messages from 2019-06-24 22:58:30 to 2019-07-01 20:41:58 UTC [more...]
Call trace stops at static callback functions
2019-07-01 20:41 UTC (15+ messages)
` SGI-IP30
[RFC PATCH 10/10] hw/pci-host/gt64120: Clean the decoded address space
2019-07-01 18:06 UTC
generic gup fixups
2019-07-01 17:43 UTC (5+ messages)
` [PATCH 1/2] sh: stub out pud_page
` [PATCH 2/2] MIPS: don't select ARCH_HAS_PTE_SPECIAL
[PATCH net-next 0/8] net: mscc: PTP Hardware Clock (PHC) support
2019-07-01 15:54 UTC (13+ messages)
` [PATCH net-next 1/8] Documentation/bindings: net: ocelot: document the PTP bank
` [PATCH net-next 2/8] MIPS: dts: mscc: describe the PTP register range
` [PATCH net-next 3/8] Documentation/bindings: net: ocelot: document the PTP ready IRQ
` [PATCH net-next 4/8] MIPS: dts: mscc: describe the PTP ready interrupt
` [PATCH net-next 5/8] net: mscc: describe the PTP register range
` [PATCH net-next 6/8] net: mscc: improve the frame header parsing readability
` [PATCH net-next 7/8] net: mscc: remove the frame_info cpuq member
` [PATCH net-next 8/8] net: mscc: PTP Hardware Clock (PHC) support
remove asm-generic/ptrace.h v3
2019-07-01 15:40 UTC (3+ messages)
[PATCH v14 00/13] Ingenic TCU patchset v14
2019-07-01 15:14 UTC (14+ messages)
` [PATCH v14 01/13] dt-bindings: ingenic: Add DT bindings for TCU clocks
` [PATCH v14 02/13] doc: Add doc for the Ingenic TCU hardware
` [PATCH v14 03/13] dt-bindings: Add doc for the Ingenic TCU drivers
` [PATCH v14 04/13] mfd: Add Ingenic TCU driver
` [PATCH v14 05/13] clk: ingenic: Add driver for the TCU clocks
` [PATCH v14 06/13] irqchip: Add irq-ingenic-tcu driver
` [PATCH v14 07/13] clocksource: Add a new timer-ingenic driver
` [PATCH v14 08/13] clk: jz4740: Add TCU clock
` [PATCH v14 09/13] MIPS: jz4740: Add DTS nodes for the TCU drivers
` [PATCH v14 10/13] MIPS: qi_lb60: Reduce system timer and clocksource to 750 kHz
` [PATCH v14 11/13] MIPS: CI20: Reduce system timer and clocksource to 3 MHz
` [PATCH v14 12/13] MIPS: GCW0: Reduce system timer and clocksource to 750 kHz
` [PATCH v14 13/13] MIPS: jz4740: Drop obsolete code
[PATCH] net: ethernet: mediatek: Fix overlapping capability bits
2019-07-01 12:57 UTC (4+ messages)
[PATCH] net: ethernet: mediatek: Allow non TRGMII mode with MT7621 DDR2 devices
2019-07-01 12:57 UTC (2+ messages)
[PATCH v3 0/7] Use MFD framework for SGI IOC3 drivers
2019-07-01 8:19 UTC (5+ messages)
` [PATCH v3 7/7] Input: add IOC3 serio driver
` [PATCH v3 5/7] mfd: ioc3: Add driver for SGI IOC3 chip
[PATCH v5 0/2] clocksource/drivers: Create new Hyper-V clocksource driver
2019-07-01 4:26 UTC (3+ messages)
` [PATCH v5 1/2] clocksource/drivers: Make Hyper-V clocksource ISA agnostic
` [PATCH v5 2/2] clocksource/drivers: Continue making "
[PATCH] MIPS: only select ARCH_HAS_UNCACHED_SEGMENT for non-coherent platforms
2019-06-30 17:57 UTC (2+ messages)
[PATCH v4 00/14] Provide generic top-down mmap layout functions
2019-06-30 15:34 UTC (3+ messages)
MIPS: ath79: regression after patch: sched/fair: do not expose some tracepoints to user if CONFIG_SCHEDSTATS is not set
2019-06-30 5:01 UTC (7+ messages)
[PATCH] mm: Generalize and rename notify_page_fault() as kprobe_page_fault()
2019-06-30 4:41 UTC (3+ messages)
[PATCH V2] include: linux: Regularise the use of FIELD_SIZEOF macro
2019-06-29 16:45 UTC (5+ messages)
switch the remaining architectures to use generic GUP v4
2019-06-29 15:15 UTC (21+ messages)
` [PATCH 01/16] mm: use untagged_addr() for get_user_pages_fast addresses
` [PATCH 02/16] mm: simplify gup_fast_permitted
` [PATCH 03/16] mm: lift the x86_32 PAE version of gup_get_pte to common code
` [PATCH 04/16] MIPS: use the generic get_user_pages_fast code
` [PATCH 05/16] sh: add the missing pud_page definition
` [PATCH 06/16] sh: use the generic get_user_pages_fast code
` [PATCH 07/16] sparc64: add the missing pgd_page definition
` [PATCH 08/16] sparc64: define untagged_addr()
` [PATCH 09/16] sparc64: use the generic get_user_pages_fast code
` [PATCH 10/16] mm: rename CONFIG_HAVE_GENERIC_GUP to CONFIG_HAVE_FAST_GUP
` [PATCH 11/16] mm: reorder code blocks in gup.c
` [PATCH 12/16] mm: consolidate the get_user_pages* implementations
` [PATCH 13/16] mm: validate get_user_pages_fast flags
` [PATCH 14/16] mm: move the powerpc hugepd code to mm/gup.c
` [PATCH 15/16] mm: switch gup_hugepte to use try_get_compound_head
` [PATCH 16/16] mm: mark the page referenced in gup_hugepte
[PATCH 1/8 v2] MIPS: ralink: mt7628a.dtsi: Add SPDX GPL-2.0 license identifier
2019-06-29 9:07 UTC (10+ messages)
` [PATCH 5/8 v2] MIPS: ralink: mt7628a.dtsi: Add I2C controller DT node
` [PATCH 8/8 v2] MIPS: ralink: Add GARDENA smart Gateway MT7688 board
[PATCH v7 00/25] Unify vDSOs across more architectures
2019-06-29 6:58 UTC (23+ messages)
` [PATCH v7 04/25] arm64: Substitute gettimeofday with C implementation
` [PATCH] arm64: vdso: Fix compilation with clang < 8
` [PATCH v2] arm64: vdso: Fix compilation with clang older then 8
[PATCH v6 00/19] Unify vDSOs across more architectures
2019-06-28 18:40 UTC (11+ messages)
` [PATCH v6 18/19] x86: Add support for generic vDSO
[PATCH v4 0/2] Drivers: hv: Move Hyper-V clock/timer code to separate clocksource driver
2019-06-28 18:34 UTC (3+ messages)
` [PATCH v4 1/2] Drivers: hv: Create Hyper-V clocksource driver from existing clockevents code
` [PATCH v4 2/2] Drivers: hv: Move Hyper-V clocksource code to new clocksource driver
[PATCH RFC net-next 0/5] net: dsa: MT7530: Convert to PHYLINK and add support for port 5
2019-06-28 7:16 UTC (35+ messages)
` [PATCH RFC net-next 1/5] net: dsa: mt7530: Convert to PHYLINK API
` [PATCH RFC net-next 4/5] dt-bindings: net: dsa: mt7530: Add mediatek,ephy-handle to isolate ext. phy
` [PATCH RFC net-next 5/5] net: dsa: mt7530: Add mediatek,ephy-handle to isolate external phy
[PATCH 0/3] MIPS: BMIPS: add support for gated clock controller
2019-06-27 20:43 UTC (5+ messages)
` [PATCH 1/3] devicetree: document the BCM63XX gated clock bindings
` [PATCH 2/3] clk: add BCM63XX gated clock controller driver
[PATCH v3 1/2] pid: add pidfd_open()
2019-06-27 13:57 UTC (2+ messages)
Ingenic Timer/Counter Unit (TCU) patchset v12
2019-06-27 9:19 UTC (8+ messages)
` [PATCH v12 04/13] mfd: Add Ingenic TCU driver
[PATCH v7 04/25] arm64: Substitute gettimeofday with C implementation
2019-06-26 11:08 UTC (12+ messages)
` [PATCH 1/3] lib/vdso: Delay mask application in do_hres()
` [PATCH 2/3] arm64: Fix __arch_get_hw_counter() implementation
` [PATCH 3/3] arm64: compat: "
` lib/vdso: Make delta calculation work correctly
[PATCH] au1200fb: don't use DMA_ATTR_NON_CONSISTENT
2019-06-26 7:16 UTC (2+ messages)
[PATCH v13 00/13] Ingenic Timer/Counter Unit patchset v13
2019-06-25 23:28 UTC (21+ messages)
` [PATCH v13 01/13] dt-bindings: ingenic: Add DT bindings for TCU clocks
` [PATCH v13 02/13] doc: Add doc for the Ingenic TCU hardware
` [PATCH v13 04/13] mfd: Add Ingenic TCU driver
` [PATCH v13 05/13] clk: ingenic: Add driver for the TCU clocks
` [PATCH v13 06/13] irqchip: Add irq-ingenic-tcu driver
` [PATCH v13 07/13] clocksource: Add a new timer-ingenic driver
` [PATCH v13 08/13] clk: jz4740: Add TCU clock
` [PATCH v13 09/13] MIPS: jz4740: Add DTS nodes for the TCU drivers
` [PATCH v13 10/13] MIPS: qi_lb60: Reduce system timer and clocksource to 750 kHz
` [PATCH v13 11/13] MIPS: CI20: Reduce system timer and clocksource to 3 MHz
` [PATCH v13 12/13] MIPS: GCW0: Reduce system timer and clocksource to 750 kHz
` [PATCH v13 13/13] MIPS: jz4740: Drop obsolete code
[PATCH v2 1/5] clk: ingenic: Add missing header in cgu.h
2019-06-25 22:48 UTC (12+ messages)
` [PATCH v2 2/5] clk: ingenic: Handle setting the Low-Power Mode bit
` [PATCH v2 3/5] MIPS: jz4740: PM: Let CGU driver suspend clocks and set sleep mode
` [PATCH v2 4/5] clk: ingenic: Remove unused functions
` [PATCH v2 5/5] MIPS: Remove dead code
DMA API usage in au1000_eth.c
2019-06-25 12:34 UTC
fix DMA API abuse in various mips fbdev drivers
2019-06-25 12:09 UTC (5+ messages)
` [PATCH 3/3] jz4740_fb: fix DMA API abuse
switch the remaining architectures to use generic GUP v3
2019-06-25 11:56 UTC (15+ messages)
` [PATCH 01/16] mm: use untagged_addr() for get_user_pages_fast addresses
` [PATCH 04/16] MIPS: use the generic get_user_pages_fast code
` [PATCH 10/16] mm: rename CONFIG_HAVE_GENERIC_GUP to CONFIG_HAVE_FAST_GUP
` [PATCH 11/16] mm: consolidate the get_user_pages* implementations
switch nios2 and microblaze to use the generic uncached segement support
2019-06-25 5:52 UTC (4+ messages)
` [PATCH 1/2] nios2: use the generic uncached segment support in dma-direct
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).