On Mon, Jan 28, 2019 at 02:28:44PM +0530, Jagan Teki wrote:
> CSI block in Allwinner A64 has similar features as like in H3,
> but the default CSI_SCLK rate cannot work properly to drive the
> connected sensor interface.
> 
> The tested mod cock rate is 300 MHz and BSP vfe media driver is also
> using the same rate. Unfortunately there is no valid information about
> clock rate in manual or any other sources except the BSP driver. so more
> faith on BSP code, because same has tested in mainline.
> 
> So, add support for A64 CSI block by setting updated mod clock rate.
> 
> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>

Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>

Maxime

-- 
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com