Linux-Media Archive on lore.kernel.org
 help / color / Atom feed
From: Jacopo Mondi <jacopo+renesas@jmondi.org>
To: mchehab@kernel.org, hverkuil-cisco@xs4all.nl,
	sakari.ailus@linux.intel.com, laurent.pinchart@ideasonboard.com
Cc: Jacopo Mondi <jacopo+renesas@jmondi.org>,
	niklas.soderlund+renesas@ragnatech.se,
	kieran.bingham@ideasonboard.com, dave.stevenson@raspberrypi.com,
	hyun.kwon@xilinx.com, jmkrzyszt@gmail.com,
	robert.jarzmik@free.fr, linux-media@vger.kernel.org,
	linux-renesas-soc@vger.kernel.org
Subject: [PATCH v8 03/10] media: i2c: ov6650: Use new [get|set]_mbus_config ops
Date: Fri, 17 Jul 2020 16:53:17 +0200
Message-ID: <20200717145324.292820-4-jacopo+renesas@jmondi.org> (raw)
In-Reply-To: <20200717145324.292820-1-jacopo+renesas@jmondi.org>

Use the new get_mbus_config and set_mbus_config pad operations in place
of the video operations currently in use.

Compared to other drivers where the same conversion has been performed,
ov6650 proved to be a bit more tricky, as the existing g_mbus_config
implementation did not report the currently applied configuration but
the set of all possible configuration options.

Adapt the driver to support the semantic of the two newly introduced
operations:
- get_mbus_config reports the current media bus configuration
- set_mbus_config applies only changes explicitly requested and updates
  the provided cfg parameter to report what has actually been applied to
  the hardware.

Compile-tested only.

Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
---
 drivers/media/i2c/ov6650.c | 56 ++++++++++++++++++++++++++------------
 1 file changed, 38 insertions(+), 18 deletions(-)

diff --git a/drivers/media/i2c/ov6650.c b/drivers/media/i2c/ov6650.c
index 91906b94f978..b349a9d5986a 100644
--- a/drivers/media/i2c/ov6650.c
+++ b/drivers/media/i2c/ov6650.c
@@ -921,55 +921,73 @@ static const struct v4l2_subdev_core_ops ov6650_core_ops = {
 };
 
 /* Request bus settings on camera side */
-static int ov6650_g_mbus_config(struct v4l2_subdev *sd,
-				struct v4l2_mbus_config *cfg)
+static int ov6650_get_mbus_config(struct v4l2_subdev *sd,
+				  unsigned int pad,
+				  struct v4l2_mbus_config *cfg)
 {
+	struct i2c_client *client = v4l2_get_subdevdata(sd);
+	u8 comj, comf;
+	int ret;
+
+	ret = ov6650_reg_read(client, REG_COMJ, &comj);
+	if (ret)
+		return ret;
 
-	cfg->flags = V4L2_MBUS_MASTER |
-		V4L2_MBUS_PCLK_SAMPLE_RISING | V4L2_MBUS_PCLK_SAMPLE_FALLING |
-		V4L2_MBUS_HSYNC_ACTIVE_HIGH | V4L2_MBUS_HSYNC_ACTIVE_LOW |
-		V4L2_MBUS_VSYNC_ACTIVE_HIGH | V4L2_MBUS_VSYNC_ACTIVE_LOW |
-		V4L2_MBUS_DATA_ACTIVE_HIGH;
+	ret = ov6650_reg_read(client, REG_COMF, &comf);
+	if (ret)
+		return ret;
+
+	cfg->flags = V4L2_MBUS_MASTER | V4L2_MBUS_DATA_ACTIVE_HIGH
+		   | ((comj & COMJ_VSYNC_HIGH)  ? V4L2_MBUS_VSYNC_ACTIVE_HIGH
+						: V4L2_MBUS_VSYNC_ACTIVE_LOW)
+		   | ((comf & COMF_HREF_LOW)    ? V4L2_MBUS_HSYNC_ACTIVE_LOW
+						: V4L2_MBUS_HSYNC_ACTIVE_HIGH)
+		   | ((comj & COMJ_PCLK_RISING) ? V4L2_MBUS_PCLK_SAMPLE_RISING
+						: V4L2_MBUS_PCLK_SAMPLE_FALLING);
 	cfg->type = V4L2_MBUS_PARALLEL;
 
 	return 0;
 }
 
 /* Alter bus settings on camera side */
-static int ov6650_s_mbus_config(struct v4l2_subdev *sd,
-				const struct v4l2_mbus_config *cfg)
+static int ov6650_set_mbus_config(struct v4l2_subdev *sd,
+				  unsigned int pad,
+				  struct v4l2_mbus_config *cfg)
 {
 	struct i2c_client *client = v4l2_get_subdevdata(sd);
-	int ret;
+	int ret = 0;
 
 	if (cfg->flags & V4L2_MBUS_PCLK_SAMPLE_RISING)
 		ret = ov6650_reg_rmw(client, REG_COMJ, COMJ_PCLK_RISING, 0);
-	else
+	else if (cfg->flags & V4L2_MBUS_PCLK_SAMPLE_FALLING)
 		ret = ov6650_reg_rmw(client, REG_COMJ, 0, COMJ_PCLK_RISING);
 	if (ret)
-		return ret;
+		goto error;
 
 	if (cfg->flags & V4L2_MBUS_HSYNC_ACTIVE_LOW)
 		ret = ov6650_reg_rmw(client, REG_COMF, COMF_HREF_LOW, 0);
-	else
+	else if (cfg->flags & V4L2_MBUS_HSYNC_ACTIVE_HIGH)
 		ret = ov6650_reg_rmw(client, REG_COMF, 0, COMF_HREF_LOW);
 	if (ret)
-		return ret;
+		goto error;
 
 	if (cfg->flags & V4L2_MBUS_VSYNC_ACTIVE_HIGH)
 		ret = ov6650_reg_rmw(client, REG_COMJ, COMJ_VSYNC_HIGH, 0);
-	else
+	else if (cfg->flags & V4L2_MBUS_VSYNC_ACTIVE_LOW)
 		ret = ov6650_reg_rmw(client, REG_COMJ, 0, COMJ_VSYNC_HIGH);
 
-	return ret;
+error:
+	/*
+	 * Update the configuration to report what is actually applied to
+	 * the hardware.
+	 */
+	return ov6650_get_mbus_config(sd, pad, cfg);
 }
 
 static const struct v4l2_subdev_video_ops ov6650_video_ops = {
 	.s_stream	= ov6650_s_stream,
 	.g_frame_interval = ov6650_g_frame_interval,
 	.s_frame_interval = ov6650_s_frame_interval,
-	.g_mbus_config	= ov6650_g_mbus_config,
-	.s_mbus_config	= ov6650_s_mbus_config,
 };
 
 static const struct v4l2_subdev_pad_ops ov6650_pad_ops = {
@@ -978,6 +996,8 @@ static const struct v4l2_subdev_pad_ops ov6650_pad_ops = {
 	.set_selection	= ov6650_set_selection,
 	.get_fmt	= ov6650_get_fmt,
 	.set_fmt	= ov6650_set_fmt,
+	.get_mbus_config = ov6650_get_mbus_config,
+	.set_mbus_config = ov6650_set_mbus_config,
 };
 
 static const struct v4l2_subdev_ops ov6650_subdev_ops = {
-- 
2.27.0


  parent reply index

Thread overview: 15+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-07-17 14:53 [PATCH v8 00/10] v4l2-subdev: Introduce [g|s]et_mbus_format pad op Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 01/10] media: v4l2-subdev: Introduce [get|set]_mbus_config pad ops Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 02/10] media: i2c: Use the new get_mbus_config pad op Jacopo Mondi
2020-07-17 14:53 ` Jacopo Mondi [this message]
2020-07-21  7:53   ` [PATCH v8.1 03/10] media: i2c: ov6650: Use new [get|set]_mbus_config ops Jacopo Mondi
2020-07-21 15:50     ` Janusz Krzysztofik
2020-07-17 14:53 ` [PATCH v8 04/10] media: pxa_camera: Use the new set_mbus_config op Jacopo Mondi
2020-07-20  8:55   ` Hans Verkuil
2020-07-17 14:53 ` [PATCH v8 05/10] media: v4l2-subdev: Remove [s|g]_mbus_config video ops Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 06/10] media: v4l2- mediabus: Add usage note for V4L2_MBUS_* Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 07/10] staging: media: imx: Update TODO entry Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 08/10] media: i2c: adv748x: Adjust TXA data lanes number Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 09/10] media: i2c: adv748x: Implement get_mbus_config Jacopo Mondi
2020-07-17 14:53 ` [PATCH v8 10/10] media: rcar-csi2: Negotiate data lanes number Jacopo Mondi
2020-07-17 14:59 ` [PATCH v8 00/10] v4l2-subdev: Introduce [g|s]et_mbus_format pad op Hans Verkuil

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200717145324.292820-4-jacopo+renesas@jmondi.org \
    --to=jacopo+renesas@jmondi.org \
    --cc=dave.stevenson@raspberrypi.com \
    --cc=hverkuil-cisco@xs4all.nl \
    --cc=hyun.kwon@xilinx.com \
    --cc=jmkrzyszt@gmail.com \
    --cc=kieran.bingham@ideasonboard.com \
    --cc=laurent.pinchart@ideasonboard.com \
    --cc=linux-media@vger.kernel.org \
    --cc=linux-renesas-soc@vger.kernel.org \
    --cc=mchehab@kernel.org \
    --cc=niklas.soderlund+renesas@ragnatech.se \
    --cc=robert.jarzmik@free.fr \
    --cc=sakari.ailus@linux.intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-Media Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-media/0 linux-media/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-media linux-media/ https://lore.kernel.org/linux-media \
		linux-media@vger.kernel.org
	public-inbox-index linux-media

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-media


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git