;
> +		interrupts = <42>;
> +		clocks = <&soc_clocks MMP2_CLK_CCIC0>;
> +		clock-names = "axi";
> +		#clock-cells = <0>;
> +		clock-output-names = "mclk";
> +
> +		port {
> +			camera0_0: endpoint {
> +				remote-endpoint = <&ov7670_0>;
> +			};
> +		};
> +	};

-- 
Kind regards,

Sakari Ailus
e-mail: sakari.ailus@iki.fi