Re: [PATCH 1/2] mmc: tmio: Further fixup runtime PM management at remove

[Geert Uytterhoeven <geert@linux-m68k.org>]

Hi Wolfram,

On Wed, May 20, 2020 at 8:19 PM Geert Uytterhoeven <geert@linux-m68k.org> wrote:
> On Wed, May 20, 2020 at 5:49 PM Wolfram Sang
> <wsa+renesas@sang-engineering.com> wrote:
> > On Wed, May 20, 2020 at 04:30:33PM +0200, Geert Uytterhoeven wrote:
> > > On Tue, May 19, 2020 at 5:24 PM Ulf Hansson <ulf.hansson@linaro.org> wrote:
> > > > Before calling tmio_mmc_host_probe(), the caller is required to enable
> > > > clocks for its device, as to make it accessible when reading/writing
> > > > registers during probe.
> > > >
> > > > Therefore, the responsibility to disable these clocks, in the error path of
> > > > ->probe() and during ->remove(), is better managed outside
> > > > tmio_mmc_host_remove(). As a matter of fact, callers of
> > > > tmio_mmc_host_remove() already expects this to be the behaviour.
> > > >
> > > > However, there's a problem with tmio_mmc_host_remove() when the Kconfig
> > > > option, CONFIG_PM, is set. More precisely, tmio_mmc_host_remove() may then
> > > > disable the clock via runtime PM, which leads to clock enable/disable
> > > > imbalance problems, when the caller of tmio_mmc_host_remove() also tries to
> > > > disable the same clocks.
> > > >
> > > > To solve the problem, let's make sure tmio_mmc_host_remove() leaves the
> > > > device with clocks enabled, but also make sure to disable the IRQs, as we
> > > > normally do at ->runtime_suspend().
> > > >
> > > > Reported-by: Geert Uytterhoeven <geert+renesas@glider.be>
> > > > Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
> > > > Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
> > > > Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
> > >
> > > Tested-by: Geert Uytterhoeven <geert+renesas@glider.be>
> > >
> > > (on R-Car Gen2, various Gen3, SH-Mobile AG5, R-Mobile A1, R-Mobile APE6,
> > >  RZ/A1, and RZ/A2)
> >
> > Thanks, Geert! If it is not too much to ask, could you try re-applying
> > commit 7a7dab237027 ("mmc: tmio: remove workaround for NON_REMOVABLE")
> > on top of all these patches and see if your NFS is still stalled?
> >
> > Sidenote: we still need to tackle the problem when SCC hangs because it
> > has no clock. However, I am still interested if all the PM updates have
> > an impact in the beaviour you observed here[1].
> >
> > [1] https://patchwork.kernel.org/patch/11149285/
>
> I reverted "[PATCH] WIP: clk: renesas: rcar-gen3: enable SDnH clk for HS
> modes" (which I still had applied in my local tree), and reapplied "mmc:
> tmio: remove workaround for NON_REMOVABLE", but I cannot reproduce the
> issue, with or without the top 3 commits on mmc/next:
> ff5a1a63febb0761 mmc: tmio: Further fixup runtime PM management at remove
> 774c44ceff3c5b3f mmc: tmio: Make sure the PM domain is 'started' while probing
> 4863bb62a87786ec mmc: renesas_sdhi: remove manual clk handling
>
> Let's see if I can bisect where it was fixed...

Commit 9b0d6855e756b60d ("mmc: renesas_sdhi: enforce manual correction
for Gen3") fixed it.  However, there must be other later changes that
have impact, as reverting 9b0d6855e756b60d and reapplying 7a7dab237027
on both mmc/next~3 and mmc/next gives a working system.

Let's call it a day, no more bisecting today...

Gr{oetje,eeting}s,

                        Geert

-- 
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds