Re: [PATCH v3 7/7] [not for merge] netstats: example use of stats_fs API

[Andrew Lunn <andrew@lunn.ch>]

On Tue, May 26, 2020 at 01:03:17PM +0200, Emanuele Giuseppe Esposito wrote:
> Apply stats_fs on the networking statistics subsystem.
> 
> Currently it only works with disabled network namespace
> (CONFIG_NET_NS=n), because multiple namespaces will have the same
> device name under the same root source that will cause a conflict in
> stats_fs.

Hi Emanuele

How do you atomically get and display a group of statistics?

If you look at how the netlink socket works, you will see code like:

                do {
                        start = u64_stats_fetch_begin_irq(&cpu_stats->syncp);
                        rx_packets = cpu_stats->rx_packets;
                        rx_bytes = cpu_stats->rx_bytes;
			....
                } while (u64_stats_fetch_retry_irq(&cpu_stats->syncp, start));

It will ensure that rx_packets and rx_bytes are consistent with each
other. If the value of the sequence counter changes while inside the
loop, the loop so repeated until it does not change.

In general, hardware counters in NICs are the same.  You tell it to
take a snapshot of the statistics counters, and then read them all
back, to give a consistent view across all the statistics.

I've not looked at this new code in detail, but it looks like you have
one file per statistic, and assume each statistic is independent of
every other statistic. This independence can limit how you use the
values, particularly when debugging. The netlink interface we use does
not have this limitation.

	     Andrew